Question about Seat Cars & Trucks

Open Question

Wireing cadilac power seat and not deploy airbag.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MrScary66613
  • 1990 Answers

SOURCE: seat belts on both driver and pass. won't extract

Unfortunately, Yes, You will need new Seat Belts also. Once the Seat Belts and the AirBags are Deployed in a Crash, There is no Reset for the Belts. Please Rate My Response! Thanks!

Posted on Feb 01, 2009

  • 323 Answers

SOURCE: driver's airbag light on 2007 PT Cruiser convertable

The first code is for "driver seat track position sensor low". The module detects that the sensor input is less than or equal to 0.3 mA. The second code is referring to the first code. I have no idea what the third code is. Basically you have two different communication systems mixed. The 2001 uses the PCI bus system and the 2007 uses the CAN bus which is much faster. The first code is a CAN bus code and the second is a PCI code. As far as the airbag deploying in the event of a collision, I don't believe it will with an active code in the system. I hope this helps.

Posted on May 13, 2009

  • 297 Answers

SOURCE: Replace seats in 2003 Montana with seats from 2000 Montana

I would disconnect the battery minus - cable first, ensure the airbag connectors are the same ! otherwise I do not think you have a problem !!

Posted on Aug 11, 2009

alicantecoli
  • 22156 Answers

SOURCE: I kerbed my vw polo 1.4tdi 2004

airbag light can only be sorted by the dealer,with a certificate for the vehicle mechanical inspection.as for teh power steering then providing the pump is working ok then you will need to change the complete rack and pinion ,jack vehicle up then top up the fluid and turn the steering lock to lock to bleed system ,if that doesnt work then change the reck and pinion as the impact has most likely damaged the spool valve.

Posted on Nov 11, 2009

  • 819 Answers

SOURCE: how do you reset the seat belt tensioner after

it must be replaced. it is a one shot deal.

Posted on Jan 22, 2010

Testimonial: "Thanks so much. Is it me, or does this seem stupid? Ok, the airbags are shot, but in the interest of at least SOME safety, why the belts too?"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Airbag wires under seat


Get a auto sparky to hook it up . if you make a wrong connection and deploy the air bag it will cause a lot of damage and empty your money box.

Mar 11, 2014 | Ford Escape Cars & Trucks

2 Answers

Airbag light reset sx4


There is a manufacturer's recall on this if it's caused by a failure in the front passenger weight detection system.

The system has a minimum weight required in the front passenger seat for the airbag to deploy in an accident (if no one is in the front passenger seat during an accident, the airbag does NOT deploy). If the system fails and the car cannot determine if someone is in the front passenger seat, the light illuminates and in an accident the passenger airbag WILL deploy, even if there's no one in that seat.

The purpose of the system is to prevent airbag deployment for a lightweight child in the front seat. The fix is to replace the seat weight sensor mat...free if it's the recall item.

Mar 05, 2013 | 2008 Suzuki SX4

1 Answer

Air bag code 33 for a 2005 lincoln town car


2005 Towncar SRS Code 33 (3 flash + 3 flash, repeat this set for twice. then Beep 5 times pause x 5 = 25 beeps every 30min).

This means you have problem with left (Driver) side pretentioner (Seat belt retract system).
It doesn't mean physical belt or retract mechanism.It is just bomb wiring which is part of airbag system.
When airbag deploy, passenger must stay tight in seat otherwise body lean to front then slam back to seat by airbag.
if belt is loose or delay to lock, passenger's body rocks back and forth.So, system use small bomb (Fire power) to lock and retract seat belt when airbag deploy.There is small bomb and igniter in part of Seat belt retractor.
Code 33 is warning for this part on 2005 Towncar.(older model is different meaning in Ford/Lincoln, it's possibly passenger side airbag system for earlier model)
Before you work for any part of Airbag system and touch any "Yellow connector", * *Disconnect battery (negative side is good enough) and wait at least 5 min to clear all power in system**.(Airbag store back up power for few minutes to be able to deploy even in case if power disconnected)
by the way, you should move your driver seat most forwarded position before you disconnect battery to make it easy to work with seat belt.
locate driver side seat belt retractor (in center pillar between front and rear door, you may have to fight with weather strip)

Locate Yellow connector on bottom of Seat belt retractor (it's called "Pretensioner")it is located on very bottom of rear side of retractor.
only one yellow connector. (make sure your battery is disconnected)
Check its physical connection or looseness.if connection looks fine, you may have to replace whole seat belt ($180-$200 in Lincoln dealer)
You can check if pretensionor is good or bad by regular tester, but unless you know how, I won't tell (because I don't wan't you to blow out pretentionor).








Jul 19, 2012 | 2005 Lincoln Town Car

1 Answer

My airbag light is on but my airbag is not deployed, what could be the problem? thanks......


Hi
Try under drivers/pass seat the wire cuppling is attached to the under seat of one of them and can prise loose with adjusting seat.
tc

Oct 02, 2010 | 2004 Honda Civic

1 Answer

I have a 2001 ford escape that was in a fender bender. minor visual damage but both airbags deployed. I bought new steering wheel and passanger airbag and hooked up. I was told i now need new sensors which...


this may sound crazy but this is what they say (manufactor) when ever airbags are deployed ,the following must be replaced,the deployed bags. the airbag module,crash sensors,clock spring, the belt buckles and seat belts should be inspected and checked.

Mar 08, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

My 2004 XG 350 had its driver's side airbag deployed while I was seated in the parking lot. There was no impact, no accident, car was not in motion at all. The dealer says I have to drop it off to find out...


Thay will make you pay for the seat and airbag and a new airbag module you can save money by buying the used seat with airbag at a junk yard and sand out your airbag unit for repair abt $50 more info on all airbag how to go to http://www.vehix411.com

Mar 04, 2010 | 2004 Hyundai XG350

1 Answer

Replace seats in 2003 Montana with seats from 2000 Montana


I would disconnect the battery minus - cable first, ensure the airbag connectors are the same ! otherwise I do not think you have a problem !!

Aug 11, 2009 | 2003 Pontiac Montana

2 Answers

2008 MKz - Remove Objects Near Pass Seat


Do you have anything under the drivers seat? Fords will put the airbag module under the seat, if anything is packed around it, it can cause the airbag light to come on. Remove any items around it and check the connectors are firmly in place.

Apr 15, 2009 | 2008 Lincoln Mkz

1 Answer

Airbag light keeps coming on then off and on all the time


Hello, The airbag light comes on whenever there is any problem with the safety restraint systems.
This means that while the light is on the AirBag WILL NOT deploy. It could be several things....Electrical short in the Steering wheel (supplies power to Airbag), Seat belt locks (if the computer thinks the seatbelt is not in use it won't deploy the airbag), these are the most likely problems, But it could be bad or loose wiring under the dash (aftermarket Stereo?), or Impact sensors, or the Body control module. Any other lights? When does it come on / go off? Random or predictible pattern? Goods news is the car does not need an airbag to drive ... Good luck , hope that helped..

Jan 12, 2009 | 1999 BMW 323 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Adam Truesdale

Level 2 Expert

265 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...