Question about Cars & Trucks

Open Question

Mc hale fusion 2 baler baler door will not close on automatic

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have an 07 Fusion, windows on the back won't work at times, and passenger side won't work when driver door is opened.

Check for pinched or broken wires inside the rubber boot from body to drivers door . Opening an closing of the door over time causes these wires to break . Gently move the boot while trying the windows ,do they work ?

Sep 18, 2016 | 2007 Ford Fusion 1.4

1 Answer

14 Ford fusion(the rear passenger door)tried 2 set child lock & accidental click latch closed w door open. dealer wants to charge crazy fees to look at it.Can anyone please help me figure this out??!

Pull the door handle up or out like you are trying to open the door (no sure on this model, not a Ford guy) (unlocked door), at the same time with a screw driver pull back on the latch arm, if it doesn't move back the latch is defective and the dealer charge is correct.

Jun 24, 2016 | Ford Cars & Trucks

1 Answer

Were is the fuse for my ford fusion 2007 lighter

Open driver door,look on end of dash where door closes,you will see a fuse panel cover,just pull it out,the fuses are numbered,look for the cig lighter see number,look in fuse box find num,pull out fuse see if blown.look on back of cover,it will tell you which one you looking for,they are numbered.

Jul 24, 2015 | 2004 Ford Fusion

1 Answer

2007 Ford Fusion door lock. Replaced drivers inside door handle. Before repairs made, whenever I opened the door it automatically unlocked. Now I have to use the door lock switch. Any ideas?

Easy one, I say that because I did the same thing. When putting the new one in I missed one little detail. There's a small metal rod that is very easy to miss if you don't look close. It connects the inner handle to the mechanical lock, you didn't connect it. That's why the power and the keys work and the handle doesn't. You just have to take the handle back off and find that tiny rod. Once you see it you'll know exactly what I mean. Secure it in place, re-assemble, done. Glad I could help. Grimm

Apr 11, 2015 | Ford Cars & Trucks

1 Answer

Why does my ford fusion passenger door makes a grinding noise on opening and closing

Sounds like your door hinges need lubrication! (Should be done annually.)

Jul 31, 2014 | 2008 Ford Fusion

1 Answer

Ford fusion europe

To replace it you need to drain the fuel or drive the car until your vehicle is almost out of fuel (reserve light on )check if there is easy access to your rubber hose that goes from fuel door to your gas thank. If you can see the clamp on the hose close to the fuel thank you need to open fuel filler door, remove fuel filler cap there will be 3 or 4 screws 1/4"" size. Remove it, remove clamp from hose and air hose clamp (smaller one going to gas thank) and remove whole assembly. Installation is in reverse order of removal. Best way is to drive your car up the ramps, set the parking brake, choke the wheels and do the repair. It will probably take 1 to 2 hours of your time...

Apr 11, 2014 | 2006 Ford Fusion

1 Answer

After I've turned off my car. Removed the key from my ignition. Locked my door. The inside light located in the ceiling of the car still won't go out. Why? How can I make it go out?

Wait until your door closes all the way and then press the lock button. My Fusion does that too but after I get out of the car, shut the door, and lock it the light goes out.

Jan 02, 2011 | 2008 Ford Fusion

1 Answer

Remove master cylinder 1996 dodge caravan 2.4

disconnect brake lines from MC should be only 2. Remove the 2 nuts holding the MC on. replace in reverse order u will need to bench bleed the new MC and u will probaly need to bleed the brakes

Apr 13, 2010 | 1996 Dodge Caravan

1 Answer

My 2006 Ford Fusion's radio won't turn off. Everytime I take the keys out and open the door the radio doesn't cut off!! Why!!!

U have a defective door ajar switch most likely, if this switch remains closed then the delayed exit feature stays on, this means the radio will stay on because the delayed exit module didn't sense the door was opened, try opening the passenger door to confirm this problem, any door should turn off the radio

Mar 11, 2010 | 2006 Ford Fusion

1 Answer

I have a 2008 ford fusion where the dome light stays on all the time, even with the doors closed. We just purchased this car and we think it is an electrical relay problem.

your problem is probably caused by a sticking door switch try spraying wd40 in the door latches and opening and closing the doors several time do all the doors or you can take it to the dealer and they can scan the body control module and tell you which one it is

Dec 30, 2009 | 2008 Ford Fusion

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides