Question about Land Rover Freelander

Open Question

Does the freelander2 SD 2007 model have an inertial switch

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have a 2002 ford f150 crewcab and Im not getting any power to the fuel pump. Any suggestions?

Power comes from the ignition switch to the fuse panel. Do have power at both sides of the pump fuse? From the fuse it goes to the pump relay. Pull the relay. You should have power at 2 pins and ground at 2 pins. Jump the 2 large pins in the fuse panel. Check the pump plug for power it should be there. Check for power and ground in the plug, then check for power and ground at the body/frame.

Dec 11, 2016 | Ford Cars & Trucks

2 Answers

What is a inertia switch

An inertial switch is a switch, firmly mounted upon a vehicle or other mobile device, that triggers in the event of shock or vibration. It is a part of electrical circuits that may either enable or disable some function.

Inertial switch - Wikipedia

Dec 05, 2016 | Cars & Trucks

1 Answer

Where is the inertia switch located on a 2007 suzuki forenza?

the Daewoo wonder wagon, in snake clothing.
and 6 engines, ill guess at gasoline engine.
so what makes you think there is one, (hope:? dreams, rumors?)
you have zero fuel pressure, is that it? did you check that first?
got spark?
run on test fuel?
yes then
do you have 12vdc top the pump cranking> yes/no,

there is no electric fuel switch, period, only the Std, fuel pump relay
that PCM operates only.

that leaves fuel line switches (inertial fuel valves, real name)
and the fuel diagram, shows, no such part.! it's not there, in USA car
is it a USA car?
so you are guessing.?
thanks for the goose chase. what a waste.
why not , post the symptoms and get real DIAGNOSTIC help
and avoid this goose chase.
what's bad is suzuki online parts , suck they have no online drawings.
do you want go Guess, or test.
do say.

Oct 12, 2014 | 2007 Suzuki Forenza

1 Answer

I hit a speed bump my car doesn't want to start what I do

You likely hit the speed bump hard enough to trip the INERTIAL CUTOFF SWITCH, which is designed to turn your fuel pump off in the event of a collision. Usually, the Inertial Cutoff Switch is located in the trunk near the hinge on the driver side. Check your Owner's Manual for its location, and simply hit the reset button.

Jul 25, 2014 | Cars & Trucks

1 Answer

Corsa lite 1.4 cuts out when driving and does not stat immediately

Although there are many potential causes for this condition, it is most likely a FUEL DELIVERY issue. Potential suspects include the fuel pickup strainer, the fuel pump, the inertial cutoff switch, the fuel filter, and the fuel pressure regulator.

May 24, 2014 | 2007 Opel Corsa 1.2

1 Answer

I have a 2000 Oldsmobile Bravada I have changed the fuel pump and the fuel regulator it will run a short distance then it will die then I have to wait for it to cool down and then it will restart what is...

First, try bypassing the inertial safety switch (common failure) using a simple jumper wire across the two contacts of the connector. If you do not know where the inertial safety switch is, consult your Onwer's Manual.

If that corrects the problem, simply replace the switch (low-cost item from your local parts store).

If not, it may be the first signs of a failing ECU. GM ECUs will exhibit that failure initially before failing entirely.

May 23, 2014 | Cars & Trucks

1 Answer

How to release fuel pressure without gauge

Locate the inertial safety switch (usually in the trunk, check your Owner's Manual) and disconnect the electrical plug connector from it. Once you have disconnected the plug from the inertial safety switch, attempt to start the car. It may run momentarily, then will stall out and not restart. When this happens, pressure has been released from your fuel system.
After you are done with whatever you are doing and want to re-pressurize the system, replace the plug in the inertial safety switch, turn the key switch to ON (not START), count to five, then return the switch to OFF, count five, then do the same thing again two more times. After you have cycled the ignition switch three times, the car should start with no problem

Apr 09, 2014 | 1998 Oldsmobile Intrigue

1 Answer

Freelander2 /LR2 owner. Headlamp power wash problem.

sounds like a blocked jet/hose.try asking someone to operate the washers whilst you poke a small needle into will get wet.....

Feb 19, 2010 | 2008 Land Rover LR2

1 Answer

Telephone kit

you can either splice in to cig lighter or back of stereo , i recomend back of cig lighter although you have to lift the center console up to get to it

Oct 13, 2008 | 2007 Land Rover Freelander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

77947 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides