Question about Cars & Trucks

Open Question

What is the problem with my excelvan weather station when it stopped getting information from outside transmitter Only works a few hours after each reset .? I have it for about one year

This has been happening for the last 2 weeks. Fitted new batteries. Cleaned all connectors

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2920 Answers

SOURCE: 2003 Nissan Maxima will not start.

have the crankshaft sensor checked out on the car

Posted on Jan 17, 2009

Ad
emissionwiz
  • 76846 Answers

SOURCE: 2005 cadillac sts remote transmitter

This is the procedure for a reprogram of the remote's from the factory service manual, if it doesn't work then u may have a receiver issue.
Use this Procedure for Vehicles with
Driver Information Center Buttons

This information is in your Owners Manual in the
Drivers Information Center Section.


1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays

3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays

4. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.


5. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.

6. To exit programming mode turn key off and remove key.
Test remote(s).


Use this Procedure for Vehicles without
Drivers Information Center Buttons


To access this display, the vehicle must be in Park (P) with key in the on position (as far
as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE KEY LEARNING ACTIVE will display

3. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximately 15 seconds. A chime
will sound indicating that the remote is
programmed.

4. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key.
Test remote(s).

Posted on Jan 17, 2009

  • 2 Answers

SOURCE: passenger power window will not work from either button.

the window motor is finished in it and you'll need to change it

Posted on Mar 27, 2009

  • 1986 Answers

SOURCE: 2002 mazda protege5 auto battery light coming on

I'm guessing that you've tested the actual current output of the alternator then. I'm assuming that the output is between 13-14Volts at the battery when the car is running... If it's too low, then it's not charging your battery at all, too high, and it's frying your battery.... Another thing that can cause this is if you have a short in your electrical system.. that, however, will be difficult to narrow down...

Posted on Aug 12, 2009

  • 1 Answer

SOURCE: Car not starting after car runs for a while and weather is hot

It sounds like a fuel pump issue. When the pump gets hot it stops producing, or produces less. I'd have it checked out.

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I find local rainfall amounts for this year?


The National Weather Service Website should be able to help you. If you go to their website (www.weather.gov) and type in the zip code for a location in the upper left it will take you to the forecast page for that location. If you scroll to the bottom of that page and click on past weather information you can view the rainfall totals since January 1. Not sure if that is exactly what you need.

To see current rainfall totals on more of an hourly basis and not once a day when the above site updates check out http://aviationweather.gov/adds/metars/Type in the METAR code for that station (if you don't know it it is in the station.txt file, link on the page). Type that in the box and then make sure you click the button for translated. That will tell you the hourly report for that weather station which, if there was rainfall, should say how much fell.

Apr 04, 2017 | Cars & Trucks

2 Answers

My Ford Focus car doesn't centrally lock anymore, I have to use the key. It's not the fob battery because I changed it.


Sure you did put in a new battery? sure you did insert it correct? not the other way around? sure you did use the correct battery? like CR23 or AAA?
Sure all contacts in the battery compartment and on the battery are clean and shiny?
just a few things you could check.

Feb 09, 2015 | Ford Focus Cars & Trucks

1 Answer

My mercedes 1991 560 sel turn signals do not work


The radio station sends information by embedding it in the radio waves before transmitting it through air by its transmitters. This process is called modulation and it is done by changing any of its basic characteristics, frequency or amplitude.


-------------------------------------------
obd2express.co.uk

Dec 14, 2012 | 1995 Mercedes-Benz SL-Class

1 Answer

My 96 thunderbird sprutters at times during acceleration. it happens when the car will climb a hill or when just taking offrom a stop sign. sometimespushing harder on the pedal will make it go away, so...


Sounds like you might have some water in your tank "BAD GAS", Try a bottle of HEAT and pour into tanl and drive a few day's, This should help it. When weather warms most os the gas stations have water that gets into there tank. If this don't work you might check engine for vacume leaks, good luck to you.

Apr 09, 2011 | 1996 Ford Thunderbird LX

3 Answers

Car not starting after car runs for a while and weather is hot


have the starter tested because it sounds like a bad solenoid in the starter and it makes it get hot so it won't start

Apr 26, 2009 | 1991 Lincoln Town Car

1 Answer

2005 cadillac sts remote transmitter


This is the procedure for a reprogram of the remote's from the factory service manual, if it doesn't work then u may have a receiver issue.
Use this Procedure for Vehicles with
Driver Information Center Buttons

This information is in your Owners Manual in the
Drivers Information Center Section.


1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays

3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays

4. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.


5. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.

6. To exit programming mode turn key off and remove key.
Test remote(s).


Use this Procedure for Vehicles without
Drivers Information Center Buttons


To access this display, the vehicle must be in Park (P) with key in the on position (as far
as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE KEY LEARNING ACTIVE will display

3. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximately 15 seconds. A chime
will sound indicating that the remote is
programmed.

4. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
5. To exit programming mode turn key off and remove key.
Test remote(s).

Jan 17, 2009 | 2005 Cadillac STS

2 Answers

How to manual tune the radio to a station and not use the scan


i have the exact same problem. i bought a fm transmitter, so i need to tune to a unused fm station in my region wich i cant do because the audi concert tunes up automatic and skips the unused stations ... HELP !

Nov 23, 2008 | 1997 Audi A4

1 Answer

Programing garagedoor opener


HOMELINKT UNIVERSAL
TRANSMITTER (IF EQUIPPED)
The HomeLinkt Universal
Transmitter, located underneath
the driver’s visor, provides a
convenient way to replace up to
three hand-held transmitters with
a single built-in device. This
feature will learn the radio
frequency codes of most current
transmitters to operate garage
doors and gates, and can also
control home or office lighting and
security systems (with the
available accessory package).
NEXT
MODE
Controls and features
42
When programming your
HomeLinkt Universal
Transmitter, you will be
operating the garage door or
gate. Be sure that people and
objects are out to the way to
prevent potential harm or
damage.
Do not use the HomeLinkt
Universal Transmitter with any
garage door opener that lacks
safety stop and reverse features as
required by U.S. federal safety
standards (this includes any garage
door opener model manufactured
before April 1, 1982). A garage
door which cannot detect an
object, signaling the door to stop
and reverse, does not meet current
U.S. federal safety standards. For
more information on this matter,
call toll-free: 1–800–355–3515.
Programming
1. Prepare for programming the
HomeLinkt Universal Transmitter
by erasing all three of the factory
default channels by holding down
the two outside controls until the
red light begins to flash (20-30
seconds). Release both controls.
2. Hold the end of your hand-held
transmitter against the HomeLinkt
Universal Transmitter (located on
your visor) while keeping the red
light in view.
Controls and features
43
3. Using both hands, press the
hand-held transmitter control and
the desired channel control on the
HomeLinkt Universal Transmitter.
Do not release the controls until
step 4 has been completed.
4. Hold down both controls until
the red light begins to flash slowly
and then rapidly. Rapid flashing
indicates successful programming
of the new frequency signal.
5. Follow steps 2 through 4 to
program the remaining two
channels.
If you do not successfully program
the HomeLinkt Universal
Transmitter after repeated
attempts, refer to Training a
rolling code
which follows or call
toll-free customer assistance:
1–800–355–3515.

Controls and features
44
Operating the HomeLinkT
Universal Transmitter
Once programmed, the HomeLinkt
Universal Transmitter can be used
in place of hand-held transmitters.
To operate, simply press the
appropriate channel control on the
transmitter (the red light will
illuminate, indicating the signal is
being transmitted).
Controls and features
3. Press the programmed
HomeLinkt control in the vehicle
until the training light on the
garage door receiver turns solid
(1-2 seconds). Release the
HomeLinkt control and repress to
turn off the training light.
4. Press the HomeLinkt control
again. If the garage door activates,
the HomeLinkt Universal
Transmitter has been trained to
the receiver.
Erasing channels
To erase all three programmed
channels:
1. Hold down the two outside
controls until the red light begins
to flash.
2. Release both controls.
Channels cannot be erased
individually, but can be
reprogrammed. Refer to
Programming for instructions.

Oct 21, 2008 | 1999 Lincoln Town Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...