Question about Cars & Trucks

Open Question

Cani get a break down of where the fuel lines go on a mitsabishi pajero?

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Abs brakes ******* 2001 mitsabishi pajero replace two sensor with second hand told do i need to reset something

if the abs light is still on after changing the parts
then yes need to clear the lights with code reader.

some time if the car left with battery disconnected for 30 mins
it some time resets the computer and clear the fault

Sep 18, 2016 | 2001 Mitsubishi Pajero

1 Answer

Where is the fuel filter located on a mitsubishi pajero io (4G93)

The fuel filter is in the tank, lift the rear rug remove the plate held down by 4 screws under that is the tank with filter remove the 8mm bolts diconnect the fuel lines an pull up the filter an pump assembly

Mar 08, 2016 | Mitsubishi Cars & Trucks

1 Answer

Where is a fuel filter on my Mitshubishi Pajero wagon

Hi follow the fuel lines from the pump on the side of the engine it's usually on the L/H side as your sitting in jeep.

Apr 20, 2015 | 2002 Mitsubishi Pajero

1 Answer

Hi, i have a 1983 dodge ram 50, i think my fuel filter is pluggin up, so my question is, where is the filter located at and is there more than on? the engine # is G63B Mitsabishi Model L026....Thank Y

I'm not 100% sure on the exact model of your vehicle, but if you check on the inside of the frame on the side your fuel tank is on it should be there.

Oct 05, 2014 | 1983 Dodge Ram 50 4WD

1 Answer


check rear brake lines and rear slave cyl

Mar 23, 2014 | 1992 Mitsubishi Pajero

1 Answer

Fuel leak mitsubishi pajero 2.8 automatic

check the hose clamps on the rubber lines from the fuel filter to steel line. you can also trace the lines from there

Jul 28, 2009 | 1995 Mitsubishi Montero

1 Answer

How to bleed a 89 pajero that has run out of diesal

You have to crack the injectors, or loosen the fuel line going into each injectors. Then have someone help you by turning the motor over, letting fuel and air bleed out around the fitting that you loosen at the injectors. You will see air & fuel start spraying out around the point of breaking the lines. When you see a good flow of fuel. Tighten everyting back up tight. It should run ruff for a few seconds. Then you should be back to normal.

Jan 31, 2009 | Mitsubishi Passenger Cars & Trucks

1 Answer


right where the fuel filter is there is a primer you break the breather nut close back then prime(pump)break you will get air and deisel frouthy like bubble do this till deisel (fuel)comes clear,.,or start engine and break #1 injector line you wil see frouth lock back proceed to do remaining 3 injectors till frouth is out you will find engine dying every time you break injector,so lock off and continue with rest till it idle good

Sep 10, 2008 | 2002 Mitsubishi Montero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides