Question about Cars & Trucks

1 Answer

How can you tell if the fuse is bad 1977corvette by the starter it in plastice

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 46,703 Answers

Se a multimeter set to voltage and see if you get a reading after the fuse to ground

Posted on May 15, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

2002 sebring keeps blowing 20amp starter and fuel fuse


When does the fuse blow? As soon as it's replaced or when you try to start the car? Take the small wire off the starter solenoid. This will separate the fuel pump from the starter solenoid. With a new fuse in turn the ignition switch to the start position. Does the fuse blow? If so, then the fuel pump and/or the wiring to it has a short. If the fuse doesn't blow then the starter solenoid or the wiring between the ignition switch and the solenoid has a short.

Dec 27, 2014 | 2002 Chrysler Sebring

1 Answer

2006 Honda Accord 4 cyl 2.4 won't start.


yes that hum is fuel pump fuses are easy get a 12 volt tester and most new fuses have 2 tabs on top check both sides of fuse should light up tester if not fuse is probably blown pull starter and try to test with jumper cables or take to Canadian tire they will test for free i9t sounds like starter is shorting system

Jan 03, 2014 | 2006 Honda Accord 2.4

1 Answer

ON THE 2001 CHRYSLER SEBRING CONVERTIBLE DOES THE 20 AMP STARTER FUSE HAVE ANY OTHER CURRENT SOURCES OTHER THAN THE START CIRCUIT?


20A starter fuse? There is a heavy black/red wire that connects directly to the starter. The 120A FUSIBLE LINK 1 protects the charging circuit. There are two white wires that are connected to 30A FUSIBLE LINK 8. From there, power goes to the ignition switch and from the switch to the park/neutral position switch. That switch output is applied to the starter.

Sep 17, 2012 | 2001 Chrysler Sebring

1 Answer

If my starter is bad on my 2004 f250 6.0 would it turn slow and i just put new batterys in


maybe. Check the terminals are tight and the cables aren't corroded! These can be known for bad starters and cables, also fuse block corrosion. I would do a starter draw test with an amp clamp on the negative lead to main battery, not auxilliary battery. This will tell you how much amperage your starter is drawing.

Nov 29, 2010 | Ford F-250 Cars & Trucks

2 Answers

1998 ford taurus battery seems to work on all lights but ignition just turn key nothing .icant seem to boost it .is there a fuse somewhere


YOU NEED TO FIND THE STARTER RELAY [SOLENOID] AND CROSS POWER FROM THE TWO LARGE POST WITH A SMALL SCREW DRIVER.IF IT CRANKS OVER THEN YOU NEED A NEW SOLENOID,IF IT DOES'NT YOU NEED TO GET THE STARTER REPLACED OR REPAIRED.

Oct 16, 2009 | 1996 Ford Contour

1 Answer

1992 LS 400 Lexus. Car wouldn't start. New battery, thought was fuse problem, but no, towed in and mechanic says need new starter but starter under the engine block, will need new gasket for block after...


remove black plastic relay cover in plastic underhood fuse box and activate relay9006980.jpg with a very small screwdriver and ignition on. If starts, obviously the starter is fine, if not the starter is indeed bad and needs replacement so hold onto your ankles cuz it's gonna hurt.

Mar 01, 2009 | 1992 Lexus Ls 400

2 Answers

Wont start


you may be having a problem with the connections on the battery or your selenoid on you starter is goin bad

Feb 16, 2009 | 1996 Chevrolet K1500

1 Answer

Need to find out which fuse to pull for the starter relay


look for a relay on engine compartment on fuse panel, Relays are square plastic boxes plugged to fuse panel 1" Tall By 3/4 usually their size look on fuse cover for details or order the book on linehttp://www.themotorbookstore.com/carmanuals.html

Jan 22, 2009 | 1999 Ford Contour

1 Answer

I think my starter is going bad on my 1996 Galant


take your car to a starter rebuild shop, they should be able to tell your problem. the starter has plastic plantary hud with metal gears, that the noise you hear. the starter needs to be greased

Jan 04, 2009 | 1996 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...