Question about AC Cars & Trucks

Open Question

I have a lipor 6000ti and the ac overload light stays on steady

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal and Hazzards issue


Turn signal flasher. Replace with a heavy duty one.

Mar 20, 2014 | 2001 Jeep Cherokee

1 Answer

Wiring


Does the light stay on steady ?
and does the front flash?
if light stays on steady then the flaser unit needs to be changed, Lee

Feb 25, 2010 | Ford F-150 Cars & Trucks

1 Answer

Ac light stays on steady then starts to blink on and off


try swaping the magnetic clutch relay with another of the same relay in the junction block next to the battery.You may have a bad relay.

Sep 22, 2009 | 1995 Toyota Camry

1 Answer

I have a 2002 chevy silverado 1500 it seem that it is not getting fule it will not stay running and will start for a second but then stop when I try to give it gas or not give it gas I think it is the fule...


sounds like the security system is malfunctioning. When you turn the key on does the security light stay on steady or flash? If flashing leave the key on for about fifteen minutes till it stays on steady. the engine should then start. if it does not go steady, likely you need to replace the ignition key switch assembly.

Sep 10, 2009 | Chevrolet 1500 Cars & Trucks

1 Answer

Theft system


You have to take the key out for five -10 seconds after you wait ten mins in the on position. The reset does not take effect until you remove the key.

May 26, 2009 | 1998 Pontiac Grand Am

1 Answer

Hazard lights on steady in the off position


Please locate the fuse in the fuse box. there must be a failure from there. Take the car for a scan too.

Please rate this......

Mar 20, 2009 | 2001 Oldsmobile Silhouette

1 Answer

Flashing lights


Hi, had the same problem today. Solution: Start engine, blower on max, air direction to cabin, press rear wiper and rear wash buttons simulanteously for 5 seconds (all lights now on steady). Calibration test starts and lights flsh alternately. After first test, AC and recurculation lights flash for the cool down test. If all test pass then rear wiper light blinks slowly (press to exit self test). If AC and recurculation test fails then just 2 lights stay on. To repeat this part of the test press just AC and rear wash simulanteously ( may take several attempts and usually best when engine is cold). Again exit by pressing the rear wiper button once it is the only one flashing (slow blink).

This does work but it took me 15 minutes to finally switch them off!!!

Jul 28, 2008 | Chrysler Voyager Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top AC Experts

old marine
old marine

Level 3 Expert

2005 Answers

randymanfive

Level 3 Expert

450 Answers

David Harrelson
David Harrelson

Level 3 Expert

5324 Answers

Are you an AC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...