Question about Cars & Trucks

Open Question

Ihave kadett 1996 model dont want to spark ahave change crank sensor and destriup but if icheger the crank sesonr did not have add what is the broplem

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: 1996 chevrolet suburban 1500

check the ecm on the may have fried when you had the sensor pop out

Posted on Aug 10, 2008

  • 512 Answers

SOURCE: 1996 1500 ram wont start

there is also a crank sensor that can keep it from sparking. are you getting voltage to the coil

Posted on Jan 03, 2009

  • 181 Answers

SOURCE: 1996 jeep grand Cherokee 4.0L no power at coil got


Posted on Oct 28, 2009

  • 373 Answers

SOURCE: Dodge neon has no

remove electrical plug from coil,with test light check tosee if u are getting power to the coil with the key on.(remove fuel relay during the testing) if there is power to coil then check resistence on coil. with plug still disconnected.take ohm meter and connect to the two outside plugs to check ohm resistance 0.45 - 0.65 ohms then use ohm meter to check secondary resistance.connect ohmmeter across the two secondary terminals of each coil. resistance 11.5-13.5 k-ohms. if all checks out test wires and plugs. hope this will help!!!

Posted on Apr 23, 2010

  • 68 Answers

SOURCE: i have 1999 kia 1.8 wont start i change the cam

hi either you got a wire shorted out or the ecm failed on ya.
another thing to check is timing belt or chain you couldve popped the belt or jumped timing and the syncroing is off or got a bad check the timing belt loosen a few of the top screw on the timing cover and shine a light down there to see if the cams are turning if they are so far so good.then get a scanner on the car and see if the crank and/or cam signal is there and go from there.

Posted on Jul 16, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 2004 Chevy Malibu will not crank motor only spins. Ihave changed the spark plugs the coil pak and the fuel pump but all she does is spins.

Ihave changed the spark plugs the coil pak and the fuel pump ??????? Before replacing parts did you test the electrical Circuits for the fuel an ignition systems > You don't even know which system the problem is in . Hooking up a fuel pressure gauge an checking pressure and flow , Pulling a plug wire an seeing if there is spark. And it does crank . a crank no start condition . if the starter didn't spin the engine it would be called a no crank no start problem . Your best bet ,take it to a qualified repair shop . That has the diagnostic tool's and knowledge to diagnose the problem ,an not just replace parts . 047 Engine Hard to Start or No Start Scan Data for Ignition

Sep 13, 2017 | Cars & Trucks

2 Answers

Opel kadett 200 se alarm won't sound, engine won't start but cranks

Remove battery negative connection for 20 minutes, replace and unlock drivers door with the key. Then try and start it

Nov 06, 2014 | Cars & Trucks

1 Answer

Opel astra kadett alarm won't sound

You need to determine if you have spark and fuel. Is there gas in the tank?

Nov 06, 2014 | Cars & Trucks

1 Answer

Ihave changed the crank sensor and the coles on the plugs but still the it wont give a spark.


Apr 15, 2014 | 2005 Toyota RunX 160i

1 Answer

Vehicle died. Has a crank no start. No spark. timing is correct. Sprayed starter fluid into the intake, still won't start. Checked crank sensor when cranking engine, ohms are varing. Thanks, Marc

try changing the ignition module thats mounted under the coil ,well it was on the kadett and the astra which came out about the same year which i think this american named vehicle did so they could be the same vehicle

Aug 01, 2011 | 1995 Geo Prizm

1 Answer

No spark got gas

If you have access to a scan tool you can check and see if the scan tool shows any RPM's while cranking this indicates whether the pcm is receiving a signal from the crankshaft sensor.The crank sensor is generally located on the rightside of the car lower engine by the cranskshaft pully/dampener.Before going this route would check the ignition module which is right by the coils underneath the coil cover many auto parts stores can test these for you.

May 14, 2010 | 1996 Chevrolet Cavalier

1 Answer

Ihave been having problems with my 1997 oldsmobile achieva it would not start till the light on gear shift come on then i crank it so much that i tore starter up i bought a starter and a coil pack and put...

Try testing both the camshaft and crankshaft position sensors.Usually it turns out to be the camshaft sensor.No signal equals no spark and no start.

Apr 23, 2010 | 1996 Oldsmobile Achieva

2 Answers

I cant get spark out of the coil pack

cam sensor fires the injectors to synchronise injector pulsing with the spark at the spark plugs.. U need to probably change the crankshaft sensor (around the crank pulley) as the crank sensor is what controls the ignition spark.
hope that does it.

Jan 20, 2009 | 1996 Plymouth Voyager

1 Answer

1996 1500 ram wont start

there is also a crank sensor that can keep it from sparking. are you getting voltage to the coil

Jan 03, 2009 | 1996 Dodge Ram 1500 Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15387 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides