Question about Cars & Trucks

Open Question

Door barely opens and cd holder won't turn...just keeps searching without turning

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1267 Answers

SOURCE: Windows won't go up our down power door locks

It may be as simple as reprogramming your system. There is a way to re-synch your keys to the system. Use the instructions at:
http://www.programyourremote.com/classified/DisplayAd.asp?id=334

That vehicle had a lot of problems with the PCM "Power Control Module" and that may be your problem.

Posted on Jun 11, 2011

  • 9 Answers

SOURCE: Door chime and open door warning light won't turn off

more than likely you have a bad door switch check the driver side first

Posted on Dec 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Accessories won't turn off when driver door is opened but does turn off when passenger door is open


there is a switch in the door hinge its wore r derty spay hinge with blast away r wd 40 if it dosnt work the switch will need replaced

Jan 20, 2013 | 2002 Buick Rendezvous

1 Answer

I have a 2000 pontiac sunfire an the radio seems to stay on even when the car us turned completely off. What does that mean because it keeps killing my battery.?!


The most likely answer is that your vehicle's door pin switches aren't working. When you open the driver's door, does your dome light turn on? Your radio works with the vehicle's data bus to stay on until the door is opened; if the system can't tell that the door has been opened, then it won't turn off. The door pin switch should be mounted at the front of the door opening.

Aug 16, 2011 | 2000 Pontiac Sunfire

1 Answer

Can't get the head lamp bulbs out removed The cover unplugged the light pulled the Wire harness down but the bulbs won't Budge


Almost all headlight bulbs have a bayonet mount with a rubber gasket. The bulbs have to be turned about 1/4 turn, usually counterclockwise, to remove them. If you have the new bulb, look closely at the mount on it. It will be helpful in knowing how the bulbs are installed. If the bulb has contacts that you push into the holder, the holder is what you need to get out. It will have the bayonet mount. Sometimes the bayonet is hard to turn if the gasket is stuck to the housing. However, don't use any solvent or lubricant because if it gets into the housing it can damage the mirror coating. Even moisture inside the housing can damage the coating, so be sure you install the new bulb correctly with the gasket in place. Be sure not to touch the new bulb with your bare fingers. The oil from your skin will burn on the bulb surface and shorten its life and light output. Never touch any halogen bulb with your bare fingers.

Thanks for using FixYa.
Gaker

Jul 05, 2011 | Volvo S80 Cars & Trucks

2 Answers

Remove headlight renault clio


With the ignition off, open the bonnet. From behind the headlight unit, remove the rubber dust cover behind the bulb closest to the centre of the car. Reach in and carefully turn the back of the bulb holder about a tenth of a turn until it pops out. You can now carefully withdraw it so that the bulb is visible to work on. Remove it by pulling upwards carefully from the base of the bulb. When fitting the new bulb ensure that you do not touch the surface of the glass with your bare hands; doing so leaves oily deposits and can cause rapid failure of the bulb. Push the bulb into the holder, being careful not to damage the pins. Then reverse the removal procedure to refit, taking care not to get any wires caught when re-inserting the bulb holder.

Jun 30, 2010 | 2000 Renault 181

1 Answer

How do i change my back turn signal on my crystler minivan?


Open the hatch.

Look just inside the door frame and you will see two pack plugs about the size of buttons. Use a screwdriver to remove the plugs. The light fitting will come out.

Inside the fitting you will see the bulb holders. Turn the appropriate holder to remove it.

Remove the bulb and replace it. Try not the handle the bub with your bare hands. Use a clean cloth. Oils from your hands can shorten the life of bulbs.

Replacement is reverse of removal.

Hope this helps please rate the answer it if helps you with direction.

Mar 10, 2010 | Chrysler Town & Country Cars & Trucks

1 Answer

Brake light, 2008 Nissan Sentra


Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Jun 21, 2009 | 2008 Nissan Sentra

1 Answer

How do I turn off the interior lights 1998 Jeep Cherokee Limited?


Forget about shutting the lights off...not worth the effort. Besides, the amount of power is not that much, unless you have the doors open all day (why not just open the windows?) If you need to have the doors open all day, get a 2 amp battery charger and attach it while it's open. It will do a lot to keep your electrical system in top charge and you will be doing something good for it!

Jun 18, 2009 | 1998 Jeep Cherokee 4WD

1 Answer

Factory installed alarm won´t deactivate


Open the door insert key in ignition. turn to on

Now hold down the red button which should be flashing, untill silent

this will deactivate the alarm.


Jun 29, 2008 | 1999 Mitsubishi Montero Sport

4 Answers

Lock out bmw520i 1990


There is a procedure to open the doors in a lock out. You must pull up on the driver's door handle then insert the key and turn it counterclockwise while at the same time pulling the key as if you were trying to pull it out. You will be met with a lot of resistance but the lock will open provided your actuator is not froze. This is a tricky procedure and will no doubt take several practices to be able to pull it off. Good luck!

Jun 21, 2008 | 2007 BMW 525xi Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...