Question about Cars & Trucks

1 Answer

Wiring schematic for right hand radiants replaced switch and got confused with wiring

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 923 Answers

I might be able to help you ... that is, IF you will reveal what the make and the model of the device you are asking about. But I am not a mind reader!

Posted on May 15, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring schematic for Ford 2001 escape


For a full schematic use alldata.com. this is a pay site but it is the same site used by most mechanics and dealerships. This is the best source for schematics but beware these are fully detailed and can be confusing/overwhelming if you are not familiar with schematics of this type. These are definitely more detailed than what you will find in a haynes or Chilton repair manual.

Jul 17, 2016 | Ford Escape Cars & Trucks

2 Answers

Why doesn't passenger side brake light work?


Either your bulb is out or there is a bad connection somewhere. Usually in the socket. Clean up the connections if needed.

Oct 22, 2015 | 2005 Jeep Liberty

2 Answers

Can someone please tell me how to wire in a toggle switch for my blinkers the cam is busted I have no choice at the moment


ill believe you, no cash for a new combo switch.
they are not cheap .
so last time i did this at 15 yo. (paper boy; poor)
id use a war surplus toggle switch.
after all its just a center off switch.
but you need to buy the right switch.
and wire it up just like the old switch.
if you had the schematic, id not have to write 10000 words like above. in fact that is what schematics are for, replacing zillion words.

but hark, ? no car stated, no year , no model cars
so i cant just post the schematic.

but got alldata.com and read.
see this (use single pole double throw switch , aka: SPDT.with center off. (mouser.com sells them) as do walfart.

12v >>blinder module out>>> switch common, switch left out, to left blinker,switch outright to right blinker, wire.
done.
no auto cancel now.
here is a random car,
see the red circle, its really s SPDT switch with center off.
if you wire like this IT WILL WORK.
that is if the other parts are good there. on the right.


someone-please-tell-me-wire-in-toggle-0jkftiqau1wcuvsqxdqhiw1i-3-0.jpgid not do this today, as it a hack.
and hacks are for kids. (IMO)
id find a used switch or buy one new.
but that costs big money and is a ton of work
if car has air bags do not do this until you defeat them per the FSM book, or risk life or broken neck.

or use hand signals until you save up the cash?
its still legal to do that in most states.
many classic cars have no blinkers, at all.
or option 2:
buy what we call emergency tow car or trailer light kit, (clamps on)and you wire it to power
and adds a switch and you have temporary lights.
but that costs money too..
i cant think of much that don't cost money.
all cars are money pits.
day1 or all the time old.

and the tickets you will get, are more than the switch.

Jun 24, 2015 | Cars & Trucks

1 Answer

Why head lights will not come on


High beam and lows and FLASH mode all dead???????
can only be things. things?
a voltmeter solves this in 5 min work. (schematic in hand)
got DRL. not posting this on option fact, makes answers impossible.
but ill guess, NO

Fuses check all HL fuses. first.
then the path, switch. wires connectors relays, and head light

here is the schematic, with this and a voltmeter this is easy
right, ? no ask for help, with it.
this form sux by making photo too small,
i can link it full size. but you need ask me.
or log in to alldata.com and see it your self.

fa9d872b-12ef-48f1-ac1b-e19325dcfa47.jpg

Aug 27, 2014 | 1991 Isuzu Rodeo

1 Answer

I need the wiring schematics for a 1995 oldsmobile cutlass cierra


wiring schematics for what? audio?

if so


1995-96 Oldsmobile Cutlass Ciera Stereo Wiring
Constant 12V+ Orange
Switched 12V+ Yellow
Ground Black
Illumination Gray
Dimmer Brown
Antenna Trigger Pink
Antenna Right Front
Front Speakers 3 1/2" Dash
Left Front (+) Tan
Left Front (-) Gray
Right Front (+) Light Green
Right Front (-) Dark Green
Rear Speakers 6" x 9" Rear Deck
Left Rear (+) Brown
Left Rear (-) Yellow
Right Rear (+) Dark Blue
Right Rear (-) Light Blue



GM uses the same colors for all audio wires

I know a picture would have been better, but I think this could help

Aug 08, 2011 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Location of fuel pump reset


Hi going through a wiring schematic shows me that this car is not equipped with an inertia switch. There is simply a fuse, relay, engine control module, and the fuel pump in this wiring. This relay would be located on the right hand side of the dash. Here is an illustration showing the placemtn of the relay and the wiring.
The optima does not have a fuel pump reset switch, the fuel pump is controlled by a relay which is actuated by the engine control module...
ameezle_1.png

Jun 02, 2011 | 2004 Kia Optima

1 Answer

When turning the ignition on it the starter stopped suddenly and a puff of smoke came from under dash-1995 ram 1500 5.2. checked the starter, its good, replaced under the hood relay switch and underdash...


Go to your local auto parts store and purchase a repair manual with the wiring schematic in it. It will show you the exact wire you are looking for. When replacing it purchase the same guage & color wire so there will not be any problems or confusion if later repairs are needed.

Apr 28, 2010 | 1995 Dodge Ram

1 Answer

Hi there A while back a friend of mine's cressida was on fire. The engen compartment burnt and i have fixed it up nou the only problem is the electrical wiring, is there any way you can help me with a...


You will have to get a new (or second hand) wiring loom. Most workshop manuals have a wiring diagram in the back. You would probably find this diagram very confusing as usually they cover mutiple models on the one schematic. The alternative ti to wire up only the compnents that are needed using the loom or with automotive cable. Best I can do I'm afraid.

Mar 17, 2010 | 1990 Toyota Cressida

1 Answer

Headlamps not working, fuses o.k., bulbs ok, replaced switch ok 98 chevy cavalier w/ daytime running lights . 2 relays on harness between headlamps one is for fog lamps, not sure of the other , cannot get...


are your daytime running lamps working. if they are according to the schematic there are 4 relays, fog lamp, fog lamp cut off, isolation, and daytime running lamp; 2 fuses: right and left, that supply volts to the headlamps. it's a little confusing though, because these schematics might have some mistakes. anyway, it looks like the drl relay.grounds the headlamps when the drl control in the micro processor located in the instrument cluster senses the headlamps have been turned on. this trips the relay and 12vdc is supplied. the dlr might be bad. otherwise, i would think you have a hardwire or connector problem.

Mar 08, 2010 | 1998 Chevrolet Cavalier

2 Answers

Which wire is constant power 4 the radio, and which color is when the ignition switch is on, 91 ford f150?


1991 Ford F150 Truck Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: Green/Yellow
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Red or Black
Car Radio Illumination Wire: Blue/Red
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Green
Left Front Speaker Negative Wire (-): Black/White
Right Front Speaker Positive Wire (+): White/Green
Right Front Speaker Negative Wire (-): Black/White
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Pink/Green
Left Rear Speaker Negative Wire (-): Pink/Blue
Right Rear Speaker Positive Wire (+): Pink/Blue
Right Rear Speaker Negative Wire (-): Green/Orange

This should help you with more then just the constant power wire, good luck.

Dec 14, 2009 | 1991 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...