Question about Dodge Cars & Trucks

1 Answer

07 dodge caliber took off electronic throttle control (body) and as I shake i hear and feel something clicking inside of it

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 146 Answers

May be solonoids in injectors in throttle body.

Posted on May 15, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 412 Answers

SOURCE: Needing to locate the airbag control module '07 caliber

it is located behind the floor shifter in center console..under small piece of carpet

Posted on Jun 20, 2009

  • 1 Answer

SOURCE: need instuctions to change tail/break lights on 07 dodge caliber

popohead, if people thought it was easy, they wouldn't be here asking. Your reply is useless.

To remove the pins, look a them closely. Notice that there's two little notches cut into the cup that holds the pin. Use a flathead on each side to leveredge them out a little. If that doesn't work at all, you can use a pair of pliers to firmly grip the head of the pin and pull straight out. Quick firm pull.

Once the first pin comes out, the second pin should easily come out. At that point, firmly grip your taillight housing, and pull straight back: Don't try to wiggle it out, and don't try to lift it to one side or the other like a trunk or door. Just pull it firmly straight back like you would a dresser drawer.

Once it's out, the little wiring harnesses come out of the taillight housing with about a 1/4 turn, and the bulbs just slide straight out of those.

Good luck!

Posted on Nov 01, 2009

  • 714 Answers

SOURCE: 07 Dodge Caliber alternator

$270.00 to $300.00

Posted on Feb 12, 2010

  • 12 Answers

SOURCE: how do i install a alternator for a 07 dodge

you will need to disconnect the negative battery cable at the battery, remove right front wheel, remove underbody air dam, remove accessory drive splash shield, remove the accessory drive idler pulley. Next loosen the lower mounting bolt, then loosen the a/c compressor and relocate(pull down and to the outboard side of the vehicle to make room for the alternator the come out) next uplug field circuit from alternator and the B+ terminal nut and wire. remove upper mounting bolt on the alternator and lower mounting bolt. relocate the terminal to the other side of the a/c line. Rotate alternator pulley down and slide down and out of vehicle. Yes, its a pain in the ****.

Posted on Mar 11, 2010

  • 6927 Answers

SOURCE: where is the radiator fan relay for a 07 dodge

Not sure,but look on drivers side below radiator.

Posted on Jul 05, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

2009 dodge journey, rough idle stalls out at low idle

Check for carbon buildup in the electronic throttle body. Perform a throttle body cleaning and idle relearn after. Check for vacuum leaks.

Feb 19, 2018 | Dodge Cars & Trucks

1 Answer

2007 dodge caliber etc light on

Get a can or two of carb & choke or intake cleaner. Take the intake boot off at the throttle, and clean it thoroughly. It miught help to use a small brush (like an old toothbrush) or some paper towels to help wip it out

Apr 05, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

07 dodge caliber throttle control

Usually replacing the TPS - throttle position sensor will get rid of this issue.

Mar 31, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Electronic Throttle Control Indicator Light dodge caliber 2007

Stop using the car--period

Have it checked for codes,road tested &

I think you have very bad ignition coils that
put it into failsafe

They are so bad they spike the computer &
take out the throttle postion sensor signal &
you get ETC Failsafe

Can't use it like that-- it will ruin the exhaust converter

Dec 21, 2012 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

Were is throttle body on 2007 dodge caliber

Fallow the air intake tube back to the engine and at the end of the tube will be the throttle body.

Jan 14, 2012 | 2007 Dodge Caliber 2.0

4 Answers

Electronic Throttle Control light

I took my 2004 Dodge Ram 1500 5.7L Hemi to a mechanic that works from a garage at his home, recommended by a friend of mine. He removed and cleaned the throttle body and sensor(s?), then reinstalled them, and then disconnected both battery cables and held them together for 2 minutes so that the engine controller could reboot with the factory default settings, then reconnected them. I had bought a can of throttle body cleaner on my way over to his house for about $3.00. He charged me $40.00 for the job. This was done mid-February, about 10 weeks and 2500 miles ago. So far, the problem Has Not happened again, the truck has been running great!

Nov 25, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides