Question about Mazda Protege

Open Question

1998 Mazda Protege. Installed new belts and power steering sensor. Disconnected battery. Now will not start but cranks over. Lights flash? Help

Bruce North Beach WA

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
thutson66
  • 96 Answers

SOURCE: 2001 mazda protege will not start

well, with all that you have changed the only two possible things that are left PCM and the ECM....

Do you have an alarm system on this vehicle? If you purchased this car second hand it may have something that is inhibiting the engine from firing. From what you have told us here that would be where I would start looking.

I really hope this is helpfull

Posted on Aug 10, 2008

Ad
  • 1779 Answers

SOURCE: Possibly battery-related problem with '02 Mazda Protege

It sounds like the car's security system is going off. Is there a key fob to lock/unlock doors and turn on alarm? If there is, connect battery, and immediately press alarm/unlock button to turn alarm off.
I have a truck with an aftermarket alarm system installed by the previous owner, my battery died, and when I hooked up a new one the alarm went off, and it took a while before I hit the key fob button, but it stopped it. Let me know if this works for u.

Posted on Nov 19, 2008

  • 423 Answers

SOURCE: Replacing 2 belts on a 2000 Mazda Protege

I recommend that you go to any Auto Parts store and by a repair user manual for your 2000 Mazda Protege.  They have pictures and arrows and stuff that you will need to do the whole job.  The non-Mazda version will cost approximately $15.00.
Because of the tensioner that may come off when while you are doing these belt changes, it is too complicated to talk you through this.
But with the manual, I am confident you can change them.

Posted on Apr 16, 2009

  • 58 Answers

SOURCE: I have a 1998 Mazda Protege with the P1195

P1195 EGR Boost Sensor Circuit

Posted on Jan 01, 2010

  • 1 Answer

SOURCE: heater lights flashing

Turn it on, Put the heater on high. While the heater is on high hold down the rear wiper, rear washer and recycle air buttons (all at the same time) for 5 seconds. It will reset your heater computer.

Posted on Feb 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Mazda Protege wouldn't start, battery seemed dead replaced battery with a new one and still no power


Does anything work? Lights, radio? Do the warning lights and gauges turn on when key is turned to on? That would verify power is getting to the ignition switch and is being sent out.
Pretty limited in what you can check without a voltmeter or test light. If you have power to the ignition switch, need to know if power is getting to the starter solenoid on the starter motor when the key is held in cranking position. If power there, likely a new starter is called for-have yours tested.

Sep 22, 2013 | 1994 Mazda Protege

1 Answer

Need a diagram for 1996 mazda protege serpentine belt


you don't have a serpentine belt just two drive belts one power steering and ac to crank belt and one alt belt

Nov 25, 2011 | 1996 Mazda Protege

1 Answer

How to remove a/c belt on a 2000 mazda protege


pretty easy, loosen the power steering on top and bottom, then there is a long bolt sideways on top of p/s pumy crank it in or out whichever loosens replace belt and repeat opposite steps to tighten

Feb 27, 2011 | 2000 Mazda Protege

1 Answer

I have a 1998 mazda protege and i am getting no spark or it wont start, I changed the plugs and wires, the distributor and the crank sensor...there is no power to the fuel pump relay also... please avise.....


the first thing is to scan computer for codes, and also pay attention to the anti theft system, if the key chip is bad car will not start,then check coil,

May 20, 2010 | 1998 Mazda Protege

1 Answer

My belts have broken. Car overheated, lost power steering, and battery light illuminated. What is wrong with my car? previous website listed above shows a serpentine belt tensioner, does this apply to my...


It looks like you may have 2 serpentine belts, but when one fails it almost always gets tangled into the any other belts and they all end up coming off, all of the problems u listed are driven off your belts, replace the belts and hope that the overheat didn't cause any damage to the engine. And yes you have what are called serpintine belts and there is a tensioner for each..

Feb 28, 2009 | 1998 Mazda Protege

2 Answers

Belts making noise


Simply check is to replace the serpentine belt tensioner. Looks like this:
http://www.1aauto.com/1A/SerpentineBeltTensioner/Mazda/Pickup/1AEBT00008/975584/1/?utm_source=google_base&utm_medium=cpc&utm_campaign=google_base_api
Another reason you might have alternator going to die. Try to rotate the alternator rotor without belt on it. If you need to use force no free rotation, replace the alternator.
Please kindly let me know if you need more info
Good Luck

Feb 10, 2009 | 1998 Mazda Protege

1 Answer

Possibly battery-related problem with '02 Mazda Protege


It sounds like the car's security system is going off. Is there a key fob to lock/unlock doors and turn on alarm? If there is, connect battery, and immediately press alarm/unlock button to turn alarm off.
I have a truck with an aftermarket alarm system installed by the previous owner, my battery died, and when I hooked up a new one the alarm went off, and it took a while before I hit the key fob button, but it stopped it. Let me know if this works for u.

Nov 19, 2008 | 2002 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...