Question about Cars & Trucks

Open Question

What wire to ignition coil has a consant crank curtin to it in steering wheeel

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: cranks no start,changed ecm,crank pos sensor,spark

when you put the key on position does the check engine come on it as to be on if not blow ecm fuses or go to positive side of battery there a little wire after 3inch there a blac k plastic that connect and other wire pull on the wire if it break just remove plastic hook the wire togetherand try it good luck pierre

Posted on Aug 02, 2009

  • 3640 Answers

SOURCE: no 12 volts to ignition coil

on a lot of plymouth acclaims ,there is no fuse marked ignition. what I would do is check for voltage at the ignition switch. if no voltage is going thru it. then the ignition switch is bad. check the wires from switch, and turn key to accy,then check wire. then turn to run and record voltage.

Posted on Apr 04, 2010

Testimonial: "Thank you sincerely !"

afarri
  • 1386 Answers

SOURCE: 1968 bus no spark at

Hello and welcome to FixYa!
Have you replaced the distributor coil pack inside the engine? If not, then now is the time. The distributor coil supplies current to the plugs that when it's burnt or faulty the result will be a no spark. Once replaced I believe you'll be good.
Hope this helps and thank you for using FixYa! Have a good one!

Posted on Jul 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank position sensor and the ignition module ,coil pack at on a 1998 Pontiac Montana transport


Your spark plug wires go to coils, coils sit on top of ignition module.You have two crank sensors, if crank sensor issue, check the 7x crank sensor, on back side of engine block, down low, two wire connector, wire colors, yellow and purple.
coil pack-byehkl55qszftorfvkdndylg-2-0.jpg

Apr 05, 2017 | Pontiac Montana Cars & Trucks

1 Answer

Airbag lights go on while turning the wheeel


Most likely a bad contact or a chaffed wire in the steering column.

My Toyota truck had a recall on an air bag wire in the steering column that could chafe, causing the air bag to deploy, so you might want to have this checked out.

Sep 27, 2013 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Why won't my 1990 Ford Taurus spark?


You make no mention of having done an OBD2 fault code test, do that first.

Feb 27, 2017 | 1990 Ford Taurus

1 Answer

My key won't turn over to the on position and can't get the ignition out


sometimes you can move steering wheeel back/forward while turning key . if not ,you need to pull steering wheel off to gain access to the switch

Nov 12, 2010 | 2005 Pontiac Grand Am

5 Answers

I have a 1996 GMC yukon with 5.7 engine it is not firing I have changed the coil this did not fix problem what do I check next


Check for injector pulse if no pulse with no spark check ignition module in distributor or crank sensor.

Nov 11, 2009 | 1996 GMC Yukon

2 Answers

Engine cranks,no spark at plugs


If there is no spark at any plugs, you need to check the coil and the ignition module. If you are getting spark to some of them then check the wires and distributor cap.

Mar 30, 2009 | 1997 GMC Jimmy

1 Answer

1989 CHEVY G20 VAN WONT START


Well.... I do not see the ignition module listed, which is mounted inside the distributor mentioned yet. Have you replaced it and just not listed it? The crank sensor could be too.....I just can't imagine having to cut a wiring harness. Never had to before... keep trying other things.

Nov 14, 2008 | 1989 Chevrolet G20

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...