Question about Cars & Trucks

Open Question

My level is 6.1 is that overly high - Cars & Trucks

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

94 Isuzu Rodeo 3.2L V-6, automatic transmission slips from first to second

guesses? there are over 10.

1; low level or too high ATF.
2: filter packed. do the service now.
3: low pump pressure.
4: bad clutch packs, if it slips now, it will get worse faster.
5: or any of the other vast ways to get the wrong pressure to the servos. (huge list)
the fsm covers on car check for a/T why not read that.?
every step.

Apr 13, 2014 | 1994 Isuzu Rodeo

1 Answer

Replace high level rear led break light

First remove the trim to expose 6 screws remove the screws and pull the high mounted brake light from its housing or cut out. when loose unplug the connector the light it is now in your hand. reverse for install do not over tighten the housing will break.

Apr 07, 2012 | 2007 Audi A4 Convertible

1 Answer

My 6.5LTD Silverado will not start

I'm assuming you a talking about a Turbo Diesel. Diesels can be complicated. I would suspect the fuel injection pump. It must reach 1900psi to overcome the compression.

I've had pumps go bad because of the ultra high tolerance needed in the pump itself to get to that performance level.

Feb 15, 2018 | 1995 Chevrolet Silverado 2500

1 Answer

My 91 explorer wont pass emissions, Co levels too high and hc levels. Are high as well

have your air/fuel (a/f) ratio checked. high CO level means you have a rich a/f mixture.

rich a/f mixture means there is too much fuel compared to air. this is bad for fuel economy.
lean a/f mixture means there is too much air compared to fuel. this needs immediate attention since this might lead to over compression in the combustion chamber, which develops to total internal engine failure.

Aug 06, 2011 | Ford Explorer Cars & Trucks

1 Answer

Oil level shows about 1.5 qts high oil changed 6

If you added oil level before engine was warm
Then when engine is warm you recheck the level
Oil Expands with heat
let it cool down and then re-check if its too much drain a touch off.

Jun 23, 2010 | 1998 Ford F150 Regular Cab

1 Answer

Megane boiling over

If the car has a coolant reservoir, check the coolant level after the car has been sitting overnight. The car should be off. The level should be at the cold level line.

Your level might be to high. Hope this helps.

Apr 03, 2010 | Renault Sport Cars & Trucks

1 Answer

Code 463 fuel level sensory high imput, what is this and where is it located

Not sure if this helps or not, but here is information from the 1998 Jeep Grand Cherokee Service Manual, ezg_25.pdf, page 6 of 20…

Hex Code = 95
Generic Scan Tool Code = P0462
DRB Scan Tool Display = Fuel Level Sending Unit Volts Too Low
Description of Diagnostic Trouble Code = Open circuit between PCM and fuel gauge sending unit.

Hex Code = 96
Generic Scan Tool Code = P0463
DRB Scan Tool Display = Fuel Level Sending Unit Volts Too High
Description of Diagnostic Trouble Code = Circuit shorted to voltage between PCM and fuel gauge sending unit.

Hex Code = 97
Generic Scan Tool Code = P0460
DRB Scan Tool Display = Fuel Level Unit No Change Over Miles
Description of Diagnostic Trouble Code = No movement of fuel level sender detected.

for additional information on troubleshooting and resolution:

Mar 01, 2010 | 1998 Jeep Grand Cherokee

1 Answer

High NO Level During Emissions Test

Try a new cat converter and you should be good to go

Jul 19, 2008 | 1993 Subaru Justy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides