Question about Ford Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I work for Ford and have never seen this code, but the sensor must be on the fuel rail on the top of the engine, vans have a hot stall/hessitation issue from vapor lock, maybe this is part of the fix.
Posted on Mar 24, 2009
ps...you do not have to Post another Question....just Add a Comment to this question.
"HOW TO": I professionally prefer the Serpentine Tensioner Tool.
Standard Rules to Removal the Serpentine Belt with an Automatic Tensioner:
1. Find the Tensioner(s).
2. Using a Serpentine Belt Tensioner Tool, Or Wrench OR Ratchet, Rotate/Move the Tensioner USING THE AVAILABLE NUT (located on the Tensioner Pulley rotating the Tensioner Pulley/Arm - moving it away from contact with the belt and towards the area where the belt is not in contact with the Tensioner Pulley. The Tensioner is spring loaded, and is hard to rotate/move.
3. Remove the loosened belt off one of the other more easily accessed Pulleys.
4. DO NOT quickly release the Tensioner, but gently allow the Tensioner to rest in its closed position.
Standard Rules for Installing the Serpentine Belt with an Automatic Tensioner:
a. Pick a Pulley that is most easily accessed. This will usually be on top. This will be the last Pulley that the belt will go on.
b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right.
c. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley and Arm "away" from Belt contact area on the Tensioner. This spring is pretty hard and with a new belt, it will be even harder to install. Rotate/Move this to as-close to the maximum allowed inorder to have enough slack in the belt to get it up and over the last pulley.
d. Using your other hand - Pull the Belt up and over the Last remaining Pulley.
e. Before releasing the pressure on the Tensioner, visually inspect the remainder Pulleys and the Belts' Positioning on them.
Posted on Apr 16, 2010
Testimonial: "The help was vrey helpful i could complete the job"
Posted on Apr 20, 2012
i had that problem with my Ford and the ground wire for that side was corroded and not making contact. i installed a new ground and drilled a little new hole to fasten it with a metal screw into the body. Works good now.
Posted on Apr 04, 2017
Tips for a great answer:
Apr 03, 2017 | Ford E-150 Cars & Trucks
Oct 24, 2016 | Ford Cars & Trucks
Jul 21, 2015 | Ford Cars & Trucks
Mar 12, 2015 | 2002 Ford Econoline Cargo
Jan 10, 2015 | Ford Cars & Trucks
Apr 20, 2012 | 2002 Ford E350
Aug 04, 2011 | Ford Econoline Cars & Trucks
Feb 04, 2011 | Ford E-150 Cars & Trucks
Nov 18, 2010 | 1992 Ford Econoline
Mar 24, 2009 | 1996 Ford Econoline
Jun 20, 2018 | Ford Cars & Trucks
21 people viewed this question
Usually answered in minutes!