Question about Toyota Cars & Trucks

Open Question

How do you disconnect the bulb from wire harness of 2006 Toyota Avalon? I can't get it to release.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 76 Answers

SOURCE: Replacing 2000 toyota avalon fog light bulb

o easy enough just jack frontcar up use jackstand for safety now loo up under the bumper where fog lights sit depending on style fog light u might need to pull the whole assembly out or just twist the bulb not a hard task once u see it from underneath it is pretty easy

Posted on Dec 02, 2008

headhart40
  • 1 Answer

SOURCE: 2006 toyota corolla left headlamp replacement

start in the back the hol assebly comes out

Posted on Dec 27, 2008

  • 3 Answers

SOURCE: remove engine from toyota prius precautions

Try putting the engine back in and then refill the fuel tank with strawberry douch that should solve the proble you were havin in the first place. No need to remove engine.

Posted on Jan 01, 2009

  • 1 Answer

SOURCE: instructions on replaceing a bulb (headlight) in

Just changed mine yesterday. If you have the wiring harness out, all you need to do is unplug from harness. The bulb has three prongs. On mine the harness was actually fried and the plastic melted around the prongs. I had to pull and wiggle the bulb to disconnect. bought a new harness for $4 dollars and hooked up.
To get to the bulb you have to get to it from behind the headlight and may either have to remove the air filter cover or alarm horn to get to it. After pushing back the rubber boot, The bulb is clamped in with a spring clamp and you need to push the clamp togeather to disengage the bulb and harness.

Posted on Jan 22, 2009

  • 186 Answers

SOURCE: 2001 Toyota Avalon - Rear signals

Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

Posted on Aug 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I get access to a right marker bulb on 2006 avalon to replace it?


it is a buld then under the bonnet /hood at the back of the lamp unit

Aug 24, 2012 | 2006 Toyota Avalon Limited

1 Answer

Directions installing marker light bulb 06 toyota avalon


napa,auto zone has those directions also the parts dept at your dealer and the owners book has those in the rear of your book

Aug 21, 2012 | 2006 Toyota Avalon Limited

1 Answer

Can I replace the headlight wire harness?


Yes, you can buy it from your local toyota parts store(dealer)

Jul 28, 2012 | 2006 Toyota Corolla

1 Answer

Back light left put in new bulbs still not working


check fuses if not fuse test wires for power at wireing harness

Dec 16, 2010 | 2000 Toyota Avalon

1 Answer

Cobalt 2005 ls headlight bulb replacement


Instructions Things You'll Need:
  • 9007 LL halogen headlight bulb
  • Wrench
  • Gloves or clean rag
  1. Step 1 Set the parking brake and remove the keys from the ignition to ensure your Chevy Cobalt won't roll while you're replacing the headlight bulb.
  2. Step 2 Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it.
  3. Step 3 Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.
  4. Step 4 Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.
  5. Step 5 Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.
  6. Step 6 Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.
  7. Step 7 Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.
  8. Step 8 Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly

Feb 26, 2010 | 2006 Chevrolet Cobalt

1 Answer

How do you change the alternator on a 2002 toyota avaoln xls


Disconnect the battery before starting the job! Your power cable from the alternator will be disconnected and could potentially ground out if your battery is not disconnected!


  1. REMOVE DRIVE BELT Loosen the pivot bolt, adjusting lock bolt and adjusting bolt, and remove the drive belt.
00f6788.gif

  1. REMOVE GENERATOR
    1. Disconnect the generator connector.
    2. Remove the nut, and disconnect the generator wire.
    3. Disconnect the wire harness from the clip, unplug.
    4. Remove the pivot bolt, plate washer, adjusting lock bolt and generator.

5e50aad.gif

Please be sure to rate me if you find this information useful, thanks for using FixYa!

Sep 15, 2009 | 2002 Toyota Avalon

1 Answer

Vsc vsc off check engine light on 2000 toyota avalon I have the same problem on my 2006 Avalon Limited. Error code indentifies the O2 Sensor located on Bank 1 Sensor 1 as defective.


Disconnect your battery for 10 minutes after which you connect it back the lights should go off. Don't report to toyota. Nigerian style!

Rate this............

Mar 21, 2009 | 2007 Toyota Avalon

1 Answer

Burned out brake light (middle top light)


Take a putty knife and slide it under the front of the cover to release it from the area behind the back seat and pull it forward. Then twist the bulb holder out of the cover. The bulb pulls out of the holder . Replace bulb and reassemble.

Feb 18, 2009 | 2002 Toyota Avalon

1 Answer

Panel light burnt out 2002 Avalon


Remove lower dash panel, remove screws holding cluster to top of dash, remove middle dash panel around steering wheel. this will expose additional screws holding cluster in place, when all screws are removed the cluster will move forward a bit. THEN you must reach behind and release the speedo. it wil either be plugged in or a spring clip holds it in place. push the spring clip toward the rear of the vehicle, while keeping no tension on the speedo cable, while it is fully depressed, gently and firmly pull the speedo cable away from the cluster. Two harness connect to the cluster, each has a pressure clip, just squeeze and pull back on harness connector to remove. When released the cluster will be freed. With the cluster face down, the bulb with remove with a counter clockwise turn, just confirm whcih one you want to change. I'd recommend changing all! check that all bulbs fuction before resecuring all pieces.

Dec 17, 2008 | 2001 Toyota Avalon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...