Question about Chrysler Sebring

Open Question

2003 Chrysler Sebring 3.0 turning over but not firing,I had heard the distributors are bad for going out

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Chrysler sebring 99 convertible was driving and shut off

Under the hood check the starter fuse it a 20 amp and can fail any time. My car has done it twice, thankfully not when i was driving. It just wouldn't start. First time i had it towed and the second time I just checked it and replaced it myself. Still looking for a cause?

Posted on Nov 24, 2008

Ad
dealt_soul
  • 296 Answers

SOURCE: 2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

Posted on Jan 18, 2009

  • 49 Answers

SOURCE: error codes 442 and 456 on 2003 Chrysler Town and Country

Could be the gas cap.  Do you fill the tank with the engine running?
Otherwise, check the hoses near the Evap canister.  I have 2003 T&C and had the small leak and large leak codes.  I looked at the evap cansiter and the hose coming from the fuel tank vapor line had a huge crack in it, to the point it had fallen off the evap caniser.  I trimmed the end of the hose and reconnected and voila, no codes.
The evap canister is on the driver's side of the van, underneath, slightly behind the drivers seat.
BTW, to clear the codes without an OBDII reader, remove the negative cable for 5-10 minutes (15 to be safe).  The computer resets and clears the codes, except for one that it sets saying loss of power to the memory.

Posted on Jan 24, 2009

garputo22
  • 127 Answers

SOURCE: 2003 Chrysler Sebring ~ wrong battery installed and shorted out

You need to replace the alternator fuse. fuse 26 on the chart Notes Centralized Junction/Fusible Link And Fuse Part 2 Notes Fusible Links 1-25 (Relay Box In Engine Compartment)

Posted on Jun 05, 2009

  • 1596 Answers

SOURCE: 2004 chrysler sebring grinding noise

Check CV Joints and AXEL BEARINGS This is Common

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Windshield wipers stop working when the defroster is on


The only thing they have in common is the ignition switch.

Dec 18, 2015 | 2007 Chrysler Sebring Sedan

1 Answer

1998 chrysler sebring lxi with a 2.5 mitsubishi motor i have put 3 new distributors on it running great but now it is only hitting on 1,3,and 5 can any one help me


Check your spark plug wires, using insulated pliers pull the wires off one at a time to see it each one has spark. You may have bad wires ore even a bad cap even if it is new. Since some cylinder are firing I think you have a wire problem.

Dec 23, 2012 | 1998 Chrysler Sebring

1 Answer

My 1997 Chrysler Sebring JX quick running after coming to a stop at a stoplight I can here the fuel pump hum when the key it turned on cylinders have compression so I know the timing belt is on the crank...


You likely need a fuel pump because you hear the pump, but it is NOT pumping anything- like a well needs priming. Drop the tank and replace the pump.

Oct 30, 2011 | 1997 Chrysler Sebring

1 Answer

1997 chylser sebring 2.5 engine want crank plugs are fring fuel pump work timing belt didnot break battery charge gas in the car


how do you know all this (plugs firing, timing belt good, etc ) if engine wont crank??
Chrysler had a major problem in those years with the distributor going bad...buy new on ebay for around $100...dont buy used1

Aug 24, 2011 | 1997 Chrysler Sebring

1 Answer

Why does my 95 sebring cut out after i drive it awhile .It drives ok until i drive about 3 miles then it loses power.


you might have a bad distributor, but inspect E.G.R.and crank signal, is this a 2.5? very common for this eng. size distributor goes bad and if installed non factory one will ended up having same problem

Nov 17, 2009 | 2000 Chrysler Sebring

2 Answers

2003 chrysler sebring is hesitating whn at higher


(Fuel filter will not effect anything, it only prevents build up in engine)
Could be one of these-
Oxygen sensor
fuel sensor
Dirty injectors
Bad injector/injectors

~~~~Go to car zone/ or a frendly auto part store, and ask them for a FREE electronic computer check ( where they check the computer, and the computer tell them whats wrong)

Sep 28, 2009 | 2003 Chrysler Sebring

2 Answers

98 Chrysler Sebring 2.5 6cyl wont start. engine wont even turn


sounds like your starter ruined your flywheel. replacing the flywheel is not easy. also expensive. call a couple of tranny shops to get an estimate.

Mar 24, 2009 | 1998 Chrysler Sebring

1 Answer

Dead cylinders 2003 sebring


it sounds like you may have the wires on the wrong coil. It should be #1 on the #4 coil, and the #3 wire on the #2 coil. you probably have them backwards so 1 and 3 are firing on the exhaust stroke.
the firing order is 1-3-4-2.
they should be hooked like this.
82c8490.jpg

3ddfc56.jpg

Jan 23, 2009 | 2003 Chrysler Sebring

1 Answer

Chrysler cirrus 2.5 v 6 no fire


I've heard it's an issue with the distributor. Moisture, washing your engine gets through the vents in the distributor causing no spark. The ignition coil/module is built into the distributor housing. This means the distributor would have to be replaced. People also have tried using WD-40, I don't recommend, due to it only being a temporary fix and the petroleum in the WD allows build up to occur. BAD distributor design!!!!

Nov 17, 2008 | 1995 Chrysler Cirrus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...