Question about Cars & Trucks

Open Question

No spark to the number one spark plug. Please help

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ford focuskeeps missing if sparks on 12 AND 3 BUT NO SPARK ON 4 CHANGED PLUGS AND LEADS CAN YOU HELP PLEASE


This has a coil pack and four spark plug wires, correct? If so and you have replaced the spark plug wires and you don't have any spark out number four but you have spark on number one than you have a bad coil. You can remove the number four wire from the coil start the engine. Use. Test light connected to ground and place it near the opening in the coil that the spark plug wire goes into. You should see a sharp strong snappy spark. You may find that you have to hold the test light really close to the metal part inside the oil tower to see any spark. If this is the case you have a bad coil. Be careful when checking for spark. There is between 30 - 40 thousand volts generated but the merge is extremely low. If you get zapped it's going to tickle. Bit but it won't kill you. Good luck and let me know what you find.

May 26, 2011 | 2000 Ford Focus

3 Answers

What number and type of acdelco spark plug fits a 2000 s10 pickup with 4.3 motor ,4x4


2000 Chevrolet Truck S10 P/U 4WD 4.3L SFI 6cylSPARK PLUG ASM
Part Number: 12
Product Notes:
[Rapidfire Spark Plug]; .060 GAP
Per Vehicle: 6; Years: 1996-2001

SPARK PLUG ASM
Part Number: 41-993
Product Notes:
[Platinum Spark Plug]; .060 GAP
Per Vehicle: 6; Years: 1996-2002

From acdelco-catalog


Hope helps (remember to rate this answer).

Jan 04, 2011 | Chevrolet S 10 Cars & Trucks

2 Answers

Number 2 spark plug


Are you sure it's the spark plug that's faulty or the ignition wire?? How old are plugs and wires?
If you don't know if it's your spark plug not firing or your ignition wire you could move spark plug to number 1 then check your code reader.
Or you could do an ohms continuity test on your number 2 ignition wire to verify that there is no break in the wire. Common problem to check for. If wires and plugs are old and high mileage maybe should change all including cap and rotor on distributor. Fresh wires plugs cap and rotor always improve mileage and performance.
Good luck, sorry can't help with tranny.

Dec 10, 2009 | 1998 GMC Jimmy

1 Answer

Can you please tell me the spark plug gap for a 1996 Mazda Protege XL, 4 cyl?


Make: MAZDA
Model: PROTEGE - LX
Year: 1996
Engine: L4 - 1.5L - FI - - GAS

Champion / Traditional spark plug / Part Number RC12MC-4 / OE GAP .044"

Note: w/SOHC (Original Equipment Manufacturer and/or Original Equipment Equivalent)

More details in Champion Spark Plug

I hope help you (remember rated this help). Good luck.

Sep 25, 2009 | 1996 Mazda Protege

2 Answers

2001 Honda Odyssey which cylinder is number 2? (3.5 L V6)


see your spark plug cables they have writen in begining or ending what number spark is. or in the joint electrical box from they take electricity have writen in it in any output what number of cylinder cable spark id going.

Apr 07, 2009 | 2001 Honda Odyssey

1 Answer

I can't find the spark plugs in my 2005 sonata


To locate and change the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine:
Remove the (4) 12mm bolts from the decorative plastic engine cover. Remove plastic cover from engine and place it off to the side out of your way.
Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed.
Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right.
Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insulated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place.
To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place.
Repeat same procedures for spark plugs number (3) and (4).
Note: If you have the (6) cylinder engine, the front (3) sparks pluge are readilly accessible but in order to access the (3) rear spark plugs, you will have to remove the intake manifold.


please rate!

Mar 18, 2009 | 2006 Hyundai Sonata

1 Answer

Spark plug number/location


Hi there Passenger side front to back......1,3,5 Drivers side front to bak.....2,4,6. Hope this helps you out

Jan 19, 2009 | 1996 Chevrolet Blazer

1 Answer

Spark plug wiring


The coil have these number 1,4,3,2 these are the cylinder number and the number 1 cylinder spark is the first of the left when you are in front of the car trunk the secuency is continuos in the motor from left to right 1,2,3,4.

Dec 20, 2008 | 1998 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...