Question about Cars & Trucks

Open Question

No throttle response on 1.8focus 04 reg - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats wrong when car start but no throttle


does the engine stay idling with no response to throttle movement? or does the engine cut-out when the throttle is pushed?

Nov 26, 2015 | 1997 Chevrolet Cavalier

1 Answer

P2106 P2110 P2135 P1516


Here is what meens those codes:

P2106
Throttle Actuator Control System - Forced Limited Power

P2110
Throttle Actuator Control System - Forced Limited RPM

P2135
Throttle/Pedal Position Sensor/Switch "A"/"B" Voltage Correlation

P1516
Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

I beleive that there is, specifically for chevrolet aveo 2006 a technician service bulletins.

You should have it checked at gm dealer!!!

ask for
TSB Number: SB-08-06-04-004
TSB Number: 08-06-04-023

Jan 27, 2014 | 2006 Chevrolet Aveo

1 Answer

04 honda accord 3.0 V6, auto: MIL and both TCS lights on with loss of power


it sounds like a probem with the correlation of the throttle position sensor and the P.C,M, With the drive by wire system, throttle is no longer a command, but rather a request for throttle provided the P.C.M. gives the ok after taking readings from various sensors. this correlation for whatever reason goes wrong and often neds attention from the manufacturers mechanic for a relearn, which will relearn the throttles home position and correct the problem.

Dec 15, 2013 | Honda Accord Cars & Trucks

1 Answer

Misfire under all conditions most noticeable accelarating from stop


google the code, could be a million things when you put it like that. Reg is a cheap fix.

Jul 28, 2012 | 2003 Honda Odyssey

1 Answer

2004 hyundai santa fe parked it last night, went to use it today and it doesn't accelerate, engine runs fine, no warning lights on dashboard lit, can put it in gear and move it, but absolutely no...


The 04 Santa Fe came with three different engines. 4 cylinder (2.4 lit), and two different V6's (2.7 lit & 3.5 lit). The 2.4 & 2.7 use throttle cables connected directly to the throttle plate, but the 3.5 uses ETS (Electronic Throttle System) which uses two sensors (APS & TPS) and a control module (ETSCM). APS=Accelerator Position Sensor, TPS=Throttle Position Sensor, ETSCM= Electronic Throttle System Control Module. There are different diagnostic procedures for each system.
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, campaigns, illustrations and procedures, etc.

Sep 10, 2011 | 2004 Hyundai Santa Fe

1 Answer

Gmc w4500 with 5.2 L after driving loses throttle response and kicks code p1094 fuel rail pressure low at idle or deceleration


Follow this link. Hope it helps. Good Luck.
http://www.duramaxforum.com/forum/04-5-05-lly-duramax-powertrain/106-trouble-codes.html

Sep 28, 2010 | GMC W3500 Cars & Trucks

1 Answer

R reg Range Rover, There is a delayed response when accelerating from a standing start, then after a couple of seconds and a buried accelerator pedal it flies. Also, tick over seems very high. Any ideas on...


I would change your throttle position sensor (TPS) or at least check all related wiring, fuses and relays concerning this device. It is located on the outside of the throttle body at the end of the throttle plate shaft. Its function is to send a an electrical signal to the ECU that correspnds to the position of the throttle plate. Your TPS is not sending a signal to the ECU so the ECU does not know to inject more fuel in response to the throttle being opened. The call for more fuel in the absence of immediate input from the TPS is being made to the ECU by the Manifold air pressure sensor but this can a take a second or two to respond to pressure changes, hence the hesitation in acceleration. One really quick way to check is to simply disconnect the TPS electrical connector. If it were running normally you will notice an immediate change in engine idle, as your is faulty you will notice no difference

Jun 03, 2010 | 1997 Land Rover Range Rover

1 Answer

04 6. sometimes i have no throttle response accompanied with popping back through air intake and lots of black smoke out of the exhaust


I WOULD SAY TAKE IT AND HAVE IT HOOKED TO A DIOGNOSTIC SCANNER TO PIPOINT WHAT IT IS FOR SURE, IF THE CHECK ENGINE LIGHT COMES ON ESPECIALLY, BUT IT IS HARD TO GIVE AN ANSWER WITHOUT KNOWING IF IT IS A GAS OR DIESEL,I WASN'T SURE IF THE 04 6. AT THE TOP WAS MEANING IT WAS A 4.6 LITRE GAS ENGINE,OR IF IT WAS SOMETHING ELSE.

Dec 05, 2009 | 2004 Ford F350

4 Answers

On a 04 camry with 2.4 ltr engine, can I replace just the throttle position sensor or do i have to replace the entire throttle body? The engine code said faulty throttle body.


I think the terms "Throttle Positon Sensor", TPS and "Throttle Body" can be misleading at least in regards to the 04 Camry.

My 04 Camry gave a diagnostic reading of P2121 for my problem "Throttle PEDAL position switch D circuit". However, we changed out the complete Throttle Body/TPS (Toyota Part #22030-0H020) that did NOT fix problem.

The 04 Camry TPS Electronic Module "Throttle Positon Sensor" is factory assembled and riveted to the side of the throttle body. The only way to service/inspect it would be to cut off or drill out the rivets. Not sure you could open the darn thing if you got it off, but that seems to be the only way Toyota sells them!!

Hopefully a new Throttle PEDAL Position Sensor (Toyota Part # 78010-33010 PEDAL ASSY, ACC)
will fix it. This is located under the dash near the accelerator pedal.

So, now I would recommend FIRST to replace the "Throttle PEDAL Positon Sensor" (it is much, much cheaper) and then the Throttle Body/TPS assembly!! Unless of course, you get a diagnostic code as you did for "faulty throttle body!!


Nov 12, 2009 | 2004 Toyota Camry

1 Answer

Delay throttle response. Shifts to early


Changing out your rear end gears is not the solution to your problem. If you are unhappy with the way your automatic transmission shifts, your mechanic should be able to adjust the computer that controls it to shift differently through all the gears. If your problem is when you launch the vehicle from a stop, you should consider having the idle raised a little, that should fix your problem.

Jul 21, 2008 | 2008 GMC Sierra 2500HD 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...