Question about Cars & Trucks

Open Question

My picture keeps freezing but the programme continues playing.Why?

Derek

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to watch a programme on BBC I player and it keeps on freezing.


just get a dish ,,,, your internet connection isnt any good or the aerial connection if its over a wireless connection ,cannot beat a fibre or phone line connection

Dec 01, 2015 | Cars & Trucks

1 Answer

Where can I find a picture of the freeze plugs in the rear of the motor is a 96 4 cylinder Dodge Dakota


My research shows that your engine is most likely the 2.5 liter American Motors 4 cyl that was also used in a lot of Jeeps; Chrysler owned Jeep at the time. The 4 cylinder engine is basically the old AMC 4.0 liter 6 missing two cylinders; a very basic engine.
If you do a Google search for 1996 AMC 2.5 freeze plugs, you'll get lots of pictures. Here is one with the plug out which shows you which way to rotate the plug to remove it without damaging the cylinder:
imgp1541.jpg
You may want to spring for a brass plug if you are going to keep the vehicle. Also see the link below for some good tips on freeze plug installation.
Non typical Coolant leak Page 2 JeepForum com Freeze Plugs Tips For Leak Free Plugs Circle Track Magazine

Jan 31, 2015 | Dodge Cars & Trucks

2 Answers

2003 Chevy Trailblazer brake pedal not releasing. When turning and brakes tapped briefly they continue to brake until complete stop. When stopped and foot off brake 10 sec delay before pedal releases


Sounds like your ABS unit on its way out.
with the engine off, pump the pedal till its hard. keep your foot on the pedal pushed down and start the engine. your pedal should become light and continue down to the "floor".

Jan 12, 2015 | 2003 Chevrolet TrailBlazer

1 Answer

1996 ford contour cooling fan assembly


Hi Derek, I'm glad to help!
I'm not positive what your asking because it only says "Cooling Fan Assembly" But, if they are not working it's either the motor is bad or a relay that drives the motors is bad. Also on some FORD products I have found the wiring going to the motor melted away and has no insulation on them and they touch together and blow the fuse if applicable. Hope this helps and have an awesome day Derek.

Apr 20, 2013 | Cars & Trucks

2 Answers

Show me a picture where the fuel pump relay is located on 1994 Acura Legend?


selectachapter.gif

Acura Coupes and Sedans 1994-2000 Repair Information

PGM-FI Main Relay

Print
This relay is located behind the dashboard's lower cover. It consists of two individual relays. One is energized whenever the ignition is ON , thus supplying battery voltage to the Powertrain Control Module (PCM). This relay also supplies voltage to the fuel injectors, and power to the second relay. The second relay is energized for two seconds, when the engine is turned ON , to power the fuel pump.
See Figure 1

0900c1528008be04.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 1: Schematic of the PGM-FI relay
Testing
If the engine starts and continues to run, the PGM-FI relay is working and does not need to be replaced.
See Figure 2

0900c1528008be05.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 2: PGM-FI relay terminal numbers

  1. Remove the relay.
  2. Apply battery voltage to the number three terminal.
  3. Ground the number two terminal.
  4. Check for continuity between terminals five and two.
  5. If continuity is detected, proceed to the step 7.
  6. If there is no continuity, replace the relay.
  7. Connect the number four terminal to the positive side of the battery.
  8. Ground the number two terminal of the relay.
  9. Check for continuity between the number five terminal and the number two terminal of the relay.
  10. If there is continuity, the relay checks out "OK". If the fuel pump still does not work, test the harness.
  11. If there is no continuity, replace the relay and retest.

Mar 11, 2013 | Cars & Trucks

1 Answer

Fuel gauge broken


Hi Derek,sounds like your fuel sending unit is not working,it states that the fuel pump has everything built within and that has to be replaced.Here a picture of pump,look at picture and the wire with black piece on it is the fuel sending unit,sends signal to gauge letting it know how much gas is in it.Here's a link on it.Here's how to replace fuel pump.

Feb 17, 2013 | 2007 Hyundai Santa Fe Limited

1 Answer

Keeps needing antifreeze and no leaks


You didnt state year make or model of it. But if you take pictures and mark everything you should be fine.when taking things apart be aware of bolt lengths.take cardboard and trace the part pop a screwdriver thrue the bolt holesand put the bolts thrue cardboard cutout.

Jul 29, 2017 | 2002 Chevrolet Silverado

1 Answer

Maxda RX8 2003 model - Power steering hard when engine is cold and ok when engine get hot. Do I need to change the power steering rack?? Derek derek.narainen@gmail.com


does it have the right grade of oil in the pump ,has or it have been topped up with the wrong grade oil??if anything i would say the pump??

Mar 02, 2010 | 2004 Mazda RX-8

1 Answer

6.6 diesel LB7 oil


Derek.

it takes 10 quarts of oil in 15w40. I have the same year GMC and i have had no issues other than my carrier bearing went out today.

Jul 07, 2008 | 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...