Question about Cars & Trucks

Open Question

What is the psi pressure on a fuel pump for a 2000 kawasaki zx9r

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 220 Answers

SOURCE: fuel pressure problem.I replaced the fuel pump on 2001 chevy s-10

Most fuel injected vehicles have a relay that controls the fuel pump so after the ignition switch has been on for about 5 seconds and the engine is not running, the fuel pump automatically shuts off.
I don't know what your original problem was, but I think if the car runs normally, you have probably fixed your problem. If you don't have a manual, you can probably go to the library and take a look at a manual that covers your vehicle.

Posted on Jan 16, 2009

  • 5 Answers

SOURCE: Where is the fuel pressure regulator located on an 2002 f150 v6?

in the center of the motor,in the rear on the fuel rail

Posted on Jan 19, 2009

  • 1118 Answers

SOURCE: 2000 gmc jimmy wont start fuel pump comes on and cuts off...

When you hook the pressure test guage to shrader valve on fuel rail what it reads is what the pressure is from pump, around 60 p.s.i. all you need to do is hook up the guage and turn on key, you do not have to turn engine over, and if pump is good it will shoot up to 58 or 60 right now.

Posted on Feb 14, 2009

  • 333 Answers

SOURCE: low fuel pressure 1996 savana 5.7 V8 central sfi

The only thing left in this system is the fuel pressure regulator. You need to check pressure before the regulator and after the regulator if there is the problem then you need to replace it. I hope this helps. Don't forget to rate my answer.

Posted on Feb 18, 2009

66 chrgr
  • 1011 Answers

SOURCE: 2000 gmc jimmy wont start fuel pump comes on and cuts off...

the fuel pressure if leaking could cause this the regulator is located under the intake plenum but you should smell gas .if you dont then most likely the pump is bad ,the pump will come on for 2 seconds when the key is on then go off it will not stay on with just the key on only when you crank it will it .so have your fuel pressure checked with a gauge.

Posted on Mar 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How much pressure should the fuel pump on a 2000 gmc jimmy sle 4+4 4 door


Between 55 and 63 psi with ignition in on position and fuel pump energized not less than 45 psi upon 5 minute bleed down with pump not energized.

Oct 22, 2014 | 2000 GMC Jimmy

1 Answer

2000 Mercury Sable double overhead cam/car starts 7has 35psi fuel pressure/pressure drops to under 20 psi & motor stops running. What would cause the fuel pump to shut down? Runs & maintains


It is likely the fuel pump is defective. It never produces the correct pressure based on the readings you presented here, it should be 42-44 PSI at idle and then when you throttle the engine it should go up to about 50 PSI, never down. To change the pump you must remove the gas tank from the car, this takes special tools (fuel line release tool) and a helper for sure. About 3 hours on the ground. This is a guess on my part and I caution you to have it checked out by the dealer before any parts are replaced.

Sep 13, 2012 | 2000 Mercury Sable

1 Answer

2000 blazer,idles and revs up fine in park,put it in drive it has no power


Check your fuel pressure it should be 60-66 psi with key on and engine off.If its below 52 psi replace the fuel pump and filter.Sounds like it maybe a weak fuel pump.

Dec 28, 2011 | 2000 Chevrolet Blazer

1 Answer

I want to know what's the normal pressure on the 2000 expedition fuel pump


Here is the normal fuel pump pressures for the 2000 Ford Expedition with the 5.4L SOHC Vin L >>

Key ON Engine OFF (KOEO) 35-45 psi Key ON Engine Running (KOER) 28-45 psi

Here are your pressures if this is the 4.6L SOHC >>

Key ON Engine OFF (KOEO) 30-45 psi

Hope this helps with your concern...

Sep 13, 2011 | 2000 Ford Expedition

1 Answer

How do I check the fuel pressure on a 2000 model mazda millenia with a 2.3 engine in it


Hi.

You connect a fuel pressure gauge like this to the pressure rail. Pressure in this car must be between 35 and 45 psi. If pressure is too low look for kinked fuel lines and eventually replace the pump. If the pressure drops down more than 10 psi in five minutes or if the pressure is considerably higher than that replace the fuel pressure regulator. Below the parts that may need testing:

ginko_261.gif

1. Fuel tank
2. Shut-off valve
3. Non-return valve
4. Fuel pump
5. Fuel pump (Transfer)
6. Fuel filter (High-pressure)
7. Injector
8. Pressure regulator
9. PRC solenoid valve
10. Fuel pump relay
11. Fuel pump resistor and relay (KJ model)

Aug 04, 2011 | 2000 Mazda Millenia

1 Answer

2000 oldsmobile intrigue fuel pump pressure


most in tank pumps deliver generic pressure of between 60-90 psi. the pressure needed for specific models is set and kept by the fuel pressure regulator located in the gas supply line up near the intake manifold (maybe with a vacuum line running to it), usually in the 18-45 psi range. your local auto parts store can give you your specific information, as can the parts desk person at your local dealership.

Sep 04, 2010 | 2000 Oldsmobile Intrigue

3 Answers

Car loses power, feels very sluggish, jerks back and forth. what could be the problem.


FUEL FILTER STOPPED UP OR FUEL PUMP WEAK CHECK FUEL PUMP PRESSURE IT SHOULD BE.FOR 2.2L ENGINE FUEL PRESSURE 55 - 65 PSI THE 1.9L FUEL PRESSURE 31 - 36 PSI THE 3.0L ENGINE FUEL PRESSURE 39 - 49 PSI.

Aug 05, 2010 | 2000 Saturn SL

2 Answers

What is the fuel pump pressure for a vortec 4.3l engine on a 2000 Sonoma gmc


2.2L Vin 4.... 41-47 psi Ignition switch is on and fuel pump running
2.2L Vin 5 ... 55-60 psi " "
4.3L Vin W .. 60-66 psi " "
4.3L Vin X ... 60-66 psi " "

Feb 07, 2010 | 2000 GMC Sonoma Extended Cab

1 Answer

Fuel pressure problem


theres 2 options,voltage feeding pump is fluctuating,or pump itself is going bad!

Apr 17, 2009 | 2000 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...