Question about Chrysler Town and Country

Open Question

Were is the speed censer at on a 2002 3.8 town an country

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

short shadey
  • 421 Answers

SOURCE: location of the speed sensor on 1996 town & country

they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff

Posted on Sep 04, 2008

  • 76 Answers

SOURCE: 2002 Chrysler Town and Country

Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug

Posted on Nov 18, 2008

chryslertech
  • 115 Answers

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Posted on Mar 08, 2009

defadad
  • 351 Answers

SOURCE: removing and replacing passenger side mirror 2002 town and country van

there should be a triangle shaped plastic section on the interior of the door behind the mirror, check it for a little plastic screw cover to remove it or you may just have to lever it gently to remove it.
once it is off it exposes the mirror retaining bolts which you undo to remove the mirror, I presume it has electric mirrors and if that is the case you will have to find the electrical wire plug for the mirror and pull it apart, replace mirror in reverse order of removing

Posted on May 13, 2009

  • 240 Answers

SOURCE: Front climate control blower only works on high speed.

Replace your blower motor resistor
Resistor located under dash on passenger side in screwed into blower housing. May be able to be repaired. Requires soldering a small piece of "unmelted solder" across where the old fusible link was. look carefully at resistor. Or else just replace. Buy new. Junkyard resistor likely to be as bad as yours.

Posted on Jun 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air bag icon stays on


you most likely have a bad air bag censer has his model been in a crash is so you may have to have it reset. take tit to a shop or dealer se if they can reset censer if that don\'t fix it replace censer is next step

Aug 19, 2014 | 2003 Chrysler Town & Country

1 Answer

Can I put a 2003 town & country transmission into a 2002 town & country


most likely it will fit unless the manufacturer changed the application that year but its not likely suoldnt be a problem

Mar 03, 2013 | 2002 Chrysler Town & Country

1 Answer

Where is the speed sending unit located on a chrysler town and country


transaxle has two speed sensors input speed sensor located behind transaxle cooler lines the output sensor located far right transmission case driver side.

Jan 04, 2013 | 2002 Chrysler Town & Country

2 Answers

What controls the odometer on a 2002 Town and Country


most likely the instrument cluster. you can bring the vehicle into any chrysler dealer and have them run tests on it.

Oct 18, 2012 | 2002 Chrysler Town & Country

1 Answer

My front blower on my 2002 Town and Country won't shut off. It blows full speed any time the van is running.


replace blower motor resistor located behind the glove box apro 2 x 3 in 2 screws and wire

Jan 19, 2011 | 2002 Chrysler Town & Country

1 Answer

2002 Chrysler Town and Country Rear Heat/Air only on High


most of the time the resistor is located downwind of the blower motor so it should be not to fao from the blower motor in the right rear of the van behind the quater trim panel which is the hvac unit is located

Jun 01, 2010 | 2002 Chrysler Town & Country

1 Answer

2002 town & country blower motor will not


In order to achieve different speeds for the fan motor, there is a bank of resistors that reduce the voltage depending on what speed is selected. This is basicaly the same design for all cars on the road. The fail mode causes the full voltage to bypass the resistor bank so the fan runs at high speed (maybe even higher than your normal high setting). On most newer vehicles, including your '02 T&C, to help keep the resistors cool, they are mounted to a heatsink and then that assembly is mounted in a hole in the A/C ductwork just below or behind the glovebox. My '02 T&C has the 3 zone auto temp control and it had a fancier resistor block, but the function is the same. You should be able to get the cheaper one for <$25 at a parts store.

Apr 21, 2010 | 2002 Chrysler Town & Country

1 Answer

Front climate control blower only works on high speed.


Replace your blower motor resistor
Resistor located under dash on passenger side in screwed into blower housing. May be able to be repaired. Requires soldering a small piece of "unmelted solder" across where the old fusible link was. look carefully at resistor. Or else just replace. Buy new. Junkyard resistor likely to be as bad as yours.

Jun 13, 2009 | 2002 Chrysler Town & Country

2 Answers

Speedometer not working


normally read off your rear wheel abs sensor

Jan 14, 2009 | 2002 Chrysler Town & Country

2 Answers

2002 chrysler town and country wont leave limp mode


try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 to 200 dollars but it should fix your problem.

Dec 31, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...