Question about Cars & Trucks

Open Question

2007 jetta 2.5 in hot days pwer windos dnt wrk directional ligths dnt wrk. 1.- engn stp. 2.-WHAIT 25 mins car strt again and keep doing it ONLY ON HOT DAY's NO CHEK ENGINE LIGTH. Please HELP

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76164 Answers

SOURCE: check engine light on after

You have a leak in the fuel system somewhere or a bad evaporative system sensor, the way the system works is the control module for the emission system pulls a vacuum on the gas tank and lines to check for leaks, if it can't get a certain vacuum level for a specified time it decides there is a leak and the check engine light comes on. This may be covered under the Federal Emissions warranty, call the dealer and inquire if the Evap System is covered.

Posted on Aug 27, 2008

Ad
66 chrgr
  • 1011 Answers

SOURCE: 2004 sebring 2.7 engine, will strt when cold but not when warm

more than likely a bad crank sensor but not knowing if there are codes might also be a cam sensor,it is deffently a electrical componet problem hot soak of the motor will break down bad electrical sensors,

Posted on Jan 25, 2009

  • 1 Answer

SOURCE: 2007 Nissan Navara Service ligth reset.

You will need to send the navara workshop it needs to be hooked up to a special computer to be reset.

Posted on Mar 30, 2010

  • 4793 Answers

SOURCE: My ASR ligth keeps coming on and the cars slows

A.S.R. is anti slip regulator,it is connected to the abs system so that when you are on a loose surface the wheel that is loosing grip slows down until traction is achieved,SO, if you accelerate really hard.and you get wheelspin,the car basically shuts down until you get full traction.feels funny but you wont get fined for tyre squeel.try putting two wheels on grass and two on tarmac then flooring it........

Posted on Apr 13, 2010

  • 1 Answer

SOURCE: 98 jetta will not start on hot days

I have same problems on my 96 jetta. Did anyone get this fixed?

Posted on Aug 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 jetta didnt have key so hot wired, ran fine for few days and just wont start now , why?


The 97 Jetta has a built in security system and if you hot wire anything it interferes with it and will shut the car down and will not start again. Un hook the battery and wait 5 mins and then hook it back up. The alarm might go off so use the key to turn it off and then try to start the car. That should fix it and if not I cannot fix it without seeing it. Sorry and hope that it works for you. It has happened to me when I switched out my stereo with an aftermarket one.

Jun 19, 2014 | 1997 Volkswagen Jetta

2 Answers

Instructions on how to use holts wondarwald


Holts Wondarweld
Flush engine.
EXTERNAL CRACKS
1 Run engine until hot,drain off enough coolant to remove thermostat.
2 Remove thermostat.
3 Mix contents of can thoughoughly! and pour contents into thermostat opening.
4 Replace thermostat cover.& fill radiator with hot water,replace radiator cap.
5 Run engine at a fast idle for 15 mins,dont allow to boil.Top up if necessary.
6 Leave Wondarweld in system for 2-3 days then drain off,flush system replace thermostat and refill.
HAIRLINE CRACKS
1 MIX thoroughly and pour into cold engine (radiator if it has a cap)
2 Run engine until hot.
3 Allow engine to cool then run again until hot.
4 Follow procedure 6 above.
INTERNAL CRACKS
1 Follow external crack instructions except after pouring Wondarweld into engine remove spark plug from
affected cylinder and run engine for 20 mins. If more than one cylinder affected run for 5 minute intervals.
2 Allow engine to cool then drain cooling system and refill with clean water.
3 Drain sump & flush,refill with fresh oil.
Note:- 1/2 pint of Wondarweld for every 6 pints of water,DO NOT add antifreeze for at least 3 days after process.

Aug 05, 2012 | Cars & Trucks

1 Answer

I use to start truck for about 25 min before I go to wrk and I turn on seat warmers and they would stay on now they dnt stay on for more than 20 seconds what could it be


There should be a relay for the heated seats. It may be faulty, or detecting an overheating problem and shutting down. Find the relay and replace it with a new one.

Dec 29, 2010 | 2004 Chevrolet Tahoe

2 Answers

Starts well,runs wellfor five mins but then cuts


My first guess would be the fuel filter. It is probably almost completely plugged.

Oct 23, 2009 | 1991 Volkswagen Passat

2 Answers

VW Jetta starts, then turns off immediately


try checking the throttle position sensor or the idle control valve both can keep it from running.

Aug 26, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

2004 sebring 2.7 engine, will strt when cold but not when warm


more than likely a bad crank sensor but not knowing if there are codes might also be a cam sensor,it is deffently a electrical componet problem hot soak of the motor will break down bad electrical sensors,

Jan 23, 2009 | 2004 Chrysler Sebring

3 Answers

2000 Jetta Heater Not working


2000 jetta warms up when idling, but gets cold as soon as I start driving.

Dec 17, 2008 | 2000 Volkswagen Jetta TDI

1 Answer

1999 buick century limited


if your caar is a v-6 or 6 cylinder motor you might have a injector shorting when hot this is very coming on those cars and very very hard to find from mechanics i'm a ase certified tecnichian and had found this as coming problem on this cars
you can ask to a mechanic to check the resistance on the injectors or when it happens again unplug one by one and see if car runs again if it does then replace all the injectors
because shops will keep trowing parts and labor trying to guess

May 31, 2008 | 1999 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...