Question about Hyundai Cars & Trucks

Open Question

I have a 1.2 Hyundai that has a squeak when the steering wheel is deployed it is not a constant squeak.Do you know what is causing this/

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 82 Answers

SOURCE: squeak in front wheels

jump on the corner of the car that the side the noise is coming from then jump off and see how many times it bounces till it stops if it bounces 3 times to well then your front shocks are bad.

Posted on Feb 25, 2009

USfalcon
  • 175 Answers

SOURCE: Chirping in steering wheel of 2007 Hyundai Santa Fe

bad p/s belt or need tide

Posted on Mar 17, 2009

  • 6982 Answers

SOURCE: steering wheel squeaking

they do that sometimes...Usually if you take some silicone spray and squirt it all around the area where you can hear the squeak,it will go away.

Posted on Mar 20, 2009

  • 2 Answers

SOURCE: squeaking noise in steering wheel

check your CV joint

Posted on Mar 30, 2009

emissionwiz
  • 75797 Answers

SOURCE: FRONT END SQEAKING

worn out strut tower bearings.

Posted on Apr 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08 Scion xD release series my horn honks by itself when I turn or if you pull on top of steering wheel what is causing this and could it possibly cause my air bag to go off


Inside the steering wheel the button for the horn has springs that can break or become weak when turning the weight of the air bag causes it to make contact and honk. The air bag will not deploy because of this but if you are planning to repair it be sure to disconnect the battery completely and wait ten minutes before attempting to disassemble the steering wheel. Failure to do this can cause the airbag to deploy possibility causing injury to yourself

Oct 25, 2016 | 2008 Scion Xd

2 Answers

Service air bag indicator light on dash stays on


In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to disarm the airbag system can result in an unexpected Airbag deployment and possible serious personnel injury disconnect the battery 30 minutes prior to start of work.

Sep 22, 2010 | 2005 GMC Sierra 2500HD 4WD

2 Answers

2002 chevy truck.Code B0026


Hello and welcome. code B0026 is for a airbag malfunction. this code will require a high end scan tool, like a GM tech 2 scan tool to check out.this code is related to a deployment loop problem on the drivers side of vehicle

• DTC B0026 will set when one of the following conditions occurs:
- The SDM detects the steering wheel module deployment loop resistance is greater than 4.8 ? for 500 milliseconds. - The SDM detects the voltage at steering wheel module high signal is less than 2.4 volts and steering wheel module deployment loop resistance is 6 ? or greater for 500 milliseconds.The inflatable restraint steering wheel module deployment loop consists of a steering wheel module, steering wheel module coil, steering wheel module high signal circuit, and steering wheel module low signal circuit. Shorting bars are used on the steering wheel module connector as well as the steering wheel module coil connector which will short together the steering wheel module high and steering wheel module low signal circuits when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing. When the ignition is turned ON, the inflatable restraint sensing and diagnostic module (SDM) performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, a DTC will be stored.

Sep 12, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

2003 Sante Fe air bag light stays on. Air bag has never been deployed.


in steering colunm have an clockspring wire , this is broken, to replace remove the steering wheel, go to workshop

Jul 30, 2010 | Hyundai Santa Fe Cars & Trucks

1 Answer

Recently when I started my car and move my steering wheel I hear a squeaking noise. The weather has been cold and snowy. Does this noise happen because of the weather?


THIS IS CAUSED BYTHE PLASTIC COVERS RUBBING ON THE SHAFT, IF U SPRAY SOM LUBERCANT ,LIKE WD40 OR SPRAY WAX IN THE AREA THE NOISE WILL GO AWAY , YES ITS THE COLD CAUSING IT , TRY DIFFERENT POSITIONS FOR THE STERING WHEEL

Feb 16, 2010 | 2004 Hyundai Elantra

2 Answers

2004 Mazda tribute steering wheel squeaking


Well a steering flush would not necessarily be related to squeaking.

So, you need to locate exactly where the sound is coming from...
It really sounds like steering wheel turning and resistance causes the noise, is this constant, or only while actually turning the wheel?

Likely it would be semi constant, so that would focus you on the assist portion... Be careful around all moving parts, but you need to locate the source.

Try taking a section of heater hose, and listen through one end and move carefully around with the other end and see what you find. Likely something under the hood, with your note about window open...

Now, if the squeaking stops when the steering wheel stops turning, now steering components are suspect.... So, again, louder with window down makes me think outside and in front...I would stand in front of the car, have your handy assistant actuate the steering wheel, and you decide which side, right or left.... Suspect items that squeak only during steering wheel input include, amongst other things, the entire strut, all ball joint, including joints in the steering linkage.... Be sure to keep clear of moving parts, your handy assistant would not know they they are crushing you, while truning the wheel......

Doc


Sep 19, 2009 | 2001 Ford Escape

1 Answer

Squeak in front wheels


jump on the corner of the car that the side the noise is coming from then jump off and see how many times it bounces till it stops if it bounces 3 times to well then your front shocks are bad.

Feb 25, 2009 | 2000 Hyundai Sonata

2 Answers

2000 Montero limited steering column noise / squeaking


try spraying some armor all where wheel meets the column covers

Dec 18, 2008 | 2000 Mitsubishi Montero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...