Question about 1995 Nissan Altima

1 Answer

I recently had my whole engine rebuilt on my 95 altima se and now the rpm gauge is going crazy but the car is running just fine

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 784 Answers

Your rpm signal shares the same connection with the primary coil terminals. Take off the contact connections, and clean metal parts with small grid sand paper. Put them back and tighten securely. It should be OK. If it is not, then there is a problem with the display. Good luck.

Posted on Jul 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

MY 2003 NISSAN ALTIMA SE MAKES A CLINK NOISE WHEN ACCELERATING AT ABOUT 1700 RPM AND 2500 RPM OR GOING UPHILL ,NO NOISE WHEN REV UP OR IDLE OR TAKING OFF FAST


Wheel nuts loose, or stones in hub caps, do you get the noise rolling down hill ? , if not its engine, retrace your repair.

Nov 21, 2014 | 2003 Nissan Altima

3 Answers

When the gas is applied the car will stall and the rpm gauge will go up and down


Check the air inlet tube for cracks. Duct tape will work in a pinch.

Sep 01, 2014 | 1992 Honda Accord

1 Answer

4runner RPM gauge needle going crazy


Check your Alternator. If itis charging and arcing inside the case, the gauges like rpm can malfunction.

Mar 29, 2012 | Toyota 4Runner Cars & Trucks

1 Answer

Relearn idle on 2003 nissan altima


Does the fuel gauge work properly? Recently had to have fuel sender unit replaced and Nissan dealership service to reset the idle learn on 03 Sentra SE-R Spec V. Engine idle rpm would go up and down as a result of bad sender.

Dec 18, 2010 | Nissan Altima Cars & Trucks

2 Answers

One by one my gauges(rpm,gas,speedometer,oil) stopped working. Is there a sensor that needs replaced? a fuse? dash? Help?


please keep me posted as well, ALL my gauges are doing the same. First the gas, filled it one day and it fell all the way and light turned on, then my themostat, freaked me out, thought i was overheating,...NO just the guage, NOW my spedometer is stuck on 120, and my RPM's are acting crazy. i have read tons with this same problem, WHY WONT the manufacturer DO SOMTHING??

Aug 25, 2010 | 2004 Isuzu Ascender

1 Answer

Heater only works when driving at a certain rate of speed


As crazy as this may sound, your water pump could be going bad. At higher RPM's the pump spins faster, keeping pressure on the system. Does the engine temperature gauge show that your car overheats while idling? The water pump may not have the power to push coolant or heat through your car's system until you're driving at higher speeds. The blades in the water pump could be broken.

Jan 02, 2010 | 2005 Nissan Altima

2 Answers

2003 Nissan Altima stalls at intersections/ stops


sounds like your carb is getting to much air some where check your hoses

Sep 20, 2009 | 2003 Nissan Altima

1 Answer

1996 3.1L Pontiac Grand AM all gauges went crazy


sometimes when the battery is too low the gages will go haywire.check you battery terminals for good conductivity and current levels. sounds like a low current problem.computer runs on 12 volts not 11 or 10. low current will give poor performance and bad electrical response.
try that first then look for shorts under the dash ie naked wires or burnt wires.
good luck.

Jun 02, 2009 | 1996 Pontiac Grand Am

1 Answer

95 Mustang gt backfiring and RPM's bouncing


sounds like you have jumped a tooth on the timing if not timing out

Feb 02, 2009 | 1995 Ford Mustang

Not finding what you are looking for?
1995 Nissan Altima Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...