Question about Cars & Trucks

Open Question

Good morning please help how do I fix a fault code p2014-001 on my 2006 merc c200 kompressor

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

lastech
  • 408 Answers

SOURCE: I haven't fuse papers layout for mercedes c200 2002

hello,you can order to your dealer a fuse designation,it"s size of standard paper,ty

Posted on Apr 20, 2009

jasperoni
  • 203 Answers

SOURCE: My 2003 mercedes kompressor C200 key is not working!

the key's are special order and they are fairly expensive. Test the voltage in your remote batteries. They should be 3 volts. These systems are very voltage senstive and require a good battery to operate properly. I'm assuming you have the original batteries in the remote now and it is 6 plus years old. These batteries generally last 3 years so it is definatly time if you have not replaced them yet!

Posted on Jul 17, 2009

  • 1 Answer

SOURCE: mercedes benz c200 (w202)gearbox fault

There is a special additive lubricant for gear transmission to solve this problem. Just add on to gear oil. I had the same problem. now ok.

Rajapal, Malaysia

Posted on Aug 01, 2009

merctechniqu
  • 229 Answers

SOURCE: my c200 kompressor has a problem with the ESP,how

In your car Electronic Stability Program system included many different sensors (yaw-rate sensor, steering angel sensor, body acceleration sensor, some more) if ESP visit Workshop message appear on your instrument display It's very hard to say witch sensor could be the fault without right diagnose most common faults are either steering angel sensor or yaw-rate sensor might be some other sensors if you replace yaw-rate sensor it's need to be calibrate by diagnose computer, if replace steering angle sensor it's need to do right way otherwise when you tern steering wheel fully left or right it will brake at first time then you have to be replace another one so like to advise you to get right diagnose and repair buy Mercedes specialist if do some thing wrong it's be more cost to you if you get right place to do it only you have to pay once.

Posted on Oct 12, 2010

Testimonial: "checked from some other sources and the information matched..thank you.."

  • 213 Answers

SOURCE: my 2001 c200 kompressor shakes

see plug wires HOW at night start the engine open the engine hood it should be dark so that you can see any spark on the cables

Posted on Jan 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

RUNS LIKE A DREAM BUT STOOD AT TRAFFIC LIGHTS STARTS BY REV NEEDLE JUMPING UP AND DOWN WANTING TO CUT OUT LIKE HOLDING BACK IT KEEPS SAYING ON CODE READER MASS AIR FLOW METER IVE CHANGED IT TWICE


The fault code is not saying to change any part, it indicates that a fault is in the system of the sensor, that can be the sensor, the wiring or the computer control module. Stop guessing consult a professional;

Oct 18, 2016 | Mercedes-Benz C-Class Cars & Trucks

1 Answer

Where can I download 2002 Mercedes-Benz C200 Kompressor Factory Service Manual


Think you will have too pay for this ,although you could try direct connect file sharing ,the programme for which you can download free from www.sourceforge.net ,but to join a hub for sharing you will need to have plenty on your computer to share like films and music ect

May 30, 2015 | 2002 Mercedes-Benz C200

1 Answer

Where is the IDplate


depends on the age of vehicle but many vehicles do not have one anymore ,mtheir should be a sticker in the front door frame with the homoglonation number and the chassis number with the weights ,all europeon made vehicles will have this ,but to check the vehicle for the annual mechanical inspection then the number stamped in chassis is checked which on a merc is normally under the bonnet ,but some models its in the boot to the right of the spare wheel --

Mar 12, 2015 | Cars & Trucks

1 Answer

Merc w203 with fault code p2002


On cars with "fly by wire" throttle pedals this is a fairly common failure of the TPS to sync with the throttle pedal sensor, and often caused by something as simple as crud building up on the throttle body plate keeping it from fully closing.

Jan 07, 2015 | 2002 Mercedes-Benz C200

1 Answer

Merc 180 kompressor . airbag fault codes erased , light wont go off


NOT A D.I.Y. PROJECT!!!!! ONE WRONG TEST LIGHT PROBE OR BACK PROBE...AND YOU WILL DETONATE THE AIR BAG(S) AGAIN!
SHOP......MY ADVICE...UNLESS YOU HAVE ALOT OF MONEY!

Mar 09, 2013 | Saturn L-Series Cars & Trucks

1 Answer

I recently purchased a C200 Merc with 162 000 Km. On two ocassions the car lost power and began to idle roughly. It would not accelerate at all and barely moved. A few moments later everthing went back to...


most possibly it could be the air mass sensor ( air flow meter) first check air flow meter, if you get in to the workshop and fixed the diagnose cpu you can see the fault code, if not the air flow meter next have to check crank angle sensor, if you check the fault code you can see what's wrong, if the fault code like mixtcher information retch or Lin replace air flow meter,

Oct 17, 2010 | 1998 Mercedes-Benz C-Class

4 Answers

What do i need to service my car mercedes benz c200 kompressor?


i have a Mercedes Benz C200 Kompressor , I just changed the plugs, air filter and oil filter and put new oil, but it's now miss firing badly can some one out there help?

Sep 08, 2010 | 2000 Mercedes-Benz C-Class

3 Answers

My c200 kompressor has a problem with the ESP,how can i fix it?


In your car Electronic Stability Program system included many different sensors (yaw-rate sensor, steering angel sensor, body acceleration sensor, some more) if ESP visit Workshop message appear on your instrument display It's very hard to say witch sensor could be the fault without right diagnose most common faults are either steering angel sensor or yaw-rate sensor might be some other sensors if you replace yaw-rate sensor it's need to be calibrate by diagnose computer, if replace steering angle sensor it's need to do right way otherwise when you tern steering wheel fully left or right it will brake at first time then you have to be replace another one so like to advise you to get right diagnose and repair buy Mercedes specialist if do some thing wrong it's be more cost to you if you get right place to do it only you have to pay once.

Sep 03, 2010 | 2002 Mercedes-Benz C-Class

1 Answer

Mercedes 1999 c200 key fob


Hello Haq!
Could it be the key just needs re-coding? maybe you are worrying to much as £177 would be about right as that would need coding etc., Try phoning your local Merc dealer or take the key and V5 to them for coding (Hopefully)
Good Luck!
Paul 'W'
Onyer~EDson(:0)~[><

Jan 06, 2009 | 1998 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...