Question about Cars & Trucks
You have to "prove" to the vehicle that you have the keys! So lock the doors using your key, then unlock the driver's door, then get in and start the car using your key, then turn it off, take the key out, lock all the doors and close them. That should reset the security system.
Posted on May 11, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Are you using the original key that came with the car? The chip in that key may have gone bad. Try using the spare key that should have come with the purchase of the car. You may also be having battery issues. If all else fails....call the people who really know how to rape you...DUM Dum dummmmm....the dealer
Posted on Dec 31, 2008
There will be adjustment screws located on at least two different spots surrounding each headlamp. By turning these screws you move the angle of the headlamp. Most shops will do this at a very resonable rate, I say this because improper headlamp angle may lead to a ticket, or at least a warning. To say the least, they have to be at specific angles and heights. Good luck.
Posted on Feb 20, 2009
the battery is located in the trunk under the carpet where the spare tire is located, loosen the 10 mm nuts on the terminals and pull them off, gently pull the vent hose from the battery, loosen the bolt for the battery hold down, usually a 13mm or 15mm, remove battery and reverse the process to install
Posted on Jun 19, 2009
Start with the basics. Check the fuses (all of them) with a test light and be sure you have power to each and that they are good. Then be sure that the power lock relay is good by swapping it with another relay in the fuse block. If the fuses are good and the relay is swapped and the locks still aren't functioning, you may have an issue with the BCM. The BCM can be programmed to change the behavior, but if the car has had water damage, or other stress to the BCM (voltage, heat, etc.), it can sometimes damage the BCM and you will need to replace it and reprogram it at a GM dealership.
Posted on Jul 25, 2009
Fault with the IAC valve.there maybe a trouble code associated with it also./ Go to your nearby autozone or auto parts retailer and ask them to put a scanner to the car....make note of the codes if any are found. the IAC valve i usually locate don the throttle body and can be removed for inspection and sometimes cleaning using a good throttle body cleaner spray and a pipe cleaner brush.
Posted on Aug 04, 2009
Tips for a great answer:
Oct 04, 2014 | 2006 Chevrolet Cobalt
Feb 25, 2014 | 2005 Chevrolet Cobalt
Mar 15, 2013 | Cars & Trucks
Oct 18, 2011 | 2006 Chevrolet Cobalt
Apr 13, 2011 | 2006 Chevrolet Cobalt
May 27, 2010 | 2006 Chevrolet Cobalt
Sep 26, 2009 | 2006 Chevrolet Cobalt
Jun 27, 2009 | 2006 Chevrolet Cobalt
Jun 10, 2009 | 2007 Chevrolet Cobalt Coupe
27 people viewed this question
Usually answered in minutes!