Rex-v871 receiver will not turn on

Get service repair manual (https://www.alldatadiy.com/?affiliate_id=93770&click_id=3235271354&clickId=3235271354
Then learn how to trouble shoot electrical circuits .
https://www.youtube.com/watch?v=SO-eKuhCOqc
This is what it taked to fix automotive electrical problems .
https://www.youtube.com/watch?v=9oM8_U0rB9A

Guessing doesn't work ,that's most of the answers you'll get on here ,guesses

Hey Ron,
AN internal combustion engine requires three (3) things to run...assuming the internals are good.
1. Adequate compression >120PSI
2. A properly timed spark
3. A proper fuel/air ratio

Start with one, and eliminate one at a time(make sure it works) - ..(this is the way a professional would trouble shoot an engine).

Sounds like a bad connection on wires cooking from fuel pump in fuel tank, of a loose ground wire.

If your other blinkers work ,it's not the flasher . Probably a wring problem or the bulb . Find a wiring diagram at www.bbbind.com an trouble shoot the circuit . Look at you tube , there are a lot of basic electric trouble shooting videos , an a few on reading wiring diagrams .

Do you get any action when you turn the key? A click?
Check battery. Dead battery is the first thing to check for. Headlights come on full brightness? Try jumping it?
If shifter won't move, what is it stuck in? If auto, stuck in "park" may simply be that the parking brake is holding tension against the parking gear's workings. If stick, similar, but pressing clutch should clear.

I had a similar experience and I had to replace the PTO.
What size motor do you have and what brand is it?

a jeep phone?

http://groups.yahoo.com/group/villagerquest/

switch at the brake pedel or loose earth at the loom on brake lights. hope this helps ( rate me thanks )

Yes replace your fuel pump relay,first