Question about Citroen Cars & Trucks

Open Question

Can anybody help my Citroen picasso2001 when run for about30 minuits it starts to rev up verry bad funtill I turn engine of for about 2 minuits then it runs ok after entering body no what it could be

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 702 Answers

SOURCE: Citroen C15 Diesel Van.

It definitely sounds like the electrical part of your ignition isn't working properly.When you turn the key, the lck and tumbler turns on the ign. switch in which sends power to the rest of the car.

Posted on Jun 23, 2008

short shadey
  • 421 Answers

SOURCE: Engine whine noise

most likely a belt tensioner or pulley take some penetrating oil and spray the center of each pulley one at a time if the noise stops you got your bad pulley if not take the belts off the motor and spin everything by hand to feel or hear any grinding noises if you still don't feel anything run the motor (not for more then a minute) with the belts off and if the noise is still apparent your timing belt needs to be checked right away! it may be on its way out and if that goes your motor is toast good luck and please rate -jeff

Posted on Sep 05, 2008

  • 6674 Answers

SOURCE: 1976 Gran Torino motorcraft 2150

Are you sure your idle ports ( size of pinhole) in carb aren't plugged with something? What happens if it starts to die, and you give it a quick squirt of WD-40 , down throat of carb?

Posted on Oct 18, 2008

  • 53 Answers

SOURCE: running rough

what engine is this diesel /petrol

Posted on Oct 23, 2008

  • 223 Answers

SOURCE: Need location of fuel pump on a 1992 BMW 525i straight six engine

The fuel pump is located under the back seat on the passenger side. You will find an access cover and will need to remove the screws. You should be able to listen for the pump while someone cranks the car. Also I believe there is a large green w/ blue trace wire and an equally large brown wire at the connector. Check for battery voltage across the two wires. The fuse for the pump should be in the fuse panel under the hood.

Posted on Mar 09, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a citroen zsara picasso that wont rev out

Fuel filter,fuel pump,cam timing,exhaust plugged,bad catalitic converter.

Nov 10, 2014 | 2004 Citroen Xsara 2.0

1 Answer

Citroen xantia electrics are shorting out

If it's an automatic, check if the lever is at P or N. Check if your car has immobilizer that needs you to enter codes before it will start. Gauges moving full scale usually indicates that the instruments cluster is 'missing' an additional IGN supply. When you turn your key to the ON position, all lights in the cluster will light up. This position will make the ignition switch supply 2 IGN power to most electrical systems. If one is missing, the car may not start. Check all fuses under the fascia and in the engine bay. Be on the look out for fuses that have melted 'seats'. They may give intermittent power. Xantia's fuse slots gets melted with age, so the fuse becomes loose and supply gets disconnected.

Mar 23, 2014 | 1998 Citroen Xantia Break

1 Answer

Multitronic gearbox

dont ask a dealer-bettr advice from privatemechs--ur car needs a datastream run-to show values whats goin on in the system--specific gear is used not a cheap code reader--the computer may hav issues-unplug it and clean the connectors-then see if it clears anything--ur library has vehicle repair books

Feb 10, 2014 | Cars & Trucks

1 Answer

2.1 i stalling

Your fuel injection pump may need to be re calibrated. Check,clean or replace fuel filters if not done yet. Check pre-heating circuit runs properly. Diesel train tends to get ingested with water more frequently. Drain fuel filter of any water.

Apr 19, 2012 | Citroen Xantia Cars & Trucks

1 Answer

My Golf Mk4 TDI's lights have started pulsing with the sound of the engine idling rough however rev counter stays pretty steady. putting a multimeter across the battery whilst ignition is off gives a...

voltage sounds kinda high for while its running. the voltage regulator in the alternator sounds like it is bad. i would replace the alternator.

Feb 03, 2010 | 2000 Volkswagen Golf

1 Answer

Car wont rev

under the bonnet on the back of the mechanical pump there is a unit held in by 2 bolts
remove this unit and on the end there is a tiny filter
this will need cleaning because when the lift pump brakes down tiny parts of it get sucked up through the pipes and clog the filter
it may be best to feplace the fuel filter aswell

Oct 01, 2009 | 1990 Peugeot 405

2 Answers

Over revs and wont start

it could be a bad alternator

Jan 20, 2009 | 1988 Nissan Sentra 2 Door

2 Answers

Hard to start when engine warm

crankshaft sensor may be going bad

Jun 26, 2008 | 2003 Ford F150 Regular Cab

1 Answer

Citroen C15 Diesel Van.

It definitely sounds like the electrical part of your ignition isn't working properly.When you turn the key, the lck and tumbler turns on the ign. switch in which sends power to the rest of the car.

Jun 22, 2008 | 2006 Peugeot 505

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides