Question about Cars & Trucks

Open Question

Manual for GB, instrument get- 1200 circuit tracker

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98Chevy tracker speedometer doesn't work


The speedometer cable mechanically drives the speedometer and the odometer

Remove the instrument cluster assembly. Refer to Instrument Cluster Replacement .
Unhook the speedometer cable from the heater case.
Remove the grommet from the bulkhead.
Feed the speedometer cable through the bulkhead.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Unscrew the speedometer cable (1) from either the transfer case or the transmission.
Remove the speedometer cable (1) from either the transfer case or the transmission.
Remove the speedometer cable (1) from the clamp.
Remove the speedometer cable (1) from the vehicle.

Jan 20, 2017 | 1998 Chevrolet Tracker

1 Answer

2006 GMC Yukon, 3/4 ton with tow package will not idle above 1200 rpms/10-15 mph


check ICS for correct operation
engine idle speed is 850 -950 rpms for auto and 750-850 for manual
at 1200 rpms you are not on the idle circuits but on power circuits
run the fault codes

Jan 15, 2017 | 2006 GMC Yukon

1 Answer

Finding blower motor in 2000 Chevy tracker


Finding blower motor ?
Could you please tell me where the blower motor is ?

It is behind the instrument panel compartment (glove box ).
1. Open the instrument panel compartment by pushing in on both sides to release the IP compartment door stops.
2.Remove the following components from the instrument panel:
2.1. The screw (1)
2.2. The instrument panel compartment (2)

Dec 31, 2016 | Cars & Trucks

1 Answer

2006 Chevy Silverado 5.3 Code B2610


DTC B2610
Circuit Description
The body control module (BCM) receives a variable voltage signal from the instrument panel (I/P) dimmer switch requesting to illuminate the illumination lamps to a desired intensity. When this occurs, the BCM directly sends a variable voltage based on the I/P dimmer switch position on the instrument panel lamps dimming supply voltage circuit, instrument panel lamps dimming control circuit, and the LED dimming signal circuit.
Voltage for the instrument panel lamps dimming supply voltage circuit, instrument panel lamps dimming control circuit, and the LED dimming signal circuits is from the TBC 2 A fuse in the instrument panel fuse block directly through the BCM to these circuits.

1
Did you perform the Diagnostic System Check - Vehicle?
YES - Go to Step 2
NO - Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
Is the TBC 2 A fuse in the instrument panel fuse block open?
YES - Go to Step 3
NO - Go to Step 4
3
Test the instrument panel lamps dimming control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
YES - Go to Step 11
NO - Go to Step 8
4
Test the instrument panel lamps dimming supply voltage circuit and the instrument panel lamps dimming control circuit for an open, high resistance, short to voltage or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
YES - Go to Step 11
NO - Go to Step 5

Are you confused yet ? The info above is a Chevy factory repair manual diagnostic flow chart for DTC B2610 . Your best bet would be to take your vehicle to a qualified repair shop .

Aug 14, 2016 | Cars & Trucks

1 Answer

Need to change bulb in instruments panal of Chev tracker 2002


You have to remove the instrument cluster from the vehicle and the bulbs are replaces from the backside.

May 22, 2015 | 2002 Chevrolet Tracker

1 Answer

Replace blower motor 1998 tracker


The instrument panel needs to be taken out to replace the blower motor. For complete detail with diagram:--- Click the link below :--- http://technoanswers.blogspot.com/2011/10/how-to-replace-blower-motor-on_19.html ---------- This should help.Thanks.Helpmech.

Oct 19, 2011 | 1998 Chevrolet Tracker

2 Answers

Where is the 16-pin data link connector on 2002 chev tracker?


IT IS LOCATED DIRECTLY UNDER THE STEERING COLUMN.

May 20, 2009 | 2002 Chevrolet Tracker

1 Answer

The clock, radio and cd player quit working


I have a 4 DR 2002 Tracker. There are two fuse blocks. One is under the driver side instrument panel and the other is in the engine compartment on passenger side. Did you look at both?

R Black

Mar 19, 2009 | 2002 Chevrolet Tracker

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...