Question about Cars & Trucks

Open Question

Leaking oil out of the pump plunger - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Install crankshaft kit on 2004 hyundai sonata 6 cylinder 2.7l engine


Really need more information...It sounds like they didn't give you a complete gasket kit...You will have to remove and re-install other components just to be able to see the crank shaft....You need the front and rear oil seal for the crank..,Oil pan gasket..,exhaust will have to be removed also...etc.......NEED MORE INFO..

Jan 24, 2015 | Hyundai Motor 2004 Sonata

2 Answers

Why woun't my 6500 ransond generator start its a diesel


See id it is actually pumping fuel and if so see if the glow plugs are getting hot.

Oct 07, 2014 | Cars & Trucks

1 Answer

Kubota M 5030 2.8 6 cyl. Diesel in oil sump. Why?


Diesel gets in the sump from an seal leaking in the fuel pump through to the drive gear and out into the sump. If it has an inline pump( one where the injector lines are in a row at the top of the pump) the fuel will be leaking past the plunger elements and into the pump sump which then drains back tot he engine sump. IF it is slight but consistent sometimes injectors will dribble when shut down and the fuel will by pass the piston rings into the sump. Talk with a diesel pump and injector repair specialist for any faults particular to the Kubota fuel system

Apr 03, 2013 | Cars & Trucks

1 Answer

Changed the oil and fuel filters in 06 duramax and truck won't start


IS THE ENGINE TURNING OVER? IF IT IS YOU MAY HAVE TO BLEED AIR FROM THE FUEL SYSTEM, IF THERE IS A MANUAL PRIMING PUMP, USALY BUILT AS PART OF THE FILTER HOUSING OR REMOTELY MOUNTED ON THE FUEL SYSTEM PUMP THE PLUNGER THILL IT GETS HARD THERE SHOULD BE A BLEED SCREW MOUNTED OPEN IT AND STROKE PLUNGER UNTIL YOU SEE BUBBLE FREE FUEL COMING THROUGH CLOSE OFF THE BLEED SCREW AND PUMP PLUNGER TILL HARD AGAIN THEN TRY STARTING

Jul 29, 2011 | Chevrolet 2500 Cars & Trucks

3 Answers

My 3406b caterpillar engine is having excessively high oil levels


HI,
Time to find out why your oil level is going up.
Either coolant in the oil, or fuel in the oil.
Which ever it is the cat engine is not happy. My suggestion would be to get an oil sample test.
Any major diesel repair place will help. Just a little oil in a sterile jar to be analyzed for contaminants.
Coolant is the worst as it will scour the bearings.
Good thing you are concerned.
Wayne

Dec 02, 2010 | Ford F-450 Cars & Trucks

1 Answer

How to fix a oil leak where the filter is at


If its a 3.8 litre its possibly the oil filter adapter gasket has failed..t bolts 13mm remove the adapter and clean the gasket off..note silver plunger and spring do not remove....leave them there..install new gasket andreinstall adapter..good luck

Apr 01, 2010 | 1998 Buick Regal

1 Answer

High oil pressure changed intake gaskets 2 days later it blew oil fiter seal out changed filter it did it again within 5 seconds


The pressure control is integral to the oil pump . the plunger is stuck on the oil pump possibly due to some contaminates ..remove the oil pan and remove the oil pump and clean it.remove the spring and plunger and clean it as well and put it all back together and all should work...good luck..

Mar 01, 2010 | 1998 Chevrolet Express

1 Answer

The oil is leaking from my car i think that the oil pump is damaged because oil is leaking very bad


Unless you've run it out of engine oil because of the bad leaks , oil leaks are are not a sign of a bad oil pump , what is a sign of a bad oil pump is low or no oil pressure either due to lack of oil for the pump to pick up in the oil sump or either a mechanical failure of the oil pump, in which case you would have some internal damage to your engine. In either case if you plan to keep the car then by all means have the oil leaks investigated and repaired so the the oil stays inside the motor instead of the outside and on the ground making your driveway look horrible...

Oct 05, 2009 | 1991 Oldsmobile Cutlass Supreme

1 Answer

Oil pump - 42kmls


I am having the same issues. I am about to check the relief valve myself. There are two remaining factors for you the actual pump or the little ol o-ring on the back of pump that seals oil pump tube to block. If it is bad or blown you will not build pressure. I am not sure if it would cause a no pressure issue though. Good luck...

Aug 24, 2008 | 2000 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...