Question about Cars & Trucks

Open Question

How to access the winch on a 1996 coleman pop up

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I install an 8000 lb 5.5 hp winch and install front to back wiring rated for at least 360 amps?


There must be endless info about this online or youtube or any of the offroad sites.
Make sure you mount a good cut out switch between the battery and winch you can access in a hurry to save your truck. A big fuse is usually available from the winch co rated for that winch. If it all goes wrong you can isolate the winch. Cable is going to be stick welding cable size to get good power. Be careful how you route it. Its a big winch, use a professional mounting kit and good quality fasteners.

Feb 17, 2016 | 2005 Chevrolet Silverado

1 Answer

Where can I find a 1996 fleetwood yukon pop up owners manual?


Is this a Coleman? If so the pop ups dont change to much you may be able to use the manual from '95 or '97

Jul 04, 2015 | Cars & Trucks

1 Answer

Having trouble with my logging winch constantly pulling in.


service the clutch section of the winch as it appears that something is broken in that section of the winch
This situation is dangerous because if something happens, the winch cannot be disconnected or reversed immediately

May 25, 2015 | Cars & Trucks

2 Answers

KFI winch won't spool in or out there is power to it I can hear it clicking


If your wiring a remote control to the winch or inside control,,, 4 solinoids type,,make sure the solinoids have ground on the brown wire(warn)...if you don't have a ground all it will do is click,,,even if power is applyed
kfi-winch-spool-in-or-out-power-hear-kvbc2kogfycpbbnfa2in1e3v-4-0.jpg

Feb 19, 2015 | Cars & Trucks

1 Answer

How do I go about installing a Warn winch on the metal bumper and chassis of a 1996 3.0l v6 Mitsubishi Pajero without modifications? Cables are standard Warn designed for this winch.


just make sure you get the right steel plate for your bumper to hold the winch on or it will rip your bumper off the first time you use it make sure it is bolted sucure

Jan 19, 2015 | Mitsubishi Cars & Trucks

1 Answer

HOW DO I INSTALL A WARN WINCH ON A 1996 3.0L V6 PAJERO AUTOMATIC?


I don't care what vehicle you are fitting it on I must emphasize make sure you use high ampage cable with very good earth, most important use at least 10mm cable
John

Jan 19, 2015 | Cars & Trucks

2 Answers

My winch don't move it all?


if you can use the winch manually by pressing buttons on the winch then the problem will be in either the remote unit(Battery in back to front) or the receiver in the winch

Dec 22, 2014 | Cars & Trucks

2 Answers

Idk how to bring down my spare tire on my 1996 jeep grand Cherokee


if you have a winch type spare tyre arrangement the it is held in place by a chain on a winch spindle. IT is locked in place by a clutch that you activate when you wind up the tyre until it is tight. To undo the clutch and lower the tyre simply turn the crank handle as it letting it down. Overcome the initial tightness and then it will lower as you turn the handle.

Oct 31, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Coleman taos trailer


This is the car and truck section, but I would guess something metal is getting hot and expanding, such as an inside panel.

Jul 07, 2013 | Cars & Trucks

2 Answers

Replacing spare tire winch 2004 chev trailblazer


I have a '02 TrailBlazer and I had the same problem. When I got a flat and went to change the tire on the side of the road I was not able to get the tire off the winch. Luckly, I have AAA and the driver knew the trick to getting the tire free. The process involved lowering the tire as far as it would go and then kicking it. Wind back up and repeat until the winch free's itself.

When I took the car into the shop to get the tire fixed and the have the spare put back on the car, they were not able to get the winch free enough to put the tire back on. They said that is is a common problem with this mechanism and suggested replacing the winch system (estmated parts and labor $215). From what I can tell the winch accumulates rust up in the cable and locks up.

Apr 05, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...