Question about Cars & Trucks

Open Question

P38, all lights on ignition, however, wont start

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Range rover P38 1995 2.5 Diesel auto .would not turn over all lights and Windows working new battery ok yesterday


when you lock it up does the alarm activate you say this problem only started after changing battery sounds like its the mobiliser lock and open car from inside with key in ignition hope this helps

Mar 14, 2015 | 1995 Land Rover Range Rover

1 Answer

Power loss in range rover p38 4.6 lt when going up hill


the p38 is a bit sluggish and slow on long steep hills, really not geared for performance but more as a piece of heavy equipment. strong horsepower wise very formidable powertrain but you're not going to have that get up and go that many drivers look for. couple quick suggestions you may want to check your plugs and wires a common weak spot in the ignition system, and i might suggest also running i can of seafoam through your engine. you deposit in your gas tank runs through with the half a tank of gas. i'm not a big advocate of fuel additives or octane boosters but in the case of seafoam it's definitely a worthwhile and proven product. don't forget also your sport mode button down next to your shift lever push that button down and it keeps your transmission from overdrive so you can accelerate into freeway traffic and climb hills without your transmission shifting
23939215-0evhjygssyfwoc20byca3z0s-1-0.jpg

Mar 30, 2014 | 2000 Land Rover Range Rover

1 Answer

1998 p38 at 2000 rpm's it bucks wont go over 30 miles an hour.swapped air mass,coils r/r spark plugs fuel filter fuel pressure at 35psi.


hi i have just had he same problem with my V8 p38 try cheaking your crank shaft senser we have just taken ours out and cleaned it up with carb cleaner and it works fine

Oct 19, 2010 | 1998 Land Rover Range Rover

1 Answer

How do i resolve Range Rover p38 immobilisor


sounds like keyfob has lost its sync with the car, look online lots of places tell you how to re-ai.lgn them

Jan 08, 2010 | 1999 Land Rover Range Rover

1 Answer

1998 range rover p38 2.5 dse auto engine stalls


Sounds like something is overheating then and possibly a sensor. Not familiar with Rovers but might be a problem with the CAS and/or CPS which tells the ECU the motor is running and when to fire. Also maybe the IAC is bad and when you go from throttle to idle it can't control it and allows it to die.

Nov 29, 2009 | 1998 Land Rover Range Rover

3 Answers

How do I re boot my range rover suspension. The mechanics lifted the vehicle on a hoist to do some maintenance and when they set it down they could not get it to lift. The vehicle remains flat with the...


hi, this is due to a couple of things. 1 is this a p36 or p38.
things like the door sensors will prevent this from lifting, its to stop it crushing your leg when foot is out.
more than likely there are 2 hieght correctors.
depends on the model. i see these where leg pops out, i get them in where a air bag has popped off, loosing all your air.
when its a p38 and lifted, if u dont push the button on the dash the computer gets confused and wont let it lift, this then needs a reset. i have lifted a lot of range rovers and the p38 is the worst, i use a 2 post lift, u got to push button on dash, this tells it its getting jacked up or lifted. i have forgot to push it a couple of times, a air bag drops off, u need tough thumbs to push it on.
listen to see if the compressor is running when running.
you must open bonnet start engine then shut door making sure all doors are shut, there is a box think it says eas (black box) you can take the cover to see it pumping, u will hear it.
if not you and none of this whats mentioned is at fault u have to have it 1 plugged in or 2 reset. hope this helps u. 1 more suggestion, im not sure about a p36, is the button on the dash on, orange light on, this locks the suspension for lifting, when down wont go up.
get back to me how u got on, i will have another think. im sure the sensor on axle.

Aug 11, 2009 | 2000 Land Rover Range Rover

1 Answer

CLUTCH PROBLEMS RANGE ROVER P38


hi im having the similar problem with my range rover p38 2.5td , i was on my way home i went from 3rd to 4th and then when i went to 5th the pedal went straight to the floor and it wont go into gear as there is no bite on the pedal at all. i thought it would need bleeding so i did so and nothing happened can anyone help.

May 08, 2009 | Land Rover Range Rover Cars & Trucks

1 Answer

Range Rover p38 bmw 2.5 injection running problem


Hello,
It turned out to be a broken wire on the injector which was causing a bad connection,now running better than before.
The cold was just a coincidence.

Thank you and best regards,Yvonne

Jan 07, 2009 | 1996 Land Rover Range Rover

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...