Question about Cars & Trucks

Open Question

My E350 handy cap van keeps shifting from drive to overdrive , I can not push button on shifting Columbia while running but shut off can get overdrive light to alumina refinery

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 239 Answers

SOURCE: My 99 Silverado 1500 won't shift into overdrive

There is an overdrive fuse in the fuse compartment on the drivers side door panel, check and see if its blown, if it is there was some problems with the overdrive shift wire touches the bottom of the tranny pan, and can cause the fuse to blow out.

Posted on Jun 23, 2008

  • 16 Answers

SOURCE: push button overdrive column light flashes,

the flashing overdrive light indicates a code for the transmission you need to have your codes read to see what is causing the problem

Posted on May 10, 2009

  • 376 Answers

SOURCE: 1995 ford f150 when I push the overdrive button,

cut wire/ or lost ground signal to switch

Posted on Sep 13, 2009

  • 1986 Answers

SOURCE: 2007 ford e350 van, reverse lights wont work

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

  • 39 Answers

SOURCE: what cause overdrive light to come on while

This is like a check engine light for your transmission. Something is slipping or out of its values. Get it checked out with a code reader.

Posted on Apr 07, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 mazda mpv wont shift out of overdrive

code p 0106 refers to manifold absolute pressure (MAP) sensor/barometric pressure(BARO) sensor --range / performance problem=== causes ---intake / exhaust leak---wiring---MAP sensor ---BARO sensor
not shifting out of over drive could be a problem servo/ solenoid , dirty oil , wiring or VSS sensor
have that complaint properly diagnosed by a competent auto transmission specialist shop

Dec 20, 2017 | 2000 Mazda MPV

1 Answer

Why does the fifth gear keeps on popping out

is it an overdrive push button gear.

Dec 21, 2013 | Cars & Trucks

1 Answer

2oo3 vw golf tdi 4 speed automatic wont shift into over drive and red caution light keeps blinking

Is there a Push Button to take your Transmission out of Overdrive? Are you pushing the RPM?

IT sounds like you need to put a Scan Tool on the Vehicle to see what is going on and giving you the Caution light

Apr 08, 2013 | Cars & Trucks

3 Answers

I just got O/D off light on in my 1998 Toyota Corolla. What to do

hello subir. This is the over drive function. someone may have accidentally pushed this button so to turn it off you will have to find it and push it again. there is a Overdrive button somewhere on the shifter. It is probably on the side of the actual handle or down near the 4-speed gear numbers, sometimes even in the end of the shifter..

O/D off is NOT a big problem at all- you just don't want to use it all of the time because it runs your engine a lot harder because you are always in a lower gear. That would be used if you were driving up a big hill, for example, and don't want it staying in the highest gear. It gives you more power in circumstances like that

May 04, 2011 | Toyota Corolla Cars & Trucks

1 Answer

Light on dash says o/d off what does it mean and how do I turn back on?

O/D Off means that you pushed a button on the shift lever and effectively "disabled" overdrive. This mode is normally used only when towing something fairly heavy or in some very slick snow or icy conditions. To get the light to go off and put the van back in overdrive, look for the small button on your shift lever and press it in while driving or in park, doesn't matter as long as the car is running.

Sep 08, 2010 | 2004 Kia Sedona

1 Answer

My van would run good until it ready to shift into overdrive, it would **** a little and it seems it losing power when driving up hill.

check tranny oil if ok,van is ready for rebuilt tranny,its a common problem for your van.sorry,good luck

Jun 04, 2009 | 1999 Ford Econoline

2 Answers

Transmission problem

im sorry to say no it will not.

Mar 02, 2009 | 1988 Chevrolet Astro Cargo

1 Answer

Overdrive indication light

first of all, does it shift into overdrive, I would check and see first of all if you drive it and it does go to O.D. then press the button once, does it not go to O.D. you can do this while driving, when running about 45 press the button once, do you feel it downshift. if yes then your light is burnt out...if no run an OBDII check to see if there are nay codes for the transmission. if that checks out theN i would go for the switch being bad..

Aug 05, 2008 | 2003 Ford Ranger Regular Cab

1 Answer

The D3 code on my 2007 honda odyssey is on what is the problem

This is not a code. Instead it is an indication that you are running the van in "overdrive off" mode.

Your van is equiped with a 5 speed automatic transmission. By running in overdrive off you are essentially running in 3rd gear, out of 5 gears. This will cause your van to run at a much higher engine speed, while not going very fast at all and consuming a lot more gas than normal.

You can deactivate this mode by:
1) start the van
2) Press the break pedal
3) Shift to 'D' (drive mode)
4) press the little button that is located on the left side of the shifter, under the shifter button.

If the light does not go out after pressing this button, you may need to take the van to your Honda dealership. Your van should still be under warranty as it is a 2007 model.

Good luck!

Jul 02, 2008 | 2007 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14403 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides