Question about 1990 Toyota 4Runner

Open Question

Bleeding the clutch on 1990 toyota 4 runner - 1990 Toyota 4Runner

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 49 Answers

SOURCE: cant bleed out brakes

It takes time, do you know the sequence to bleed the brakes? Most cars r different. And you have to keep pouring brake fluid, That is a two person job. Make sure all lines r connected to MC and not leaking. After a while if nothing comes out MC could be diffective.

Posted on Jun 06, 2009

  • 1810 Answers

SOURCE: window will not roll up on 1990 toyota 4 runner

no power or no ground ??
try running a hot line to the motor

run a pair of wires from the batterie 1 pos 1 neg speaker wire will do

unplug the window motor and run it direct pos on 1 wire neg on the other flip the wires to change motor direction
if motor works then it's eithor a bad ground or a bad wire or a bad reley

Posted on Jan 01, 2010

mlapres
  • 757 Answers

SOURCE: 1990 toyota 4 runner. Gas smell under the hood

If you cannot find a leak then it is probably running too rich if you are also having a rough start and or rough idle. You can find out if it has been running too rich by checking any one of your spark plugs...it will be coated with a lustrous black residue and/or smell like gas. At that point you will have to change them.

You can also try replacing your PCV, a clogged PCV can also allow that type of smell to escape past it's grommet into the engine bay instead of recirculating it back into the system.

Posted on Jan 01, 2010

  • 12104 Answers

SOURCE: Is there a bleeding sequence for a 1990 Toyota Four Runner

the parts u changed thats a lot of air to bleed ---regular procedure for bleeding brakes is to start with the furtherest than work ur way to the closest -start with the rear pass side rear drivers side than pass front last drivers front

Posted on May 31, 2010

  • 1509 Answers

SOURCE: fuel pump relay location for toyota 1990 4 runner

90 4 runner fuel pump relay? with the 3.0 engine. It's on the right side of the engine bay ( sitting in the drivers seat) it's lables EFI main relay. It's marked non the cover and theres fuses too in the same box.

Posted on Dec 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gears in 1990 Toyota 4 runner grinding and not engaging


I'm assuming it's manual, check your clutch slave cyl level. You may be low on fluid. If you check the slave cyl and it has good travel and decent pressure your transmission will need to be removed to inspect clutch

Oct 20, 2013 | 2003 Mitsubishi Outlander

1 Answer

04 toyota 4 runner shifter makes a noise like a fan hitting something then goes away after i shift it back and forth a few times?


Check and bleed the clutch as it appears that there is insufficient dis-engagement of the clutch and the shaft is still spinning . This is causing you to hit the dogs in the gear box and grating the gear teeth.

Aug 23, 2013 | Toyota 4Runner Cars & Trucks

1 Answer

Does truck have to be running on my 1990 toyota 4-runner 4x4 ?


No, you can do it without the engine running. The power assist just makes braking easier. Just make sure you don't move the pedal till the bleeder is tight, then pump it back up an do it again. Start at the right rear and move towards the front left. Hope this helps.

Jun 16, 2010 | 1990 Toyota 4Runner

1 Answer

Starter removal on a 1990 toyota 4 runner. Where


it is not fun w/o lift look behind passenger wheel you will need to raise front end remove wheel ,remove skid pan,and of course battery ends if 4wd I highly reccomend a lift good luck and please rate this

May 05, 2010 | 1990 Toyota 4Runner

1 Answer

New clutch it's already install but still shift noising


Make sure there is enough transmission oil in the gearbox, without oil the synchro's cannot work so gearchanges will be slow and cumbersome. If filling the gearbox oil dosent help maybe you have gearbox damage - have the gearbox checked out.

Jan 25, 2010 | 1990 Toyota 4Runner

1 Answer

Window will not roll up on 1990 toyota 4 runner


no power or no ground ??
try running a hot line to the motor

run a pair of wires from the batterie 1 pos 1 neg speaker wire will do

unplug the window motor and run it direct pos on 1 wire neg on the other flip the wires to change motor direction
if motor works then it's eithor a bad ground or a bad wire or a bad reley

Jan 01, 2010 | 1990 Toyota 4Runner

1 Answer

Looking for technical repair manual for 1990 4 toyota 4 runner


Check out faxonautoliterature. They list the original Toyota service manual and a separate wiring manual. I have used them and had excellent service. Hope this helps.

Nov 30, 2009 | 1990 Toyota 4Runner

1 Answer

My 1990 toyota 4 Runner has a v low rpm while in


on the cable of the accelerator,there is an adjuster to its an,so you can adjust it here to rev it a little ,at 750 rpm,

Aug 19, 2009 | 1990 Toyota 4Runner

2 Answers

Cant bleed out brakes


It takes time, do you know the sequence to bleed the brakes? Most cars r different. And you have to keep pouring brake fluid, That is a two person job. Make sure all lines r connected to MC and not leaking. After a while if nothing comes out MC could be diffective.

Jun 06, 2009 | 1990 Toyota 4Runner

Not finding what you are looking for?
1990 Toyota 4Runner Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...