Question about Nissan Cars & Trucks

Open Question

My Nissan murano 2007 model complain p1148 and p0031 codes

Nissan murano 2007 model

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: nissan murano 2005 sl keyless entry remote programing

Close all vehicle doors, LOCK doors using drivers side switch.

Insert key all the way into the ignition, (do not turn) remove key.

Repeat this step 5 times. (6 total)

Hazards should flash to indicate program mode.

Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.

*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press any button on remote, hazards should flash. Repeat step as necessary.

Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.

Source

Posted on Aug 06, 2008

insanegtp
  • 112 Answers

SOURCE: 2004 Nissan Murano How do you clear maintenance light after oil change?

press maintanence button until you see engine oil, then hold trip/reset button... :)

Posted on Oct 03, 2008

  • 1 Answer

SOURCE: '06 Nissan Murano factory radio/cd player removal steps

what holds the radio in place besides the 2 side screws in a 2006 nissan murano

Posted on Feb 08, 2009

  • 1 Answer

SOURCE: 2004 Nissan Murano, back door can't open

I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.

Posted on Mar 03, 2009

  • 635 Answers

SOURCE: My Nissan Murano has 82,000 miles. Do I ned to

Yes

Your owners manual will give you the mileage at which it should be changed.

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How fixed p 1148 nissan armada 2008


It may be a faulty oxygen sensor.
For Models 2005 and up:
- Faulty Air Fuel Ratio Sensor 1 Bank 1
- Air Fuel Ratio Sensor 1 Bank 1 circuit is open or shorted
- Air Fuel Ratio Sensor 1 Bank 1 circuit electrical connection

Before you rush off to buy replacement parts it's worth giving a mobile mechanic a call. Those guys are usually very good and far cheaper than a dealership. And a second opinion is worth paying for.
P1148 and P0031 Problem

Mar 16, 2016 | Nissan Cars & Trucks

1 Answer

I'm getting a cylinder misfire code on my 2007 Nissan Murano. what could be causing this?


9 times out of 10 a cylinder misfire is caused by either a bad spark plug or a bad coil over the plug. If the code told you which cylinder is bad, just switch the coil with the next cylinder and restart the car and rescan a code and see if the new code now tells you that the faulty cylinder misfire is moved to your new location of where you moved the coil to. (cylinder) - If it does you know the failure is with the coil.

Sep 23, 2015 | 2007 Nissan Murano SE

1 Answer

What are the probable causes of DTCs P0031, P0603, and P1148?


Clean out you idle air bypass valve with carb cleaner. P0031 air/fuel sensor 1 heater (B1)bank 1, p0603 engine control back up circuit,p1148 closed loop B1. Broken heater in upper O2 sensor is one if not all of your problems. Replace all of your O2 sensors & reset engine light.

Sep 01, 2015 | 2012 Nissan Altima 2.5 Sedan 2.5L 4-cyl....

1 Answer

I want to know if the gearbox and BCM unit of 2007 Nissan Murano is replaced, why is it still in limp mode?


Reset codes. one way is to disconnect battery overnight, but that will also require resetting radio security code, You will need a repair manual for resetting error codes.

Apr 01, 2015 | 2007 Nissan Murano 3.5

1 Answer

Removing the front power outlet on a 2007 Nissan Murano?


location of airbag ECU on 2001 (Y) peugeot boxer 2.8HDI

Jan 20, 2014 | 2007 Nissan Murano SL

1 Answer

WHAT IS P1148 CLOSED LOOP-B1 and P1031 A/F SENI


loosen and re tighten the top left (rear) o2 sensor and check the connector is not loose...

Feb 06, 2013 | 2005 Nissan Murano

1 Answer

2006 Nissan Murano Problem


What are the fault codes you now have, do not assume it is the same problem causing the rough run. I suspect that something was not done right during the overhaul/rebuid.

Feb 09, 2012 | 2007 Nissan Murano 3.5

1 Answer

Codes p0031 p1148 ? What/where are they?


I am having the very same problem with my 2007 Nissan Versa right now as well. However, I have one more additional code: P0142. P0031 refers to the front oxygen sensor heater circuit, low imput. P1148 says: Air/Fuel sensor s connection is shortened or open. I have been digging around online, and have come up with a possible bad upstream O2 sensor, a bad bank 1, sensor 3 malfunction (and replacement), and a possible connection problem. I have NO idea why all of these problems would arrive from a car that's only 3 years old. I've been trying to search for any recalls, considering if it's taken to a dealer to fix, the end cost will be over $600. That's just plain crazy!!

Dec 01, 2010 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

Nissan Murano 04 OBD II P1168 y P1051


there is a emission system recall for these codes for your year and model contact the Nissan dealer, it is a no charge repair.
here is the summary of that recall

MALFUNCTION INDICATOR LAMP ON WITH DIAGNOSTIC TROUBLE CODE P0300-P0306, P1273 OR P1283. *TT *SC
Make : NISSAN Model : QUEST Year : 2004
Manufacturer : NISSAN NORTH AMERICA, INC.
Service Bulletin Number : 04028A Date of Bulletin : MAR 24, 2004
NHTSA Item Number : 10005976
Component : ELECTRICAL SYSTEM
Summary :
MALFUNCTION INDICATOR LAMP ON WITH DIAGNOSTIC TROUBLE CODE P1031, P1051, P1148, P1168 (A/F SENSOR HEATER / CLOSED LOOP) ON 5 SPEED AUTOMATIC TRANSMISSIONS ONLY. (THIS VERSION SUPERSEDES NTB04-028.) *TT

Jul 01, 2009 | 2003 Nissan Murano

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...