Question about 1998 Oldsmobile Intrigue

Open Question

Tempature sensor 3.8K motor location

1998 olds intrigue where is the coolant sensor

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 50 Answers

SOURCE: crank position sensor location

you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!

Posted on Aug 18, 2008

Ad
  • 2 Answers

SOURCE: 1998 olds intrigue trouble code p0171

I have a dianogstic machine and the code you were given indicates that the system is too lean. (Bank 1) Were you go from here i'm not too sure. Steve

Posted on Oct 01, 2008

  • 840 Answers

SOURCE: 1999 Olds Alero 3400 motor -- location of Crankshaft sensor

Welcome to fixya. If you need anything else go to www.collisionrepairadvice.com here is the location.
On the lower rear of the engine (LA1) for the 7x
and for the 24x

On the lower rear of the engine (LA1

Posted on Jul 26, 2009

Testimonial: "Got it Thank You!!! Actually my problem was a bad fuel pump in the gas tank."

techbuster
  • 5081 Answers

SOURCE: need to drain coolant from 1998 Olds Intrigue.

COOLANT CHANGEON THE RADIATOR (LOWER DRIVERS SIDE FACING THE MOTOR) THERE IS A PLASTIC LIKE PLUG THAT YOU TURN COUNTER CLOCKWISE ABOUT 3/4 OF A TURN, THEN YOU CAN PULL IT OUT ABOUT 1/2 AN INCH THIS WILL DRAIN THE RADIATOR, THEN YOU CAN PUSH THE PLUG BACK IN AND TURN IT UNTIL YOU FEEL IT LOCK BACK IN PLACE. REFILL RADIATOR WITH 3 PARTS COOLANT TO 1 PART WATER.
1998-'99 Intrigues equipped with the 3800 engine have a specific process for replacing antifreeze. It is somewhat of a lengthy process and you should refer to your owners manual for doing this. After you empty and flush your system with water (garden hose), only fill the system with green 50/50 antifreeze, NOT Dex-Cool. Avoid Dex-Cool. If you bring your Intrigue to a shop to get serviced, make sure and inform whoever doing repairs and/or leave a note (clearly visible) to NOT use Dex-Cool if they're doing any work pertaining to cooling system.

Posted on Nov 08, 2009

  • 1168 Answers

SOURCE: Trying to replace the crankshaft position sensor

Hello suewagner.
The crank sensor is mounted above the starter motor on the firewall side of the engine. The sensor picks up the signal direct off of the crankshaft through a machined hole in the engine block.
I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it.
Here is a diagram for you.

96819d7.gif

There you are, hope this helps you.
Take care,
KL

Posted on Apr 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolant sensor location


The coolant temp sensor should be near the upper radiator hose and the thermostat housing.

May 22, 2013 | 1998 Oldsmobile Intrigue

1 Answer

My 1998 Olds Intrigue needs an O2 sensor. Where is that located and how hard/easy is it to replace it?


Should not be too tough to change. The front sensor is between the engine exhaust manifold and the catalytic converter.

Jan 24, 2013 | 1998 Oldsmobile Intrigue

2 Answers

Does car have a sensor for tempature


Maybe Because Your Car Is Old And Yes Cars Do Have A
Temputure Sensor So Try Installing A Brand New Sensor.

Kevin.

Aug 24, 2012 | 1998 Plymouth Neon

2 Answers

Where is O2 sensor located on 1998 olds intrigue?


either in exhaust manifold or exhaust pipe itself, looks like a sparkplug with a single purple wire running to it

Sep 05, 2010 | 1998 Oldsmobile Intrigue

1 Answer

Where are the O2 sensors located on 1998 Olds Intrigue?


Ther are two sensors on this car if it has a 4 cylinder engine, these sensors are screwed into the exhaust system pipes, theres one before the cat converter and one after converter,. you just unplug connector and use wrench to loosen and remove.

Aug 28, 2010 | 1998 Oldsmobile Intrigue

1 Answer

Need to drain coolant from 1998 Olds Intrigue. What is best way? (3800 Engine)


COOLANT CHANGEON THE RADIATOR (LOWER DRIVERS SIDE FACING THE MOTOR) THERE IS A PLASTIC LIKE PLUG THAT YOU TURN COUNTER CLOCKWISE ABOUT 3/4 OF A TURN, THEN YOU CAN PULL IT OUT ABOUT 1/2 AN INCH THIS WILL DRAIN THE RADIATOR, THEN YOU CAN PUSH THE PLUG BACK IN AND TURN IT UNTIL YOU FEEL IT LOCK BACK IN PLACE. REFILL RADIATOR WITH 3 PARTS COOLANT TO 1 PART WATER.
1998-'99 Intrigues equipped with the 3800 engine have a specific process for replacing antifreeze. It is somewhat of a lengthy process and you should refer to your owners manual for doing this. After you empty and flush your system with water (garden hose), only fill the system with green 50/50 antifreeze, NOT Dex-Cool. Avoid Dex-Cool. If you bring your Intrigue to a shop to get serviced, make sure and inform whoever doing repairs and/or leave a note (clearly visible) to NOT use Dex-Cool if they're doing any work pertaining to cooling system.

Nov 08, 2009 | 1998 Oldsmobile Intrigue

1 Answer

Motor hesitation only when it is cold once engine is warmed up engine runs smooth. Motor hitches terrible until tempature comes up too normal operating temperature. Once engine is warm it runs perfect,...


It might be your ECT sensor (engine coolant temperature sensor). Usally you can mesure the resistance and the voltage of the ECT sensor. You need a chart which says the Resistance versus the Temperature versus Voltage. EXEMPLE : at 120celsius, voltage should 0,27volts and the resistance should be 1,18Kohms ...etc. (this is only an exemple)

Jun 23, 2009 | 1998 Jeep Wrangler

1 Answer

Check or replace mass air flow sensor 1998 olds intrigue


it is located between the air filter and intake manifold, it the part where wires are connected. if this fails your car will have jerking engine or rough run.

Apr 26, 2009 | 1998 Oldsmobile Intrigue

1 Answer

Ideals rough but drives great where is the map sensor


The map sensor is located just below the alternator on top of the motor. It's easily removed. I just changed one on my intrigue. Their are no screws to remove, it just clips on. It is square in shape and the size of approx., a nickle.

Mar 02, 2009 | 1998 Oldsmobile Intrigue

1 Answer

Bad starter


Crawl under the front of your car near the drivers side. As you creep towards the back of the motor. you should see it..Good luck

Nov 10, 2008 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
1998 Oldsmobile Intrigue Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...