Question about Mercury Cars & Trucks

1 Answer

I have a 2010 Mercury Milan Premiere AWD. I was driving home and my e-brake light came on. My tire pressure monitor light came on. no radio/heater. Nothing in that area turns on or works. Any ideas?

Posted by on

  • Caroline Morin May 07, 2017

    There are No error codes or blown fuses...

  • Caroline Morin May 21, 2017

    Thank you, Jeff



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Mercury Master
  • 13,738 Answers

No error codes , where ? OBD2 PCM - engine computer ? Need to use a factory scan tool an check all the modules on the vehicle ! SJB - smart junction box , fords BCM ! Do you know what a body control module is? The instrument cluster can have codes also . Did you check fuse's in the SJB ? . Do you know how to do electrical testing using a volt meter ? How to read a wiring diagram to find power to the circuits in question , how to check grounds ? If the tire pressure monitor light is on , there is a code in the IPC or SJB . Electric Testing Techniques You Need to Know
I would look at wiring diagrams to see if the thing's you have listed have anything in common ! B+ voltage supply circuit , share a ground point etc....
The Trainer 29 Understanding How Electrical CIrcuits Work and How to Test...

Posted on May 20, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Tire pressure light

On the lower left hand side of the dash, near the Traction control button, is a small push button. Just press and hold until the Tire Pressure light goes out. Of course, make sure you're pressure is ok, otherwise, it will just come back on in a couple minutes.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: Lexus sc430 tire pressure monitor

there is a reset button for the tpms either just above the accerlator or to the right of the glove box. press it and tah should be good to go.

Posted on May 24, 2009

Testimonial: "Knowledgeable expert...found the button (but unfortunately did not fix problem--maybe shop messed up a sensor in the tire)"

  • 18 Answers

SOURCE: i have 2008 pontaic g6

need to be program or faulty tire pressure sensor

Posted on Oct 06, 2010

  • 4803 Answers

SOURCE: 2010 cobalt need 2 know

The low tire pressure warning should go out if you set all of the tire pressures to the correct pressure, then drive the vehicle for about a mile. You should not have to "relearn" the Tire Pressure Monitoring System (TPMS) unless the tires are (A.) rotated into different positions or (B.) There is a bad sensor that needs to be replaced.

For more information, you can read the information in your Owner's Manual. Here is a link to a pdf version 2009 Cobalt owners manual. (The information and procedures are the same for 2008 - 2010 Cobalts) The TPMS section starts on page 5-64

Cobalt Owner's Manual

Posted on Mar 30, 2011

  • 1450 Answers

SOURCE: in my Chevy Equinox LT AWD 2007 i have good power

the tire pressure sensor has nothing to do with traction control. need to have system scanned and see what codes are in it and we can go from there

Posted on May 16, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to reset and light after I put new brake shoes on

how to install front and back brake shoes. on a 2006 ...

? 6:43
Mar 28, 2010 - Uploaded by Victor Crespo
in this section i will show you how to install new brake shoe. ...How to change oil in 2005-2012 Mercury Milan/ Ford Fusion (3.0L V6) ...

Sep 27, 2015 | 2007 Mercury Mountaineer

1 Answer

2011 Mercury Milan LED tail light out

Yes, I have a 2011 Milan as well and both sides of mine went out. One last year (2013) and the other side recently. My car is no longer under warranty and the dealer said they it would be $417 to repair. Ford needs to fix this issue because from what I have been reading it is a common problem and it is a safety issue!

Nov 05, 2012 | 2010 Mercury Milan

1 Answer

Is ir normal to replace rear brakes on a 2010 mercury milan with only 22,300 miles? 15-16,000 of the miles are highway miles

The rear brakes should last 70,000 miles, if
you disassemble,clean & lube once a year,
on the rear of most all cars

My question is --- have you not had years or decades
of experience with other vehicles?
If so, why would you ask that question?

Aug 25, 2011 | 2010 Mercury Milan

1 Answer

I am getting a lot lower gas mileage recently in my 2006 Mercury Milan Premier. I was averaging about 25 mpg and now down to 20 or a little less. What can I have checked?

Hello, First thing would be the type of gas you are using. Gas with alcohol in it would not get the mileage of Gas without alcohol. If you were getting 25mpg and drop 10% because of 10% Alcohol in your gas, then that accounts for 2.5MPG of the loss. There is some heat value in the Alcohol, but rule of thumb is less gas is less mileage.

You did not indicate if any "Check Engine" lights were on. You can try to get the car scanned, Autozone, Oreillys, and Advance do it free. But some cars will not record a problem that is intermittent, some cars have to reach a plateau of intermittent events to display a "Checklight".

Not all of the scanners are equal and some places will not connect or test a car without the "Checklight" displaying. Have clean oil and Air filter installed, but watch your tire pressure. Most of the time the Oilchange places let air out of the tires. Have tires inflated below the Maximum rating on the tire BEAD, but usually above the pressure on the door label. Automakers want you to enjoy the soft ride, but it costs you money at the pump.

If your Brakes are dragging it will make a difference. The rear wheels are 2 brakes in one. The Emergency brakes are harder to inspect. Your car is 5 Years old and if you have not had Brake work done, parts may be rusted and not fully retracted.

These are the basics, I think the basics will go along ways into restoring your mileage. The newer cars have more Electronics which are good for keeping an Engine in Tune. Unless you get a "Checklight" most of the potential problems are those which are not monitored. Like tire pressure, clean filters, and Brakes.

Mar 22, 2011 | 2006 Mercury Milan

1 Answer

2007 Mercury Milan Premier V6 ac compressor clutch won't engage. Fuses and relays are ok. Pressure switch checks out ok. What could cause the problem?

you may need to top up the coolant,r112,r140or what ever the car is useing. if the car can'nt be topped up then you have a leak that needs to be fixed,usually the drier.

Oct 14, 2009 | 2007 Mercury Milan V6 AWD Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

77932 Answers


Level 3 Expert

5648 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides