Question about Hyundai XG350

Open Question

Need to replace a air intake temperature sensor on a 2003 Hyundai XG350 where is the location of it

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 37 Answers

SOURCE: Can't locate Intake Air Temperature Sensor Connector

The IAT is integrated with the MAF (Mass Air Flow) sensor all one unit the following diagram should help

Posted on Dec 06, 2008

  • 2984 Answers

SOURCE: intake air temperature sensor 02 hyundai elantra is also called the MAP-Manifold Absolute Pressure sensor...


Posted on Mar 31, 2009

  • 1 Answer

SOURCE: Air charge temperature sensor replacement

There are two of them. I mean sensors. One of them is IAT and another is Mass Air sensor ! But which one , where I don't know. Somebody help please !!!

Posted on Apr 03, 2009

  • 169 Answers

SOURCE: sensor locations

air intake look at snorkel it could be part of mass air flow check intake for eng coolant

Posted on Aug 29, 2009

  • 2984 Answers

SOURCE: I need to replace a fuel filter for a 2003 hyundai

Please don't forget to rate!!!

NOTE The fuel filter is located underneath the car, near the fuel tank.

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter
Fig. Remove the fuel filter

  1. Install or connect the following:

    Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
  2. Start the engine, check leaks and repair if necessary.

Posted on Oct 09, 2009

Testimonial: "great help, thxx "

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Air intake temp high code on 2003 hyundai elantra

Try cleaning the max flow sensor or if it has an air intake temperature sensor. These are located after the air filter box on the large flexible line. Use clean or that is safe for mass sensors available at auto parts store.

Sep 19, 2017 | Hyundai Cars & Trucks

1 Answer

Change crank sensor in 2004 Hyundai xg350

Some of these are hard to locate (I don't know your engine) but parts stores have component location charts. On some engines you have to look down through the intake manifold runners to see it, and reaching it to replace can require laying on top of the engine with your hands working blind. Others can be accessed from underneath.

Jul 06, 2016 | 2004 Hyundai XG350

1 Answer

Where do I locate the air intake temperature sensor for 2003 hyundai accent?

These are usually in or near the intake air filter box or pipe.

Aug 02, 2015 | Hyundai Cars & Trucks

1 Answer

Check engine lght on and 2 codes p0103 and p0112

P0103 HYUNDAI - Mass or Volume Air Flow Circuit High InputPossible causes- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks
- Faulty mass air flow sensor
Tech notesBefore replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
P0112 HYUNDAI - Intake Air Temperature Sensor 1 Circuit Low InputPossible causes- Dirty air filter
- Intake air temperature (IAT) sensor harness is open or shorted
- Intake air temperature (IAT) sensor electrical circuit poor connection
- Faulty intake air temperature sensor
When is the code detected?An excessively low voltage from the sensor is sent to ECM.

Jun 08, 2012 | 2001 Hyundai Accent

1 Answer

Where is the speed sensor located on a hyundai xg350 and how do I replace it?

There is a speed sensor at each wheel, usually mounted on the knuckle or as an integral part of the hub and bearing assembly.

Jan 11, 2010 | Hyundai Motor 2003 XG350

1 Answer

Crank sensor and timing belt related?

Its possible, was the crank sensor physically damaged or just an internal failure. That would determine if it was a coincidence or not.

Oct 24, 2009 | Hyundai Motor 2003 XG350

1 Answer

Sensor locations

air intake look at snorkel it could be part of mass air flow check intake for eng coolant

Aug 29, 2009 | 2003 Ford F150 Regular Cab

1 Answer

I have a 2003 hyundai XG350 its really hard to start after it sits 10 mins or longer. Had dealer check it out. they said all the sensors are OK they replaced the fuel pump 3 times still the same problem....

First and foremost, has anyone VERIFIED that the CAUSE is the fuel pump? Hard starting has NUMEROUS possible causes -- wiring, connectors, sensors (MAF, MAP, TPS, APS, ETS Motor, IAT, ECT, CKP, CMP, etc.), injectors, timing, air flow, fuel pressure, contaminated fuel, vacuum leaks, Powertrain Control Module (PCM - garbage in memory - adaptives), The more sofisticated the technology, the more COMPLEX the diagnosis. It seems you have an INTERMITTENT malfunction in one (or more) EMS (Engine Management System) components. The only way to diagnosis this is when that particular component acts up! My first suspicion is the MAF (Mass Air Flow Sensor w/Intake Air Temperature Sensor-IAT and/or the Engine Coolant Temperature (ECT) sensor. The possibility also exists that the technician who examined/inspected your vehicle wasn't the swiftest of mechanics - meaning he/she didn't fully understand what they were looking at/testing. Hyundai Shop Manuals aren't the best either. There's no possible way for me to DIAGNOSE your problem without PHYSICALLY examining your vehicle. SEVERAL SOLUTIONS: You can educate yourself regarding the systems installed on your vehicle & attempt to fix it yourself -- Go to and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle. OR, you can take the vehicle back to the Hyundai Service Center (dealership), and tell them to FIX IT! OR, hire an attorney & file a lawsuit. The latter being the last resort.

Feb 26, 2009 | Hyundai Motor 2003 XG350

2 Answers

Check engine code 0113

You failed to give the model year which could have an influence on the accuracy of this answer:

" IAT Sensor 1 Circuit High Input"

Stolen from another forum:

"Intake Air Temperature (IAT) Sensor

The intake air temperature sensor (IAT sensor) changes resistance in response to intake air temperature. The IAT sensor resistance decreases as the surrounding air temperature increases. This provides a signal to the PCM indicating temperature of the incoming intake air."

Aug 27, 2008 | Hyundai Elantra Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides