Question about Cars & Trucks

Open Question

Dog collapsed for a minute screamed out then came back round what could have happened

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 lincoln continental screams when started what's wrong.


It's probably one of the belts that is defected or needs to be replaced. When are car screams when being started 99% of the time it's a belt. Try that and see what happens

Jun 12, 2012 | 2000 Lincoln Continental

1 Answer

Need diagram for 1997 toyota camry 2.2 timing marks


Quick fix timing TDCproblem 0. Jack up car on passenger's side, block up for safety. 1. Remove tire #17 lug bolts
2. Remove skirt #10 2 bolts
3. Set crank to TDC "0" #17 bolt on crankshaft. 4. Loosen Power steering pump adjuster bolt #14 remove beltoff pulley. 5. Push PS pump back to fire wall far as possible. 6. Remove both bolts lower dog bone #14 bolts. they are a dog to get off.
6b step one withbraker bar get them loose. 6c Get smaller 1/4" socket wrench to fit on it. #14 1/4 to slip on it in a tight place. 6d Removebolts. Put in lower bone bolts in a cup for i.d.
7. Remove upper dog bolts. Put it upper dog bone cup. 8. Take out dog bone. parts 9. Remove bolts holding in upper timing belt cover. put intiming belt cover cup. 10. Remove upper timing belt cover. Yellow 11. unlock tichner #14 push down on tinchner lock it to makeloose belt. remove thespring with needle nose pliers if it makes it eazy. 12 MOVE CAM TO SEE THE HOLE AND THE ROUND HOLE BEHIND IT,NOT THE OTHER MARK.AS THE BOOK SAYS. THE ROUND HOLE IS ABOUT 5DEG BEFORE THESLIT MARK THAT YOU DON'T WANT TO USE. 13 SLIP THE BELT BACK ON CENTER THE TENCHIN ON THE BELT INBOTH DIRECTIONS FROMTHE CAM SHAFT. ONE TOOTH BACK OF FOWARD RECHECK CAM ANDCRANK MARKS. TIGHTEN IT UP TIME. 14 RELEACE TISHINGNER, TIGHTEN BELT PUSH CAM TO THE LEFT. TO GET TIGHT INBOTH DIRECTIONS TEST FOR PLUCK TONE. 15 START UP CHK TIMING WITH LIGHT. 16 BUT POWER STERING PUMP BACK TIGHT. 17 PUT TIMING COVER BACK ON 18 REINSTALL DOG BONE 19 PUT SKRIT BACK ON 20 PUT TIRE BACK ON. TEST IT ON 3 TRIPS.

Oct 13, 2010 | Toyota Camry Cars & Trucks

1 Answer

High screaming noise when drivers side wndow up,


a 2007 shouldnt need a new seal.
i would adjust the door in a pinch.

Jul 22, 2010 | 2007 Chevrolet Aveo Sedan

1 Answer

Front suspensin on a w124 merecedes collapsed


The upper mounting bracket of these are known to corrode and fall apart. I am glad you were not driving when this happened. A weld shop may be able to repair and replace the spring after repairing.

Apr 06, 2010 | Mercedes-Benz E-Class Cars & Trucks

1 Answer

2000 ford ranger 3.0 v6 engine.coolant being forced into the reservior and both top and bottom hoses at radiator are collapsing.i have replaced the thermostat.whats could be problem


It's normal for some fluid to be forced into the reservoir during operation due to fluid expansion and pressure. Usually the fluid in the reservoir will increase or decrease depending on what temperature the engine is at. Unless your truck is overheating I woudn't worry too much; just make sure the fluid level doesn't get too low or too high in the reservoir. If it is running hotter than normal and excessive amounts of fluid are being forced in to the reservoir you might have a blown head gasket. As far as the hoses collapsing; I have a 2001 Ford ranger 4.0 V6 and I noticed that the top radiator hose appeared to be collapsing in one of its bends. I installed a radiator clamp on the hose at that spot just to keep it round and from pinching itself off. It probably happens from the heat; just keep an eye on it. It may be that your hoses need replacing; I know mine did the same thing after just having been installed brand new though. God bless you and I hope everything works out for the best!!! : )

Apr 04, 2010 | 2000 Ford Ranger SuperCab

1 Answer

2000 olds intrigue ticking


probably a rocker arm out of ajustment or a collapsed or failed lifter. would have the valve covers pulled and the rocker arms felt of

Jan 06, 2010 | 1999 Oldsmobile Intrigue

1 Answer

91 S-10 it has a high pitch scream


It sounds like a worn or loose fan belt. It's slipping on the pulleys causing the screeching noise.

Nov 22, 2009 | 1991 Chevrolet S-10

2 Answers

Bike Keeps Dieing out


1.if your bike screaming at high rpm and didint go fast.check
1.is your pulley is fix the same as it was before?
2.your drive belt in the wrong directional way
3.clean and check your carb and also dont forget to check your fuel pump
4.lack of cooling system or malfuntion can lead to engine stall

Apr 18, 2009 | 2000 Ford Focus

1 Answer

Will not start after it stalls untill about 5-10 minutes


This sounds like a plugged evap valve. Try opening the gas cap when this happens. If the evap system is malfunctioning, it will use gas, but will not let air back in to replace the liquid leaving the tank thus collapsing the tank and cutting off fuel. It then takes a while to break the vacuum in the tank. If the car starts right away when you open the gas cap, have your evap system serviced by a professional. Another quick diagnosis is to take a look at the fuel tank. If it has been collapsed there will be small creases in it.

I just had this problem on a 97 Saturn.

Jan 09, 2009 | 1999 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...