Question about Ford Cars & Trucks

Open Question

Coolant Thermostat Location ,2002 ZX2 Ford Escort , Manual Transmission , 2.0 Engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: how to change thermostat in 2001 ford escort zx2

the thermostat is on the front right side just below the air tube (which you have to remove) in a black hard plastic case. It is a PAIN IN THE ARSE to get to, it will have 2 sensors sticking out of it, on on the bottom, one on the side.

Posted on Oct 18, 2008

chuck943
  • 783 Answers

SOURCE: Is the 2001 Ford escort ZX2 L4-2.0L DOHC engine

All of Ford's belt driven engines are non-interference with the exception of the 3.0L villager which was really a nissan.

Posted on May 12, 2009

  • 16 Answers

SOURCE: 2002 ford escort zx2 camshaft sensor fit a 99 zx2?

Yes, All the years of the ZX2 utilize the same engine. 1998-2003 are all the same except for ECU programing and the MAF wiring. You should not have a problem.

Posted on Jul 31, 2009

  • 1596 Answers

SOURCE: I have a 2002 Ford Escort ZX2. The Auto store

This CODE is Indicating that ENGINE COOLANT TEMP is NOT Reaching TEMP HOT Enough to >CLOSE LOOP < This is when ECM takes over ALL ELECTRONIC CONTROLS, . It Basicly Points at A Coolant Temp Sensor that is Faulty or Thermostat that is RATED too LOW. Engine Must Reach 200 - 220 degrees

Posted on Aug 28, 2009

ZX2Fast
  • 547 Answers

SOURCE: LOCATION OF PCV VALVE ON 2002 FORD ESCORT ZX2

Looking from the front of the car, start at the thermostat housing (where the top radiator hose goes) and go down from there. Located right next to the exhaust mannifold you'll see the hose going to the PCV valve.

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is causing coolant loss ON 2002 FORD ESCORT ZX2


Did you check the front floor board,heater core could be leaking?

May 24, 2015 | 2002 Ford Escort

1 Answer

2002 ford zx2 - dash and park lights out, where do i find the fuse for both to replace.


this 2002 Ford Escort ZX2 should have an owners manual in your glovebox

if not, here's a link in pdf form for it!

http://www.fordservicecontent.com/Ford_Content/catalog/owner_guides/02estog3e.pdf

now scroll to page 123 to see the diagram

look at TAIL ~ 15 amp blue fuse

this is inside the passenger compartment, not the one in the underhood bay

Fuse box location in 1998 Ford Escort

mark as helpful since i do this for fun only (not for profit) thanks!

1997 2003 Ford Escort Interior Fuse Check 2002 Ford Escort ZX2 2 0L 4 Cyl

Apr 18, 2015 | 2002 Ford ZX2

1 Answer

Location of engine coolant temperature sensor


Automobiles: 2000 Ford Escort ZX2 4-cylinder 2.0L MFI DOHC

NOTE
The "left" side of the engine is the driver's side.

The Engine Coolant Temperature (ECT) sensor is a thermistor (a device which changes resistance or voltage as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM (Powertrain Control Module - aka "the car's computer").

The ECT sensor is mounted in the following locations (small Ford engines):

1.8L engines: in the cylinder head
1.9L engines: threaded into the heater hose inlet pipe
2.0L engines: at the left rear of the engine

2.0L Zetec Engine

(1) Partially drain the engine cooling system using a clean container. If coolant is in good condition, retain for reuse.
(2) Disconnect the battery ground cable.
(3) Disconnect the electrical wiring connector from the engine coolant temperature (ECT) sensor.
(4) Remove the retaining clip and the ECT sensor.


12_5_2011_5_38_05_pm.jpg

Fig. 1 Escort ZX2 ECT sensor - The retaining clip is removed (at the solid arrow). Withdraw ECT sensor by gently wiggling/pulling in the direction of the dashed arrow.

To install:

NOTE
Coat the ECT sensor O-ring with clean coolant prior to installation.

(1) Replace the retaining clip and the ECT sensor.
(2) Connect the electrical wiring connector from the Engine Coolant Temperature (ECT) sensor.
(3) Connect the battery ground cable.
(4) Refill the engine cooling system. An inexpensive plastic "Radiator Funnel" will help with this task.

Dec 05, 2011 | 2000 Ford Escort

1 Answer

I have a 2002 Ford ZX-2 Escort with a manual transmission. Does the filter get changed the same way as an automatic transmission.


Hi there!

Manual Transmission doesn't have a filter in the transmission, you only change oil thats it and it and it doesn't have a Pan either. Good luck

Jul 22, 2011 | 2002 Ford ZX2

2 Answers

I have a 2002 Ford Escort ZX2. The Auto store


This CODE is Indicating that ENGINE COOLANT TEMP is NOT Reaching TEMP HOT Enough to >CLOSE LOOP < This is when ECM takes over ALL ELECTRONIC CONTROLS, . It Basicly Points at A Coolant Temp Sensor that is Faulty or Thermostat that is RATED too LOW. Engine Must Reach 200 - 220 degrees

Aug 28, 2009 | 2002 Ford ZX2

1 Answer

Manual Transmission fluid for Ford Escort ZX2


I know this sounds crazy according to Ford:

You can use-
Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX MERCON® Alternative Transaxle Fluid - SAE 75W90 Gear Oil F32Z-19C547-MA API GL-4
You are seeing that right, one instance they call for 75W90 and the other it is ATF. It is ok to run either, 75W90 will give you smoother shifts and less noise.

This transmission is filled through the VSS (Vehicle Speed Sensor) hole.

Mar 28, 2009 | 2001 Ford Escort ZX2

1 Answer

Thermostat


follow the upper hose to the housing it goes to and if you see bolts there the thermostat should be under it. make sure to have coolant on hand as you will loose some.

Feb 23, 2009 | 2002 Ford ZX2

1 Answer

Changeing a theromstat sensor


Follow the top radiator hose to a metel housing that the hose is attached to at the engine. There is usually 2 bolts that hold the thermostat house on.

Feb 05, 2009 | 2001 Ford Escort ZX2

3 Answers

Air won't blow


have you checked the fuses? there should be a fuse block inside the cab and another inside the engine compartment, refer to owners manual for exact location,

Nov 30, 2008 | 2002 Ford ZX2

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...