Question about Hyundai Cars & Trucks

Open Question

2004 hyundai santa fe fuel pump wiring issue.

The wires pulled out of the 4 wire connector on the pump wring harness need to know locations at the connector,spade terminals are still attached to the wires. Was changing fuel tank when this happened.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
steve_baldam
  • 52 Answers

SOURCE: Need help with 2004 Hyundai Santa Fe Audio Wiring

Sounds like you need a light tester. I would guess that at least 8 of the wires are speaker + & - the others will be Main power and earth Possibly electric ariel, Memory store and a wire for the anti theft circuit. Assuming the stereo is factory. Any Audio shop can perform a test to clarify the purpose of the wires Wouldnt worry about the blank its probably a position for a newer or different model to yours. Steve in the UK

Posted on May 13, 2009

Ad
rutherford_m
  • 63 Answers

SOURCE: While pulling a trailer the trailer lights wire

I am not completely familiar with that make and model but I believe you will find the fuse you are looking for under the hood. There should be an accessible fuse/relay box located normally on the same side of the vehicle as the battery. If you have an owners manual for the vehicle that should have a layout of the box. If not, then a voltmeter can be used to find the blown fuse.

Posted on Apr 27, 2010

catbob007
  • 70 Answers

SOURCE: fuel pump wiring

Not sugestable

Posted on May 27, 2010

  • 7353 Answers

SOURCE: i need a free wiring diagram for a 1998 chevy

Black/white is A,........ Green is B ......and Gray is C

Posted on Jul 24, 2010

  • 1 Answer

SOURCE: 2006 hyundai santa fe stereo wiring color code

I was given two Lanzar 6.5 and two Pioneer 6.5 speakers. There is nothing wrong with my stock speakers, I just wanted to add a little more thump and clarity. I took off the front drivers side interior panel, Which wasn't all that bad, but i'm having major problems putting it back together. I'll get into that a bit later. I figured swapping the old for the new would be simple. Being it has two wires (pos/neg) going to the driver/speaker cone and two wires going to the tweeter portion that goes over the lower part, four wires total. The wires are White, Brown, yellow, and Black going into a black clip, then they turn black coming out the other side. I cut the four after the clip. My new speakers have only two posts to accommodate the driver and tweeter. So I left off the two for the tweeter and it sounded awful. I tried combining the two positive and two negative and hooking it up that way. That too sounded awful. The tweeter was squealing and chirping. I tried every configuration. They all sounded like ***. What am I doing wrong. I know people swap out stocks for after market all the time. I wanted to be sure my new speaker wasn't defective, so I tried all four (Both brands) with the same results. So I gave up and put the original back in. It sounds fine, just like it had before. But now I can't put the door panel back on. I know it's just tricky and i need more patience. I'm so bummed. I have these great speakers and have no idea why I can't install them. Do I need some aftermarket clip? It seems so easy, why is it so flappin hard? I've done this with other cars in the past with no issues. This four wire thing is killing me... Please HELP ME!!!!!!!!

Posted on Jan 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyundai Santa Fe 2004 Tracking device Installation. Where to find the constant power source and where to ground?


Specific installation information would depend upon the planned installation location

Jul 14, 2017 | 2004 Hyundai Santa Fe

1 Answer

What is the pinout for this radio that was in a Hyundai Santa Fe 2005?


Do you need Wiring Diagram for hyundai santa fe.Or you need where the radio fits in hyundai santa.The connector of radio.
Please Check the link mentioned below it has all wiring diagram for hyundai santa fe radio.Also it has details for how to connect radio connector.
http://www.allcarhelp.com/2016/05/hyundai-santa-fe-radio-wiring-diagram.html

If you need anything else,please reply.
Thanks.

May 11, 2016 | Hyundai Cars & Trucks

1 Answer

Install rear backup camera


PYLE, 3.5 MONITOR INSTALLATION INSTRUCTIONS, INSTALLED IN SUV. As others have mentioned ThePyle Instructions are pretty much non-existant. As a formerly ASE Certified mechanic I am posting this to try to help others.THE PYLE KIT: Monitor + Camera Mount + Wiring Harness for hard wiring into vehicle electrical. --- Additional Materials Required to Install: 3ea. coils of automotive 18 ga. wire. One red, one black, and one white. 1/8" non insulated wire but connectors, wire shrink wrap (1/4", 3/16\', 5/16" AND 3/8" best to get assort. pack). Self taping sheet metal screws 1/2" long. Roll of electrical tape, Barbed Butt Connectors (2ea.- see illustration wiring Monitor posted this site). Rubber wire grommet 3/8" outside, 1/8" for wire, 1ea. req. Pull ties. --- Tools Required: Utility Knife, Drill w. phillips bit driver, wire tripper, volt meter, small pry bar. + Misc. ---

Mar 16, 2013 | 2004 Hyundai Santa Fe

1 Answer

Hyundai santa fe 2004 how can i install two front seat,


2 bolts in each of the seats' floor rails... total of 8. Wire harness connectors may not be the same power seat control harness, seat heaters, etc. Research of connectors shows floor harness connectors are identical between 04 & 05. However, optional features like seat warmers in the wire harness of the 05 model may not exist in the other and vise versa.

Sep 03, 2009 | 2004 Hyundai Santa Fe

1 Answer

I need some guidance as to how to replace the windsheild washer pump on the 2004 Hyundai Santa Fe


unhook the negitive battery terminal, then simply take the bolts out holding the pump on and unplug the wire harness and hose and replace new one. it may be easier if you take out the whole washer tank to get at it. usually 3 bolts.

Aug 08, 2009 | 2004 Hyundai Santa Fe

1 Answer

Are 08 hyundai santa fe and tucson desame stereo wiring harness?


NOPE! . Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Jun 29, 2009 | 2004 Hyundai Santa Fe

1 Answer

Need help with 2004 Hyundai Santa Fe Audio Wiring


Sounds like you need a light tester. I would guess that at least 8 of the wires are speaker + & - the others will be Main power and earth Possibly electric ariel, Memory store and a wire for the anti theft circuit. Assuming the stereo is factory. Any Audio shop can perform a test to clarify the purpose of the wires Wouldnt worry about the blank its probably a position for a newer or different model to yours. Steve in the UK

May 13, 2009 | 2004 Hyundai Santa Fe

1 Answer

Interior fan control knob doesn't work


you have to remove the AC panel from the back side... the virtical console pops out and you can disconnect it (wire harness connectors) to get to it.

May 07, 2009 | 2004 Hyundai Santa Fe

1 Answer

Steps to remove radio


  • Step 1:Disconnect the negative cable from the battery terminal. Position the cable to is doesn't come in contact with any metal parts.

  • Step 2:Pull out the ashtray and remove the two screws that connect the bezel around the radio. Pull off the climate control knobs and remove the two screws at the top of the bezel trim.

  • Step 3:Remove the trim and disconnecting any wires. Not all models will have connecting wires on the trim.

  • Step 4:Locate the two screws, one on each side of the Hyundai Santa Fe stereo, and pull the head unit out of the dash. Disconnect the wires behind the radio.



  • Thanks for using FixYa - a FixYa rating is appreciated!!

    Feb 20, 2009 | 2004 Hyundai Santa Fe

    2 Answers

    Fog Light Replacement Hyundai Santa Fe


    The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

    Jan 29, 2009 | 2004 Hyundai Santa Fe

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    27 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Hyundai Experts

    yadayada
    yadayada

    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8548 Answers

    Are you a Hyundai Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...