Question about Cars & Trucks

Open Question

Help me find where these ground wires go.

98 Chevy Malibu, 3.1. Replaced head gasket have 2 extra wires. Lookalike grounds. won't start.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
moparownr
  • 667 Answers

SOURCE: Taillights are not working

check for voltage in the socket. positive is the center connection. if you have no voltage there, then you may be right. Make sure that you check the wires.

Posted on Mar 23, 2009

Ad
  • 103 Answers

SOURCE: fuel level sensor ground crossed with fuel pump ground

i think the ground wire going to the gauge is black/white stripe and solid black is pump ground the bigger gauge wires r pump wires and the smaller gauge wires go to the fuel guage

Posted on Mar 17, 2010

reisdos
  • 1297 Answers

SOURCE: 99 Chevy Lumina won`t start

do mean that the plugs are firing even though the engine is not cranking?

Posted on Apr 24, 2010

  • 5522 Answers

SOURCE: My 1999 Chevy Malibu is losing the coolant though the overflow hose by the resevior I've had my head gaskets replaced there is no overheating no water oil mix, but my radiator fans arent working I

Sounds like you need to disconnect the Radiators' electric fans and have them tested. You absolutely must have them working, or your car will overheat. Check to see if the Temperature guage is working.

You need to go to a good autoparts store and have them test the fans and charge and test your battery. You may need some sensors to activate the Radiator fans, but you could be running the battery down with shorted cooling fans.

There are also Relays which work with the Radiator fans. The overflow will stabilize once the water gets into where it belongs. Make sure your Thermostat is not clogged with the sealer.

Posted on Jan 15, 2012

  • 560 Answers

SOURCE: engine wiring diagram 2000 malibu

plug it all in were it was chief

Posted on Jun 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 98 Chevy Malibu My car was hit on the driver side weeks later the headlight stopped working I replaced the whole headlight nd bulbs The auto low or high beams work but only in one head light


You may need to change the wiring harness.

2000 malibu headlight problem - Tech Support Forum

www.techsupportforum.com > ... > Automotive Support

Dec 14, 2008 - 8 posts - ‎2 authors
I have a 2000 chevy malibu with headlight problems. ... High beams work correctly.... I suspect a ground problem but cannot locate the ground cluster. ... Grouped together there, one pink wire to the Headlamp Switch, and one to ... my Wife's car has lowbeam on the left side that just won't work and now the ...

Dec 20, 2015 | Cars & Trucks

1 Answer

1997 Chevy Malibu engine fans not coming on-relays are testing fine-ETC sensor and wiring already replaced. Not overheating but WANTS TO...I stop car when temp reaches next mark after halfway on dash...


There are three relays in the underhood electrical center. They are directly controlled the the PCM. The PCM gets it's information from the coolant temp switch that is on the engine. On the PCM, Pin 54(dark green wire) in connector C2 controls the ground to the relay 1. Pin 59(dark blue wire) on the same connector controls the ground to relay 2. If you supply a ground to these, you will turn the fans on. What you need to figure out is if the ECT is telling the PCM what the temp is, (more likely cause) or you have a PCM malfunction(least likely cause).

Oct 25, 2013 | 1998 Chevrolet Malibu

1 Answer

Why won't the front turn signal work? I just replaced the entire headlamp assembly on 2005 Chevy Malibu.


is turn signal plugged in?
if this is a new bulb try the old one to make sure bulb is not at fault
then need to check the voltage at the connector.
A test light is easiest way from a good ground to each terminal.
if flashing the ground connection could be corroded.
if nothing at connector try the connection at the turn signal switch.

Feb 24, 2013 | Chevrolet Malibu Cars & Trucks

1 Answer

98 Chevy Malibu won't start after replacing thermostat?


replace thermostat did bleed coolant system check coolant level.because if not engine could have overheated and blowed headgaskets warp or cracked the heads check engine compression.sound like engine got too hot.

Jan 08, 2013 | 1998 Chevrolet Malibu

2 Answers

My 03 POS Malibu has had $4,000 in repairs the last few years. Now it won't start after driving! Have to wait an hour or so.


Are there any lights on the dash when this happens? Look for a light that says security or antitheft. If you see this, go to this link. That would explain the symptoms

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Dec 19, 2011 | 2003 Chevrolet Malibu

1 Answer

2002 chevy silverado won't start, replaced fuel pump, still won't start


Same problem here, found break in wiring harness at cross-member behind cab. did have bed removed for easy access. Ground wire guilty party.

Dec 18, 2011 | 2002 Chevrolet Silverado

1 Answer

1998 chevy malibu fuse question


Sounds like you have a ground problem, i doubt its in the sending units as both gauges are acting strange work, seeing that electricity likes paths of least resistance one gauge could be grounding through another. Bad grounds wreak havoc on electrical systems.

Feb 25, 2009 | 1998 Chevrolet Malibu

2 Answers

Cylinder 2 and 3 are misfiring


do you had prestone to the engine if ignition is good injector to you might have a blown head gasket check compression the gasket may be broken beetween the 2 cylinder good luck pierre

Feb 24, 2009 | 1995 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...