Question about Subaru Cars & Trucks

1 Answer

What does the fuel relay look like for 1992 Subaru brumby

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 197 Answers

what does the fuel relay look like for 1992 Subaru - s1-vwa2dnea31szm5gymbnnseny-1-0.png

Posted on May 06, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the valve clearances on a '92 Subaru Brumby please


valve clearance
inlet 0.23- 0.27
exhaust 0.33- 0.37

Jul 17, 2016 | Subaru Cars & Trucks

1 Answer

What is the valve clearance for a subaru brumby


most valve clearence 0002-0005 should be good in this range ,

Sep 15, 2014 | Cars & Trucks

1 Answer

92 subaru loyale new distributor and coil still no spark


Had the exact same problem and went through the whole dance. Traced problem to relay under the dash , combination ignition/fuel pump relay. The relay was "clicking" but was internally bad, it would not engage circuit for the ignition. Power was indicated at coil and fuel pump would run but the circuit was not complete through the computer to power the ignition sensor in the distributor. I actually had to "gang" 2- 12 vdc coil automotive relays to replace the original relay. Caution... if you decide to gang 2 relays be sure to separate the two circuits, one relay for ignition, one for fuel pump and tie the coil wires together.

Feb 17, 2014 | 1992 Subaru Loyale

1 Answer

1992 subaru loyale fuel pump relay location


The fuel pump relay is driver side, under dash, above brake pedal, mounted in steering column support bracket on 1991 Loyale this relay also performs an ignition system function

Jan 26, 2014 | 1992 Subaru Loyale

1 Answer

My 1992 Subaru Brumby Ute stalls each time I pull up or stop.


expose the carburetor throat and start the engine keeping it running with your hand on the throttle. try and control the idle at its lowest possible rpm and look inside the throat. if it is showing ANY dripping fuel or even wet flaps then it is stalling because of too much fuel and the carb. will have to be cleaned or serviced.

Mar 30, 2013 | Cars & Trucks

1 Answer

I have a 92 Subaru Loyale, It tries to start, but wont. It has spark, and I replaced the fuel filter. Any suggestions?


Are you getting fuel need to check left side fuel rail push pin in if you get fuel your ok if not need to check fuse and check relay under hood make sure your ware glasses lots of presure dont need gas in the eyes oh key on

Mar 30, 2011 | 1992 Subaru Loyale

1 Answer

93 subaru leg wagion fuel pump problem


The fuel pump relay is located under the dash on the drivers side. The fuel pump relay is green and it should be next to a brown relay for the ignition.

May 22, 2010 | 1992 Subaru Legacy

1 Answer

Manual for subaru brumby 4x4 ute 1985


Look on Ebay for a manual for this car. Anything late year you can find, but I doubt you'll find it online unless you get lucky. Hope this helps, good luck!

Jan 16, 2010 | 1985 Subaru Brat

2 Answers

I have a 19992 Subaru Brumby which loses ignition spark


its quite possibly the crank angle sensor as they do this when they heat up,the car wont start,till it cools down,you can get the resistance checked on it to see if its ok,but you will need someone with experience to do it but its not a hard job

Nov 11, 2009 | 1993 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...