Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hook up a gas pressure gauge to the schrader valve. should be 50-60psi. If it doesnt have any, check relays, fuses. When you replaced the fuel pump you should have checked for 12V to the pump to confirm it was bad. I am assuming you did this. If not its worth checking again. If you dont have 12v its probably a fuse, relay, or wiring problem. Possibly bad ground?
Posted on May 03, 2009
so many possibilities...
does it roll fairly freely? (checking to see if the brakes or rearend seized up)
Are there any "bad" sounds like things grinding? (Connection between Motor and rearend, axle splines...)
If all that is solid, it is likely in the controller.... (it takes a solid charge right... No bad batteries in there or loose connection? might want to check all the battery connections to make sure none are burnt...)
1997.. does it have the electonic speed control by that year? the other possibilty is that the accelerator is not working corectly. they used a resistor system on old ones that has contactors that would get worn out.... Newer ones control a potentiometer(sp) that controlled the speed.
Only a few real components to check, but if you are not mechanically and electically inclined, could be tough to isolate.
Posted on Mar 07, 2010
Most people do not trust the old oil pump used on the 3PG models, me included. Mix 50:1 and you can be sure that the piston and crank will not seize up.
Posted on Apr 22, 2010
SOURCE: EZGO golf cart won't go forward
Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.
Posted on Apr 24, 2010
Tips for a great answer:
Jun 05, 2017 | Cars & Trucks
Jan 10, 2016 | Cars & Trucks
Sep 08, 2015 | Cars & Trucks
Aug 02, 2015 | Cars & Trucks
Sep 02, 2014 | Cars & Trucks
Jun 09, 2014 | 1995 Mitsubishi Mirage
May 17, 2014 | 1993 Acura Vigor
Sep 26, 2009 | 2006 Dodge Caravan
15 people viewed this question
Usually answered in minutes!