Question about Ford Cars & Trucks

Open Question

I downloaded a Haynes 1997 Ford Windstar repair manual pdf several times but later when I go back it's gone. Where can I get it again? Cause I don't remember t. Thank you, Stephen

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chuck943
  • 783 Answers

SOURCE: Ford windstar OBD II code P1537/38, P0171 and P0420

It could all be related.P1537/38 are the intake manifold runner controls are stuck open.They are controlled by vacuum solenoids.The P0171 is bank one of the engine is running lean,usually caused by a vacuum leak, P0420 is catalytic converter efficiency code. The computer monitors the switch rate of the front 02 sensors and compares it to the switch rate of the rear 02 sensors to tell if catalytic converter is doing its job. Now if the front 02 is not switching properly then this will cause this test to fail and set this code.
Look on bottom section of the intake manifold at the back of engine(where tranny bolts up) you should see the vacuum motors there on the intake,these are the control motors for the intake manifold runners.Make sure the vacuum lines are hooked up and lines are not leaking. Also you will see a lever from it to intake make sure they move and are not binding.

Posted on Mar 11, 2009

  • 1 Answer

SOURCE: 2003 Ford Windstar Power Window Failure

I have the same issue, but mine got a little worse as time went on. I got a new motor for and when I took the door apart I had to lower the window. so I had to plug the switches back in, and what do you know it started working. so I tested for 15 mins stiaght and it statred working every time I pushed the button. So, I would try that first before you spend over $70 dollars just for the part.

Posted on Jun 07, 2009

  • 239 Answers

SOURCE: 1996/1997 Ford Windstar Audio wiring diagram

1997 Ford Windstar Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Green/Violet
Car Radio Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Brown/White
Left Rear Speaker Negative Wire (-): Light Brown/Yellow
Right Rear Speaker Positive Wire (+): Light Brown/Green
Right Rear Speaker Negative Wire (-): Brown/Pink

96 and 97 are the same

Posted on Aug 18, 2010

jewag26
  • 1 Answer

SOURCE: 1997 Ford Explorer Vacuum diagram

my ford explorer engine is running weak and i'm losing a lot of gas milage..

Posted on Jan 15, 2012

SOURCE: Looking for Service Repair Manual Jeep Wrangler YJ

I know auto zone lets you view them on there website,but i dont think you can download it.

Posted on Feb 26, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Were can i get a manual to change a timing chain on a ford explorer 1997. i want to change the chain myself but need a manual


You can get the Haynes repair manual on your vehicle from your local auto zone or advance auto parts stores.

Aug 08, 2010 | 1997 Ford Explorer AWD

1 Answer

Replacing the regulator and motor in the drivers door


There are several steps involved in this. I recommend you get the Haynes Repair Manual for your vehicle for this job. It has step by step instructions on how to do this repair.

Jun 25, 2010 | 2000 Ford Windstar

1 Answer

I want to change the speakers of the front of the windstar how should i disamble it??


There should be 4 speakers actually. 2 in the doors and 2 in the dash. Your best option is to get the Haynes repair manual for your vehicle. This manual will give you step by step instruction on how to remove them and reassemble the dash afterward.

Jan 21, 2010 | 1997 Ford Windstar

2 Answers

Power steering pump


How do you remove the power steering pump on a 1998 ford windstar? do you have a diagram? How many bolts need removing?

Jun 06, 2008 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...