Question about Dodge Cars & Trucks

Open Question

Need steering column wiring harness illustration for 2004 Dodge Intrepid SE

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: Short in steering column wiring

torque bit 20 to remove the air bag bolt in the back cover stering puller stering puller to push plate phillip screw driver that about it pierre

Posted on Oct 19, 2008

  • 15 Answers

SOURCE: 2004 Camry horn is not working

check for broken wires the neagative is by the horn button in the steering wheel has air bag ever been replaced in steering wheel if so the wire may have not been plugged in

Posted on Dec 27, 2008

nyspeter86
  • 81 Answers

SOURCE: 2004 Camry horn is not

How about ground. The horn must receive 12 volts and ground to work. If its getting both, change the horn.

Posted on Dec 27, 2008

jturcotte
  • 8138 Answers

SOURCE: wiring harness for 2004 dodge

2004 Dodge Ram 2500 Truck Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Pink
Car Radio Accessory Switched 12v+ Wire: Brown/Red
Car Radio Ground Wire: Black/Dark Green
Car Radio Illumination Wire: Orange/Dark Blue
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

Posted on Sep 12, 2010

  • 1 Answer

SOURCE: I need a steering column wiring diagram for a 1979 cj5

Black horn ground
lt.blue left front turn
blue right front turn
brown hazard power
purple turn signal power
yellow left rear turn
green right rear turn
white brake light input

Posted on Feb 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is airbag light on and my horn nor cruise control is not working now with my 2004 dodge intrepid


There are wires that run from under the dash, up the steering column to the steering wheel. They flex when the wheel turns. This wire harness is called a clock spring. When it breaks, everything connected to it in the steering wheel quits. They are about 180 USD

Jan 20, 2017 | Dodge Cars & Trucks

1 Answer

The insturments on the dash don't work and the heater blower runs all the time the lights on the insturment cluster work


I had a similar problem several years ago with my 1993 Dodge intrepid. None of the instruments on the dash would work. When this would happen the transmission would not shift past second gear. My heater blower was Not running all the time. What I found was the wiring harness to the ignition switch did not have enough slack in it. This was causing the ignition switch plug to randomly lose contact with the ignition switch. The first thing you need to do is remove the steering column covers. Put the tilt steering all the way up. Look under the steering column cover. There are 2 phillips head screws and 3 recessed T-10 torx tip screws that hold the 2 halves of the cover together and to the steering column. Remove all 5 screws. The handle used to tilt the steering wheel also has to be removed. You will need a T-30 torx tip to remove it. Now carefully remove the bottom half of the cover. The ignition switch wiring harness is under the steering column. I just reached in under the column and gently pulled on the harness until it had a little slack when I left go. Make sure the ignition switch plug is plugged in all the way. You might even want to unplug it and plug it back in several times just in case a slight film of corrosion has accumulated on any of the electrical terminals. This will help clean it off. You could also look inside the plug to make sure none of the terminals are bent or pushed part way out the back. I hope this solves your problem. Mine has not reoccurred in the 8 years since I did this.

Mar 14, 2011 | 1993 Dodge Intrepid

1 Answer

I need to know were the compter board that reads engine mileage located on the dodge imtrepid se 2004


It's part of the transmission control module, bolts up to the side of transmission, with a harness with about 10 or 12 pins, if it's remove it will have to be relearn, for transmission to work again.

Aug 30, 2010 | 2004 Dodge Intrepid

2 Answers

My 1996 dodge intrepid, while driving, will stop, just like turning the key off. all gauges go haywire. when the vehicle stands for about an hour it will restart fine.


This may be a wiring issue since electrical are affected other than the engine. Inspect the wiring harness first for loose connections or wires that may have open insulator or bad wires that needs replacing.

Mar 17, 2010 | 1996 Dodge Intrepid

1 Answer

Any guidance in changing a crank sensor in a dodge intrepid 2004 3.5 soho


disconnect wiring harness un bolt the old one install the opposite need more help e-me, Lee

Nov 15, 2009 | 2004 Dodge Intrepid

2 Answers

2004 dodge ram 3500 blower motor intermittant


remove steering column covers and check connections at ignition switch..had a truck recently at dealership with similar problem and connector at back of ignition switch was melted..wires were for blower motor and battery feed to switch..had to replace switch and connector/pigtail

Mar 25, 2009 | 2004 Dodge Ram 3500 Truck

1 Answer

The horn keeps going off what could be wrong


It could be the horn switch on the steering column. Disconnect the harness coming from the steering column at the bottom when the horn is blowing, if that stops the horn then the problem is the switch below the steering wheel

Jan 03, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...