Question about Cars & Trucks

Open Question

My MXQpro 4K box will not go on and I detect a burning smell at the power point

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery light Is on and I smell burning wires in my sant? fe. Any ideas?


I would suggest taking to a mechanic at this point. Anytime you smell burning wires, it's not a good sign. You could have a short somewhere that could potentially catch on fire.

Mar 02, 2015 | Cars & Trucks

1 Answer

I have 2001 ford ecpedition 4.6 with a code p0306 cylinder #6 miss fire but has a burning smell, why?


Chances are it had oil on it @ some point and it now has a small hairline Crack, the easiest way to Check this is to Spry water on it with a bottle Sprayer.You should notice a missfire @ this point when running the Engine and since it it is a coil the Plastic covering will burn and smell also, Check the Wire's to the Spark plugs as these are Probably the original fault.if the Electrical charge is not getting to the Plug then it backs up in the Coil.which will cause it to over heat and crack

Dec 14, 2014 | 2001 Ford Expedition

1 Answer

What's your problem?1996 chevy cavalier dash warning light has a red arrow pointing towards water and car smells like something is burning P


The light does it say Water? You are sure about this? Please have this checked by a mechanic asap,. if it is starting to run hot if you catch it early then you can avoid serious damage to the engine. The smell may be a leaking engine water pump or other component of the engines cooling sytstem.

Feb 29, 2012 | 1996 Chevrolet Cavalier

2 Answers

Battery or altanator? I have jumped the car and it has startedm but noticed that while driveing was not getting the responce power like before. After getting it home and parked smelled an oder like...


Hello! The (+) battery cable is touching chassis ground at one of two likely places...#1...At the connection to the starter motor...#2...at the underside of the power distribution center...There are two Red cables leaving the + battery post...One is going to the starter motor and the other to the Power Distribution Center...
First...Disconnect the (+) terminal from the battery..visually inspect the connection point at the starter motor...Insure it is not near or touching ground....Follow the smaller of the two Red leads to the distribution center...The cover has the word "Positive" and an arrow pointing to where that Red lead terminates...Check for signs of burning...Visually inspect the Red lead from the battery to where it connects to the distribution center...Remove and inspect the underside of the Distribution center for a contact point to ground...Send a comment with results...Guru...Saailer

Oct 31, 2011 | 1998 Plymouth Breeze

1 Answer

Burning smell whenever i pull off, go up steep hills or simply reverse up my drive


1) Check the brake pads all round. If a caliper is sticking (not retracting fully) then the pad will remain in contact with the disc rotor and gets very hot giving off burning smells. 2) If you have a manual transmission it could also be that your clutch is at the point of failing. A slipping clutch is indicated in gear the engine races irrespective of the the car accelerating along with a smell of burning.

Jun 16, 2011 | Renault R5 Cars & Trucks

3 Answers

Car had a burning smell before it lost a power. it will turn over but start. still ha o power(lights, radio,blower nothing)


check all the wires under the hood. There may be a burnt wire that powers all the things you mentioned

Nov 12, 2009 | 1998 Dodge Neon

2 Answers

MY CAR HAS A BURNING RUBBER SMELL AND THE STEERING IS GETTING A LITTLE HARDER. PLEASE HELP, I AM A WOMAN WITH NO MECHANIC EXPERIENCE AND I AM TRYING TO KNOW A LITTLE SOMETHING BEFORE I TAKE IT TO A...


The burning rubber smell may be a slipping belt; as the belt slips it will literally overheat to a point it has a burning smell (it will not burst in to flames though) The belt I would expect, given you issue, is that of the power steering pump. If the pump is beginning to sieze (not wanting to turn) the belt may begin to spin on the pump pulley. Curious if you have any noise of the belt slip, typically a high-pitched squeal? If the belt is slipping it should have a glazed or shinny look to it. In writting I come to think that just the belt itself may be old/worn, not to proper tension and causing the issue. In short if this is the issue it may be as simple of replacing the belt and put to proper tension or poosibly the power steering pump has begun to fail. The attached image may help

http://www.autorepairfacts.com/wp-content/uploads/2008/05/worn-belts.jpg
I hope this may have assisted you,
Tom

Oct 27, 2009 | Honda CR-V Cars & Trucks

1 Answer

I have no power to the the radio


You will have to chase your power wire back to the fuse panel and/or the battery itself. The burning smell was more then likely the main power cord burning up. Replace it and it should all work well.

Dec 16, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...