Question about Ford Edge

Open Question

Can I remove the head rest on the back seats of a Ford Edge limited 2013

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: removing a discovery 1 head rest the handle type

The headrest is hold by the two bars of the middle. The bars are engaged in two plastic guides fitted in the seat frame. The bars are locked by two little springs located in theses guides. They are very difficult to remove under the seat foam. The solution I used is a hammer (quite heavy) with a T bar from a sockets set . The diameter was exactly the same as the inner diameter of the plastic guide . Then I inserted this bar at the bottom end of the plastic guides and I hit the bottom of the mettalic bars with these tools and I managed. After the inspection, the springs were bended and I had to give the former shape they had before the removal.
Good luck ( sorry for my poor english but I'm french!)

Posted on Apr 19, 2009

  • 1 Answer

SOURCE: Need to remove head rest to put on seat covers

I looked into new headrest for my 2005 Grand Cherokee with the monitors installed in them. I had mine off but couldn't remember how i did it. But I got the instuctions from the the company with the new headrest and they linked me to a video online. The company was on ebay. I remember that it was really simple

Posted on May 04, 2009

97F350diesel
  • 1326 Answers

SOURCE: kia sedona front passenger seat stuck in forward position

Electric or manual??? If electric one of the motors has gone out. If the kids were playing with it they may have held the button down causing the motor to spin while the seat was all the way foward and it will just burn the motor up after so long. Also the switch could be bad. Unfortunatley being that its power there is no way to manually move the seat back without the motor turning or removing the seat and spinning the motor sprocket by hand...

Posted on Sep 10, 2009

  • 753 Answers

SOURCE: How to remove the head rest from the driver's seat 05 sunfire

There should be tiny holes in the plastic covers at the base of the chrome rods attached to the headrest use a paper clip and push it in the holes as you pull on the headrest in the full up postion.

Posted on Dec 23, 2009

ourhowse
  • 2007 Answers

SOURCE: 07 Expedition second row seat head rest cover plate removal

There should either be a little button at the base of the headrest that you push, or a small hole in the rod part, with a hole in it. Push in the hole with a pen, or a small nail to release the headrest.

Posted on Dec 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I remove the back seat and the back seat rest in my 1991 Chevy Caprice Classic? I want to have total access to my trunk, and I don't want to have to get out the saws-all.


using a tire iron push up under the backseat bottom prying toward the trunk there are two large clips one on each side, The seat back comes off by prying it towards the headliner (top) of the car.

Jul 11, 2011 | 1994 Chevrolet Caprice Classic

1 Answer

On a '97 jeep grand cherokee limited, do the back seats lay forward? If so, how do you put them down? Thank you.


On each side of the back seat (the part you sit on), there is a loop. Pull this up, and the seat cushion will swivel up towards the front seat back. Visible at the lower corner of the seat back, is a lever that tou can pull up ( the earlier versions needed to be pushed down or back). The seat back will then fold /down/forward. The headrest must be removed so that the seat back can fold flat. The headreat can be removed by turnibg the small knob at the base of one of the head rest shafts. There is a small arrow indicating the direction of rotation to accomplish this.

May 09, 2011 | 1997 Jeep Grand Cherokee

1 Answer

We need to remove the drives side head rest to install a seat cover, but we cannot figure out how to remove the head rest. How do you remove the driver's side head rest?


Head Restraints Removal
  1. Unscrew front seat head rest guide rod retainers (610A18) .
  1. Pull up on front seat back head restraint (611A08) . Compress foam in area of front seat head rest guide rod sleeves (610A16) .
  1. Remove front seat back head restraint positioning springs. Pull front seat back head restraint up and out.
Installation
  1. Slide front seat head rest guide rod retainers onto front seat back head restraint posts.
  1. Compress foam in front seat head rest guide rod sleeve area. Install positioning springs on front seat head rest guide rod sleeves .
  1. Insert front seat back head restraint posts (notches on posts facing rearward) into front seat head rest guide rod sleeves and push down to engage positioning spring.
  1. NOTE: Front seat back head restraint must operate smoothly throughout its range of travel, must remain in any fixed position, and must not be freely removable from the seat back. If any of these conditions are not met, check for proper installation of positioning spring onto front seat head rest guide rod sleeve .

    Tighten front seat head rest guide rod retainers onto front seat head rest guide rod sleeves .
  1. Adjust front seat back head restraint by applying hand pressure, either up or down, to center area of front seat back head restraint .

9a4d433.gif

Aug 21, 2010 | 1998 Ford Taurus

1 Answer

I NEED TO REMOVE THE FRONT SEAT HEADRESTS FROM A 2004 FORD MUSTANG CONVERTIBLE.


Lift the headrest to it highest postion. Insert a thin stick parallel to the head rest bar (the side facing the rear of the vechicle) I used a thin paint stirring stick, a Slim Jim is ideal.
Once the stick is inserted (10" give or take) push the head rest down holding the stick steady, then pull the headrest back up and it will come off the seat.
Hope this helps.

Apr 03, 2010 | 2004 Ford Mustang

1 Answer

07 Expedition second row seat head rest cover plate removal


There should either be a little button at the base of the headrest that you push, or a small hole in the rod part, with a hole in it. Push in the hole with a pen, or a small nail to release the headrest.

Dec 27, 2009 | 2007 Ford Expedition Eddie Bauer EL

1 Answer

Corolla rear seat removal


First lift up on the front edge of the seat bottom. There are two hooks that latch it in place. A solid tug on either side will release them.
They are located here:

54e51b5.gif
Next remove the head rests and unbolt the two 14mm nuts on the lower corners of the seat back. From there the seatback will lift straight up.
See illustration here:
90bdc78.gif
If this has been helpful please be sure to rate my answer and thanks for using Fixya!

Oct 04, 2009 | 2007 Toyota Corolla

1 Answer

How do you remove the headrest on a 1996 ford crown victoria?


Head Restraints Each front seat is equipped with dual-post design front seat back head restraint (611A08). The front seat back head restraint is installed as follows:
  • It travels on dual posts which have notches to engage a spring-loaded catch in the guide.
  • The front seat back spring assembly retains the front seat head rest guide rod sleeve (610A16).
  • The front seat back head restraint is adjustable from its normal position to a raised position of approximately 25 mm (1 inch).
  • Pull up on the front seat back head restraint to raise it. Pushing down will return it to its normal position.
----------------------------------------------------------------------------------------------

Removal
  1. Unscrew front seat head rest guide rod retainers (610A18).
  1. Pull up on front seat back head restraint (611A08). Compress foam in area of front seat head rest guide rod sleeves (610A16).
  1. Remove front seat back head restraint positioning springs. Pull front seat back head restraint up and out.
Installation
  1. Slide front seat head rest guide rod retainers onto front seat back head restraint posts.
  1. Compress foam in front seat head rest guide rod sleeve area. Install positioning springs on front seat head rest guide rod sleeves.
  1. Insert front seat back head restraint posts (notches on posts facing rearward) into front seat head rest guide rod sleeves and push down to engage positioning spring.
  1. Tighten front seat head rest guide rod retainers onto front seat head rest guide rod sleeves.
  1. NOTE: Front seat back head restraint must operate smoothly throughout its range of travel, must remain in any fixed position, and must not be freely removable from the seat back. If any of these conditions are not met, check for proper installation of positioning spring onto front seat head rest guide rod sleeve.

    Adjust front seat back head restraint by applying hand pressure, either up or down, to center area of front seat back head restraint.

Mar 01, 2009 | 1996 Ford Crown Victoria

1 Answer

Replacing boot struts


Hi GB52. Just done this myself, should take 15 minutes perside max. 1/ remove rear seat cushion by bumping the centre back and up, lower the back rests down. 2/ Unscrew the striker plate from the seat side bolster and the bolt at the lower edge of the bolster Removing the bolster takes a bit of fiddling. 3/ use a flat-head screwdriver to release the strut spring clips - use the new ones as a guide. 4/ remove the old strut and fit the new one. reinstall the bolster, bolt and strike plate. note; when replacing the rear seat cushion, ensure the seat belts are fed through first and check that the seat retaining clips properly engage the floor panel brackets.

Hope this helps,

Davo

Jul 31, 2008 | 1983 Ford Fairmont

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...