Question about Seat Cars & Trucks

Open Question

How to change cover of rear seat armrest - Seat Cars & Trucks

Posted by on

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: I have a 2004 Ford

If it's similar to those in past, you don't remove the stud, you have to push it back in at certain angle & rotate it, to lock it back in. Something tells me it's at about 2 o'clock, in push hard and turn down to rest position? I know I've had to play with some before getting it to go as it's supposed to. If worst comes to worst, stop at a body shop, it will take them about 2 minutes in most cases.

Posted on Jan 18, 2009

johnjohn2
  • 5763 Answers

SOURCE: remove armrest from a 1999 suburban bucket seat

theres a bolt at the bottom were it swivels up and dowm, it behind colth, some have a zipper to open and some you just have to pull cloth away to get to screw and some have a plug covering it, also you may have to remove seat unless you have enough room,to acces screw, good luck.

Posted on Nov 13, 2009

  • 152 Answers

SOURCE: how do you remove the armrest on the front seats?

The armrests have covers that can be removed. Locate the zipper on the arm rest. Once you unzip it pull it toward the back of the arm rest and this will expose the one bolt that hold the armrest on. You will need a large torx and rachet to get it off. Once you take out that bolt the armrest will come right off.

Posted on Apr 07, 2010

  • 5 Answers

SOURCE: i need too know to

you will have to remove the seat, completely dissasemble the seat frame from underneath, its alot of stuff to remove, all the lumbar switch cover on the drivers seat also, check also to make sure if you have heated seats that it isnt shorted out around the plug area

Posted on Dec 20, 2010

  • 5 Answers

SOURCE: how do i take off the armrests from the bucket seats

  • On most vehicles the arm rest are attached the same way, here is something you can try...Put the armrest in the upright position. Look along the bottom and sides of the armrest where it connects to the body of the seat. There should be small circles like tabs if the armrest is made of plastic, and there should be a seam that you can look through if the arms are made of cloth.
  • Pop out the tab or peel back the fabric to reveal the holding mechanism. If the chair is screwed in then you'll need a screwdriver, and if there's a nut or a bolt then you're going to need a socket wrench.
  • Hold the armrest up and make sure it doesn't move. Unscrew or unbolt the arm from the bucket seat. Pull the arm outwards once the hardware is removed.
  • Posted on Nov 13, 2012

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    Remove center armrest hhr


    Hi Konakalela, I'm Al the owner of Big As Auto Repair
    Most arm rest have a round trim cover on the side of the seat that's removable. Simple remove that cover and there is a bolt behind it that holds the arm rest remove it counter-clock-wise and pull the arm rest straight outward. For further assistance go to my website. Have an awesome day Konakalela.
    Auto Repair

    Dec 21, 2014 | Seat Cars & Trucks

    1 Answer

    How do you remove the armrest from the driver bucket seat from a 1994 chevrolet silverado, it does not have the clip from the backside like the newer chevrolets?


    It is possible that the role pin to remove the armrest is hidden inside the zipper cover. I do not know this particular vehicle, but GM did that to some of the vans. Some also have to require the removal of the actual seat and turn counterclockwise to "unwind" the armrest. Good Luck, hope this may help.

    May 19, 2014 | 1994 Chevrolet S-10 Blazer

    1 Answer

    How to remove the driver seat armrest?


    on the end of the armrest should have a cap or a zipper and inside is the screw to un do the arm

    Apr 27, 2014 | 2010 Kia Soul

    1 Answer

    Putting down armrest on rear seat honda stream 2006


    operators guide lost. need help finding one??

    Jan 20, 2014 | Honda Cars & Trucks

    1 Answer

    How do i take off the armrests from the bucket seats


  • On most vehicles the arm rest are attached the same way, here is something you can try...Put the armrest in the upright position. Look along the bottom and sides of the armrest where it connects to the body of the seat. There should be small circles like tabs if the armrest is made of plastic, and there should be a seam that you can look through if the arms are made of cloth.
  • Pop out the tab or peel back the fabric to reveal the holding mechanism. If the chair is screwed in then you'll need a screwdriver, and if there's a nut or a bolt then you're going to need a socket wrench.
  • Hold the armrest up and make sure it doesn't move. Unscrew or unbolt the arm from the bucket seat. Pull the arm outwards once the hardware is removed.
  • Nov 13, 2012 | 2007 Dodge Grand Caravan SXT Minivan

    1 Answer

    Repair 300e driver seat armrest


    Most often this is due to a loose armrest mounting bolt or worn limit washer, unzip the cover and tighten the arm rest first, it is most likely a T45 Torx female bolt head AKA star drive.

    Aug 28, 2012 | 1992 Mercedes-Benz Mercedes Benz 300 Class

    1 Answer

    Remove armrest


    I upload a VIDEO.Just be patient

    Mar 04, 2012 | 2004 Chrysler PT Cruiser

    1 Answer

    Need to remove center console to replace seat belt. After removing 12 screws, console is still firmly in place. What else has to be done?


    1. Remove the two oval covers from the sides of the floor console. Remove the four (two on each side) retaining bolts. Lift or remove the front seat center armrest from the floor console.
    2. Remove one screw from the top rear end of the floor console (directly under the front seat center armrest.
    3. Remove four screws retaining the utility tray beverage holder to floor console. Lift or remove the utility tray beverage holder from the console.
    4. Remove two screws (directly under the utility tray beverage holder) retaining the front end of the floor console to the console panel front mounting bracket.
    5. Lift the floor console from the front and rear console panel mounting brackets.

    Feb 27, 2011 | 1996 Ford Explorer

    1 Answer

    Center console disasembly instructions . we are trying to remove the center console


    Base Console, Floor, Ranger, Explorer Removal and Installation
    1. Remove the two oval covers from the sides of the floor console. Remove the four (two on each side) retaining bolts. Lift or remove the front seat center armrest (644A22) from the floor console.
    1. Remove one screw from the top rear end of the floor console (directly under the front seat center armrest.
    1. Remove four screws retaining the utility tray beverage holder to floor console. Lift or remove the utility tray beverage holder from the console.
    1. Remove two screws (directly under the utility tray beverage holder) retaining the front end of the floor console to the console panel front mounting bracket.
    1. Lift the floor console from the front and rear console panel mounting brackets.

    c758709.gif

    Apr 01, 2010 | 1996 Ford Explorer

    1 Answer

    How do you remove the armrest on the front seats?


    The armrests have covers that can be removed. Locate the zipper on the arm rest. Once you unzip it pull it toward the back of the arm rest and this will expose the one bolt that hold the armrest on. You will need a large torx and rachet to get it off. Once you take out that bolt the armrest will come right off.

    Feb 02, 2010 | 1995 Ford Bronco

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    17 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Seat Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Adam Truesdale

    Level 2 Expert

    265 Answers

    Are you a Seat Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...